2017 HYUNDAI ELANTRA SE maintenance schedule

7-25
7
Maintenance
Vacuum crankcase ventilation
hoses (if equipped)
Inspect the surface of hoses for evi-
dence of heat and/or mechanical
damage. Hard and brittle rubber,
cracking, tears, cuts, abrasions, and
excessive swelling indicate deterio-
ration. Particular attention should be
paid to examine those hose surfaces
nearest to high heat sources, such
as the exhaust manifold.
Inspect the hose routing to assure
that the hoses do not come in con-
tact with any heat source, sharp
edges or moving component which
might cause heat damage or
mechanical wear. Inspect all hose
connections, such as clamps and
couplings, to make sure they are
secure, and that no leaks are pres-
ent. Hoses should be replaced
immediately if there is any evidence
of deterioration or damage.
Air Cleaner Filter
A genuine HYUNDAI air cleaner filter
is recommended when the filter is
replaced.
Spark Plugs
Make sure to install new spark plugs
of the correct heat range.
Cooling System
Check cooling system components,
such as radiator, coolant reservoir,
hoses and connections for leakage
and damage. Replace any damaged
parts.
Engine Coolant
The coolant should be changed at
the intervals specified in the mainte-
nance schedule.

7-26
Maintenance
Automatic Transmission Fluid
(if equipped)
Automatic transmission fluid should
not be checked under normal usage
conditions. But in severe conditions,
the fluid should be changed at an
authorized HYUNDAI dealer in
accordance to the scheduled mainte-
nance at the beginning of this chap-
ter.
Automatic transmission fluid
color is basically red.
As the vehicle is driven, the auto-
matic transmission fluid will begin
to look darker. This is a normal
condition and you should not
judge the need to replace the fluid
based upon the changed color.
Manual transmission fluid
(if equipped)
Inspect the manual transmission
fluid according to the maintenance
schedule.
Brake Hoses and Lines
Visually check for proper installation,
chafing, cracks, deterioration and
any leakage. Replace any deteriorat-
ed or damaged parts immediately.
Brake/Clutch Fluid
Check brake/clutch fluid level in the
brake/clutch fluid reservoir. The level
should be between the MIN and the
MAX marks on the side of the reser-
voir. Use only hydraulic brake/clutch
fluid conforming to DOT 3 or DOT 4
specification.
NOTICE
The use of a non-specified fluid
could result in transmission
malfunction and failure. Use
only the specified automatic
transmission fluid (refer to
"Recommended Lubricants and
Capacities" in chapter 8).
CAUTION

7-29
7
MaintenanceUse only the specified engine oil
(refer to "Recommended Lubricants
and Capacities" in chapter 8).
Checking the Engine Oil and
Filter
Have engine oil and filter changed by
an authorized HYUNDAI dealer
according to the Maintenance
Schedule at the beginning of this
chapter.
NOTICE
CALIFORNIA PROPOSITION 65
WARNING
Engine oil contains chemicals
known to the State of California
to cause cancer, birth defects
and reproductive harm. Used
engine oil may cause irritation
or cancer of the skin if left in
contact with the skin for pro-
longed periods of time. Always
protect your skin by washing
your hands thoroughly with
soap and warm water as soon
as possible after handling used
oil.
WARNING
OAD075063L

7-32
Maintenance
The electric motor for the cooling fan
is controlled by engine coolant tem-
perature, refrigerant pressure and
vehicle speed. As the engine coolant
temperature decreases, the electric
motor will automatically shut off. This
is a normal condition. If your vehicle
is equipped with GDI, the electric
motor for the cooling fan may begin
to operate at any time and continue
to operate until you disconnect the
negative battery cable.
Changing Engine Coolant
Have coolant changed by an author-
ized HYUNDAI dealer according to
the Maintenance Schedule at the
beginning of this chapter. To prevent damage to engine
parts, put a thick towel around the
radiator cap before refilling the
coolant to prevent the coolant
from overflowing into engine
parts, such as the generator.
NOTICE
Do not use engine coolant or
antifreeze in the washer fluid
reservoir.
Engine coolant can severely
obscure visibility when sprayed
on the windshield and may
cause loss of vehicle control
resulting in an accident.
Engine coolant may also cause
damage to paint and body trim.
WARNING
The electric motor for
the cooling fan may
continue to operate
or start up when the
engine is not running
and can cause serious injury.
Keep hands, clothing and tools
away from the rotating fan
blades of the cooling fan.
WARNING

7-37
7
Maintenance
C
CL
LI
IM
M A
AT
TE
E
C
C O
O N
NT
TR
R O
O L
L
A
A I
IR
R
F
F I
IL
L T
T E
ER
R
Filter Inspection
The climate control air filter should
be replaced according to the
Maintenance Schedule. If the vehicle
is operated in severely air-polluted
cities or on dusty rough roads for a
long period, it should be inspected
more frequently and replaced earlier.
When you replace the climate control
air filter, replace it performing the fol-
lowing procedure, and be careful to
avoid damaging other components.
1. With the glove box open, removethe stoppers on both sides to allow
the glove box to hang freely on the
hinges. 2. Remove the support rod (1).
OAD075017OAD075018

