2017 HYUNDAI I20 battery

8
"!!" " " !
#"#!#
OIB074056

Petrol Engine (Kappa 1.2 MPI)
The actual engine room in the vehicle may differ from the illustration.
1. Engine coolant
reservoir............9 31
2. Radiator
cap ..................\4............9 32
\f. Brake\bclutch
fluid reservoir ........9\f 5
4. Air
cleaner ..................\4..............9\f 9
5. Engine oil
dipstick................\4......92 8
6. Engine oil filler
cap ..................\4..92 8
7. Windshield washer fluid reservoir
..................\4..................\494 2
8. Engine room junction
block ......96 4
9. Battery
..................\4..................\4..94 5
* : if equipped


"!!" " " !

OIB074001
Diesel Engine (U II 1.4 TCI)The actual engine room in the vehicle may differ from the illustration.
1. Engine coolant
reservoir............9 31
2. Radiator
cap ..................\4............9\f 2
\f. Brake\bclutch
fluid reservoir ......9\f 5
4. Air
cleaner ..................\4..............9\f 9
5. Engine oil
dipstick................\4......92 9
6. Engine oil filler
cap ..................\4..9 30
7. Windshield washer fluid reservoir
..................\4..................\494 2
8. Engine room junction
block ......96 4
9. Battery
..................\4..................\4..94 5

1
"&t%'s%st&'!"'%!'&&

$#%$!%

•For maximum restraint system
protection, the seat belts must
always be used whenever the
car is moving.
•Seat belts are most effective
when seatbacks are in the
upright position.
•Children age 12 and under must
always be properly restrained in
the rear seat. Never allow chil
dren to ride in the front passen
ger seat. If a child over 12 must
be seated in the front seat,
he\fshe must be properly belted
and the seat should be moved
a

s far back as possible.
(Continued)
WARNING (Continued)
•Never wear the shoulder belt
under your arm or behind your
back. An improperly positioned
shoulder belt can cause serious
injuries in a crash. The shoulder
belt should be positioned mid
way over your shoulder across
your collarbone.
•Never wear a seat belt over
fragile objects. If there is a sud
den stop or impact, the seat belt
can damage it.
•Avoid wearing twisted seat
belts. A twisted belt can't do its
job as

well. In a collision, it could
even cut into you. Be sure the
belt webbing is straight and not
twisted.
•Be careful not to damage the
belt webbing or hardware. If the
belt webbing or hardware is
damaged, replace it.
Seat belts are designed to bear
upon the bony structure of the
body, and should be worn low
across the front of the pelvis or the
pelvis, chest and shoulders, as
applicable; wearing the lap section
of the belt across the abdominal
area must be avoided.
Seat belts should be adjusted as
firmly as possible, consistent with
comfort, to provide the protection for
which they have been designed.
A slack belt will greatly reduce the
protection afforded to the wearer.
Care sh

ould be taken to avoid con
tamination of the webbing with pol
ishes, oils and chemicals, and par
ticularly battery acid. Cleaning may
safely be carried out using mild
soap and water. The belt should be
replaced if webbing becomes
frayed, contaminated or damaged.
(Continued)
WARNING

8
"&t%'s%st&'!"'%!'&&
Driver's and passenger's front air
bag (if equipped)
Your vehicle is equipped with a
Supplemental Restraint (Air Bag)
System and lap\fshoulder belts at
both the driver and passenger seat
ing positions. The indications of the system's pres
ence are the letters "AIR BAG"
engraved on the air bag pad cover in
the steering wheel and the passen
ger's side front panel pad above the
glove box.
The SRS consists of air bags
installed under the pad covers in the
center of the steering wheel and the
passenger's side front panel above
the glove box.
The purpose of the SRS is to provide
the vehicle's driver and\for the front
passenger with additional protection
than that offered by the seat belt sys
tem alone in case of a frontal impact
of sufficient severity.
(Continued)
•The SRS can function only
when the ignition switch is in the
ON position.
•Before you replace a fuse or dis
connect a battery terminal, turn
the ignition switch to the LOCK
position and remove the ignition
key. Never remove or replace
the air bag related fuse(s) when
the ignition switch is in the ON
position. Failure to heed this
warning will cause the SRS air
bag warning light to illuminate.
OIB034019
OIB034020

