2017 Hyundai Ioniq Hybrid stop start

Troubleshooting I 6-35
06
Troubleshooting
The current position as shown on the navigation may differ from
the actual position under the following conditions.
The following occurrences are not malfunctions:

•
When driving on Y-shaped roads
with narrow angles the current
position may be displayed in the
opposite direction

•
Within city streets, the current posi-
tion may be displayed on the oppo-
site side or on an off-road position

•
When changing the zoom level
from maximum to a different level,
the current position may become
displayed on a different road

•
If the vehicle is loaded onto a ferry
or a car transport vehicle, the cur-
rent position may become stalled
on the last position prior to loading

•
When driving on a spiral-shaped
road

•
When driving in mountain regions
with sharp turns or sudden brakes

•
When entering a road after passing
an underground parking structure,
building parking structure, or roads
with many rotations

•
When driving in heavy traffic with
frequent starts and stops
•
When driving under slippery condi-
tions, such as heavy sand, snow, etc.

•
When driving on spiral-shaped roads

•
When the tires have recently been
replaced (Especially upon use of
spare or studless tires).

•
When using tires of improper size

•
When the tire pressure for the 4 tires
are different

•
When the replacement tire is worn or
used (Especially studless tires having
passed a second season).

•
When driving near high-rise buildings

•
When a roof carrier has been installed

•
When a long distance route is calcu-
lated while driving on an expressway
In such cases, continued driving will
automatically enable the system
to conduct map matching or use
updated GPS information to provide
the current position (In such cases, up
to several minutes may be required)
Correct route guidance may not occur due to search conditions or
driving position.
The following occurrences are not malfunctions:

•
Guidance to go straight may be
given while driving on a straight
road

•
Guidance may not be given even
when having turned at an inter-
section

•
There are certain intersections in
which guidance may not occur

•
A route guidance signaling for
a u-turn may occur in some No
u-turn intersections
•
Route guidance signaling
entrance into a No-entry zone
may occur (No-entry zone, road
under construction, etc.)

•
Guidance may be given to a posi-
tion that is not the actual destina-
tion if roads to reach the actual
destination do not exist or are too
narrow

•
Faulty voice guidance may be
given if the vehicle breaks away
from the designated route. (e.g. if
a turn is made at an intersection
while the navigation provided
guidance to go straight.)
These situations may occur after conducting route calculation.
The following occurrences are not malfunctions:

•
Guidance may be given to a
position differing from the current
position when turning at an inter-
section

•
When driving in high speeds,
route recalculation may take a
longer period of time

•
Route guidance signaling for a
u-turn may occur in some No
u-turn intersections
•
Route guidance signaling entrance
into No-entry zone may occur
(No-entry zone, road under construc-
tion, etc.).

•
Guidance may be given to a position
removed from the actual destination
if roads to reach the actual destina-
tion do not exist or are too narrow

•
Faulty voice guidance may be given
if the vehicle breaks away from the
designated route (e.g. If a turn is
made at an intersection while the
navigation provided guidance to go
straight.)
)@"&
)&7
@(<64"@&6>"7/@1"35JOEE


 )@"&
)&7
@(<64"@&6>"7/@1"35JOEE


 

7-2 I Voice Recognition
What is Voice Recognition?
The voice recognition feature operates the
multimedia system by recognizing voice
commands and enables hands-free oper-
ation of the system while you are driving
your car.
Not all possible voice commands are
recognized by the system due to techno-
logical limitations. To make up for these
limitations, the system displays the voice
commands that are available for you to
use.
There are errors in communication between
people. Likewise, voice recognition some-
times misunderstands your voice command
in some circumstances. If this happens,
either check the screen for the available
options and say the command again, or
manually select and press the button for the
corresponding command on the screen.
Precautions Required
for Successful Voice
Recognition
1. Voice recognition supports only the
commands that are displayed on the
screen and written in the User's Guide.
2. To ensure the correct recognition and
execution of your command, say your
command when you hear the beep after
a voice prompt.
3. Voice recognition automatically ends if:
1) A call is incoming or outgoing
2) A media device (USB or iPod, etc.) is
connected or disconnected
3) The rear view camera is operated
4) The car engine starts or stops
5) A system key, such as
RADIO key
or
MEDIA key is selected
6) An emergency occurs, for example
re-searching for the route after the
navigation route has been lost 4.
The microphone used for the voice
recognition system is located in the
headliner directly above the driver's
head. To make your commands better
understood, keep your body straight
in the driver's seat when speaking the
command.
5. Speaking naturally and clearly will
ensure better recognition of your voice
commands.
6. In the following cases voice recognition
will be affected by ambient noise.
1) The sound of the wind if any window
or the sun roof is open.
2) High speed blower from the air vents.
Set climate control to blow lower
than level 3.
3) Vibrations from passing through a
tunnel.
4) Vibrations from driving on an uneven
road.
5) Storms and heavy rain.
Voice Recognition
)@"&
)&7
@(<64"@&6>"7/@1"35JOEE