7-96
Maintenance
E
EM
M I
IS
S S
SI
IO
O N
N
C
C O
O N
NT
TR
R O
O L
L
S
S Y
Y S
ST
T E
EM
M
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Owner’s
Handbook & Warranty Information
booklet in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
applicable emission regulations.
There are three emission control
systems, as follows.
(1) Crankcase emission control sys-
tem
(2) Evaporative emission control sys- tem
(3) Exhaust emission control system
In order to assure the proper function
of the emission control systems, it is
recommended that you have your
vehicle inspected and maintained by
an authorized HYUNDAI dealer in
accordance with the maintenance
schedule in this manual.1. Crankcase Emission Control System
The positive crankcase ventilation
system is employed to prevent air
pollution caused by blow-by gases
being emitted from the crankcase.
This system supplies fresh filtered air
to the crankcase through the air
intake hose. Inside the crankcase,
the fresh air mixes with blow-by
gases, which then pass through the
PCV valve into the induction system.
2. Evaporative Emission ControlSystem Including Onboard
Refueling Vapor Recovery
(ORVR)
The Evaporative Emission Control
System is designed to prevent fuel
vapors from escaping into the atmos-
phere. The ORVR system is
designed to allow the vapors from
the fuel tank to be loaded into a can-
ister while refueling at the gas sta-
tion, preventing the escape of fuel
vapors into the atmosphere.
For the Inspection and
Maintenance Test (With
Electronic Stability Control
(ESC) system)
To prevent the vehicle from
misfiring during dynamome-
ter testing, turn the Electronic
Stability Control (ESC) sys-
tem off by pressing the ESC
switch (ESC OFF light illumi-
nated).
After dynamometer testing is
completed, turn the ESC sys-
tem back on by pressing the
ESC switch again.
CAUTION

I-6
Exhaust emission control system....................................7-97
Explanation of scheduled maintenance items.................7-24
Exterior care....................................................................7-89\
Exterior lights ...............................................................3-107
Exterior overviewFront ........................................................................\
.....2-2
Rear ........................................................................\
......2-3
Flat tire Jack and tools .............................................................6-15
Jack label ....................................................................6-22\
Tire Mobility Kit ........................................................6-22
Use of compact spare tires .........................................6-20
Floor mat anchor(s).......................................................3-157
Fluid Brake/clutch fluid .......................................................7-33
Washer fluid ...............................................................7-34
Front lamps ...................................................................3-115
Front seats ........................................................................\
.2-6
Fuel filler door ................................................................3-58
Fuel gauge .......................................................................3\
-65
Fuel requirements .............................................................F-7
Fuse/relay panel description Instrument panel fuse panel .......................................7-66
Engine compartment fuse panel .................................7-69 Fuses ........................................................................\
.......7-60
Blade type fuse ...........................................................7-65
Cartridge type fuse .....................................................7-65
Engine compartment panel fuse replacement ............7-63
Fuse switch .................................................................7-62
Fuse/relay panel description .......................................7-66
Instrument panel fuse replacement.............................7-61
Main fuse ....................................................................7-64\
Multi fuse ...................................................................7-64
Gauges........................................................................\
.....3-63
Glove box......................................................................3-\
151
Hazard warning flasher .....................................................6-2
Hazardous driving conditions .........................................5-92
Head restraints ................................................................2-15
Headlamp delay function ..............................................3-113
Headlamp position ........................................................3-109
Headlight bulb replacement ............................................7-72
Heater Automatic climate control system............................3-133
Manual climate control system ................................3-123
Height adjustment ...........................................................2-25
High beam operation.....................................................3-109
Highway driving .............................................................5-95
Index
F
G
H

I-8
Jack and tools..................................................................6-15
Jump starting .....................................................................6-4\
LabelRegrigerent label ........................................................8-11
Tire loading information label..................................5-101
Tire sidewall labeling .................................................7-50
Tire specification and pressure label ..........................8-11
Vehicle certification label ...........................................8-11
Lane keeping assist system (LKAS)...............................5-61
LCD display (for supervision cluster) LCD display control ...................................................3-88
LCD modes ................................................................3-89
User settings mode .....................................................3-93
LCD display control .......................................................3-88
LCD modes .....................................................................3-8\
9
Light ........................................................................\
......3-107 AFLS (Adaptive Front Lighting System) ................3-114
Auto light position....................................................3-108
Battery saver function ..............................................3-113
Daytime running light (DRL) ..................................3-108
Exterior lights ...........................................................3-107
Front lamps ...............................................................3-115
Headlamp delay function..........................................3-113 Headlamp position....................................................3-109
High beam operation ................................................3-109
Lighting control ........................................................3-107
Map lamp..................................................................3-108
One-touch lane change function...............................3-113
Parking lamp position ..............................................3-109
Rear lamp...............................................................\
...3-116
Room lamp ...............................................................3-115
Smart high beam.......................................................3-110
Trunk room lamp ......................................................3-116
Turn signals ..............................................................3-112
Vanity mirror lamp ...................................................3-117
Welcome system .......................................................3-117
Light bulbs ......................................................................7-\
72
Lubricants and capacities..................................................8-7
Luggage net (holder).....................................................3-158
Main fuse ........................................................................\
7-64
Maintenance Explanation of scheduled maintenance items ............7-24
Maintenance services ...................................................7-4
Maintenance under severe usage conditions ..............7-22
Normal maintenance service ........................................7-8
Owner maintenance ......................................................7-7
Scheduled maintenance services ..................................7-7
Tire maintenance ........................................................7-50
Index
J
L
M