Driver’s front air bag
Passenger’s front air bag

)')
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
Type CTo unfold the key, press the release
button then the key will unfold auto-
matically.
To fold the key, fold the key manually
while pressing the release button.DD o not fold the key without pressing
the release button. This may dam-
age the key.
Remote key precautionsThe remote key will not work if any of
the following occur:
• The key is in the ignition switch.
• You exceed the operating distance limit (about 30 m [90 feet]).
• The remote key battery is weak.
• Other vehicles or objects may be blocking the signal.
• The weather is extremely cold.
• The remote key is close to a radio transmitter such as a radio station
or an airport which can interfere
with normal operation of the
remote key.
When the remote key does not work
correctly, open and close the door
with the mechanical key. If you have
a problem with the remote key, it is
recommended that you contact an
authorized HYUNDAI dealer. (Continue)(Continue)
If the remote key is in close proximi-
ty to your mobile phone, the signal
could be blocked by your mobile
phones normal operational signals.
This is especially important when the
phone is active such as making and
receiving calls, text messaging,
and/or sending/receiving emails.
Avoid placing the remote key and
your mobile phone in the same pants
or jacket pocket and always try to
maintain an adequate distance
between the two devices.
NOTICE

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IInformation
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment. If
the keyless entry system is inoperative
due to changes or modifications not
expressly approved by the party
responsible for compliance, it will not
be covered by your manufacturer’s
vehicle warranty.Keep the remote key away from
electromagnetic materials that
blocks electromagnetic waves to the
key surface.
Battery replacement If the remote key is not working prop-
erly, try replacing the battery with a
new one.
Battery Type: CR2032
To replace the battery:
1. Insert a slim tool into the slot and
gently pry open the cover.
2. Remove the old battery and insert the new battery. Make sure the
battery position is correct.
3. Reinstall the rear cover of the remote key. If you suspect your remote key might
have sustained some damage, or
you feel your remote key is not work-
ing correctly, it is recommended that
you contact an authorized HYUNDAI
dealer.
Information
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose the battery
according to your local law(s)
and regulation.
i
NOTICEi
OIB044180

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
TTailgate unlocking To unlock:
1. Carry the smart key.
2. Either press the tailgate handle
button or press the Tailgate Unlock
button (3) on the smart key for
more than one second.
3. The hazard warning lights will blink two times.
Once the tailgate is opened and then
closed, the tailgate will lock automat-
ically.
Information
After unlocking the tailgate, the tail-
gate will lock automatically after 30
seconds unless the tailgate is opened.
Start-upYou can start the engine without
inserting the key. For detailed infor-
mation refer to the Engine Start/Stop
button in chapter 5.To prevent damaging the smart key:
• Keep the smart key away from water or any liquid and fire. If the
inside of the smart key gets damp
(due to drinks or moisture), or is
heated, internal circuit may mal-
function, excluding the car from the
warranty.
• Avoid dropping or throwing the smart key.
• Protect the smart key from extreme temperatures.
Always have the smart key with you
when leaving the vehicle. If the smart
key is left near the vehicle, the vehi-
cle battery may be discharged.
Mechanical key If the Smart Key does not operate
normally, you can lock or unlock the
door by using the mechanical key.
Press and hold the release button (1)
and remove the mechanical key (2).
Insert the mechanical key into the
key hole on the door.
To reinstall the mechanical key, put
the key into the hole and push it until
a click sound is heard.
NOTICENOTICE
i
OIB044175

)'
#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
IInformation
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment. If
the keyless entry system is inoperative
due to changes or modifications not
expressly approved by the party
responsible for compliance, it will not
be covered by your manufacturer’s
vehicle warranty.Keep the smart key away from elec-
tromagnetic materials that blocks
electromagnetic waves to the key
surface.
Battery replacement If the Smart Key is not working prop-
erly, try replacing the battery with a
new one.
Battery Type: CR2032
To replace the battery:
1. Pry open the rear cover of the
smart key.
2. Remove the old battery and insert the new battery. Make sure the
battery position is correct.
3. Reinstall the rear cover of the smart key. If you suspect your smart key might
have sustained some damage, or
you feel your smart key is not work-
ing correctly, it is recommended that
you contact an authorized HYUNDAI
dealer.
Information
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose the battery
according to your local law(s)
and regulation.
i
NOTICEi
OLF044008