 )@"&
)&7
@(<64"@&6>"7/@1"35JOEE


 

9-2 I Other Features
Camera
WARNING
- Backing Up & Using Camera
• Never rely solely on the rear view camera
when backing up. Prior to entering your
vehicle always do a visual check of the area
behind your vehicle, and before backing up
be aware of your surroundings and supple-
ment the rear view camera by looking over
your shoulders and checking your rear view
mirrors. Due to the difficulty of ensuring that
the area behind you remains clear, always
back up slowly and stop immediately if you
even suspect that a person, and especially
a child, might be behind you.
Information
The camera screen shown while the system
boots up does not display any text or buttons.
Steering-linked camera
•
This device is connected to a rear
detection camera to see behind the car
for safe reversing.
•
The Rear View Camera turns on auto-
matically if you shift the gear to R when
the power is on or the engine has
started.
•
While the device boots up, shift the gear
to "R" to activate the rear detection cam-
eras. Shift the gear to another position
to deactivate the rear detection camera.
NOTICE
A wide-angle lens is installed as the rear
detection camera to get a wider view, so
there may be some difference between
the actual distance and the distance that
appears. on-screen. For safety, make sure to
view the back, right, and left sides of the car
for yourself.
The color of the parking guidelines displayed
in the picture may differ from the actual
screen.
When booted up, blinking may occur when
you switch to a UI screen.
Name Description
Red LineAbout 0.5m from the
rear bumper
Yellow Line 1About 1m from the rear
bumper
Yellow Line 2About 3m from the rear
bumper
Yellow Line 3Trajectory of the wheel
on the driver’s side
Yellow Line 4Trajectory of the wheel
on the passenger side
Blue LineNeutral steering trajec-
tory
As you reverse your car and monitor the
area behind your car, the steering-linked
driving trajectory and the neutral driving
trajectory are both displayed.
Other Features
)@"&
)&7
@(<64"@&6>"7/@1"35JOEE


)@"&
)&7
@(<64"@&6>"7/@1"35JOEE





ß
1



ß
1


32
Precautions Required
for Successful Voice
Recognition
1. Voice recognition supports only
the commands that are displayed
on the screen and written in the
User’s Guide.
2. To ensure the correct recognition
and execution of your command,
say your command when you hear
the beep after a voice prompt.
3. Voice recognition automatically
ends if:
1) A call is incoming or outgoing
2) A media device (USB or iPod,
etc.) is connected or discon-
nected
3) The rear view camera is oper-
ated
4) The car engine starts or stops
5) A system key, such as
RADIO
key or
MEDIA key is selected
6) An emergency occurs, for
example re-searching for the
route after the navigation route
has been lost 4.
The microphone used for the
voice recognition system is
located in the headliner directly
above the driver’s head. To make
your commands better under-
stood, keep your body straight in
the driver’s seat when speaking
the command.
5. Speaking naturally and clearly will
ensure better recognition of your
voice commands.
6. In the following cases voice rec-
ognition will be affected by ambi-
ent noise.
1) The sound of the wind if any
window or the sun roof is open.
2) High speed blower from the
air vents. Set climate control to
blow lower than level 3.
3) Vibrations from passing
through a tunnel.
4) Vibrations from driving on an
uneven road.
5) Storms and heavy rain.
Voice Recognition
)@"&
)&7
@(<64"@&6>"7/@23(JOEE


 7
@(<64"@&6>"7/@23(JOEE


 


ß
1