7
To use the door handles to lock and unlock your
vehicle, make sure the Intelligent Key is with
you (that is, in your pocket or purse).
• Touch the inside of the door handle 1 to
unlock the corresponding front door.
• Pushing the request switch 2 while
touching the inside of the door handle will
unlock the rest of the doors.
• To lock the vehicle, push either door handle
request switch 3 once.
Locking and Unlocking your Vehicle
via the Door Handle
1
2
3
Illumination Controls
INSTRUMENT BRIGHTNESS CONTROLS
• Press the + or – buttons 1 to change the brightness of the
vehicle information display and instrument panel.
CENTER DISPLAYS BRIGHTNESS CONTROL
To adjust the brightness of the center displays:
• For models with Around View® Monitor, press and hold the
CAMERA
button 2. Then, use the Infiniti controller 3 to change the brightness.
• For models without Around View® Monitor, press the
button, and use the Infiniti controller 3 to change
the brightness.
1
2
To change the settings for the door locking and
unlocking system, press the MENU button
4, then touch
the “Settings” key on the lower display followed by the
“Vehicle” key.
• To unlock all doors by touching the inside of the door handle, select “\
Selective
Door Unlock”.
• To disable unlocking by touching the inside of the door handle feature, \
select
“Touch Sensitive Door Sensor”.
4
3
For more information, refer to your Owner
8
Wiper and Washer Switch
Move the lever 1 up or down to one of the following positions
to operate the windshield wipers:
MIST
One sweep operation
OFF Wipers are OFF
AUTO Speed-sensing and rain-sensing automatic wipe
LO Continuous wipe, slow
HI Continuous wipe, fast
To adjust the wiper sensitivity for the AUTO setting, twist the
control ring
2.
Pull the lever 1 toward you operate the windshield washer.
1
2
PULLING UP THE WIPER ARM
The wiper arm should be in the UP position when
replacing the wiper.
• With the shift lever in the P (PARK) position, place
the ignition switch in the OFF position.
• Within 1 minute, push the wiper switch 1 to the
MIST position twice. The wiper operation stops in
mid-operation and the wiper arm can be pulled up.
• To return the wiper arm, place the wiper arm in the DOWN position and op\
erate the
wiper switch once.
To turn the rain sensor function on or off:
1. Press the MENU button below the lower display.
2. Touch the “Settings” key and then the “Vehicle” key 3 on the display.
3. Touch the “Rain Sensor” key 4 to toggle the feature ON and OFF.
When the rain-sensing feature is disabled, the AUTO position on the wiper stalk will work
in conventional intermittent mode.
3
4
For more information, refer to your Owner
