Page 87 of 643

85
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
System Message 
Indicator*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on along with a beep 
when a problem is detected. A 
system message on the driver 
information interface appears at 
the same time.
●While the indicator is on, press the   
(display/information) button to see the 
message again.
●Refer to the Indicators information in this 
chapter when a system message appears 
on the driver information interface. Take 
the appropriate action for the message.
●The driver information interface does not 
return to the normal screen unless the 
warning is canceled, or the   button 
is pressed.
—
Turn Signal and 
Hazard Warning 
Indicators
●Blink when you operate the turn 
signal lever.
●Blink along with all turn signals 
when you press the hazard 
warning button.
●Does not blink or blinks rapidly  - A 
turn signal light bulb has blown. Change 
the bulb immediately.
2 Replacing Light Bulbs  P. 540, 543 
—
High Beam 
Indicator●Comes on when the high beam 
headlights are on.——
Lights On 
Indicator
●Comes on whenever the light 
switch is on, or in AUTO* when 
the exterior lights are on.
●If you remove the key from the ignition 
switch*1 while the exterior lights are on, a 
chime sounds when the driver’s door is 
opened.—
Fog Light 
Indicator*
●Comes on when the fog lights are 
on.——
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  85 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 88 of 643
86
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
*2:Canadian models only: Apply and hold the brake pedal before turning the ignition on.
IndicatorNameOn/BlinkingExplanationMessage*2
Immobilizer 
System Indicator
●Blinks if the immobilizer system 
cannot recognize the key 
information.●Blinks - You cannot start the engine. Turn 
the ignition switch to LOCK 
(0*1, pull the 
key out*2, and then insert the key and turn 
it to ON 
(w*1 again.
Indicator
Canadian models 
without smart 
entry system
Canadian models 
with smart entry 
system
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  86 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 90 of 643
88
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
ECON Mode 
Indicator*
●Comes on when you press the 
ECON button.2ECON Button* P. 440
CRUISE MAIN  
Indicator*
●Comes on when you press the 
CRUISE  button.
2Cruise Control *  P. 441—
CRUISE 
CONTROL 
Indicator
*
●Comes on if you have set a speed 
for cruise control.
2 Cruise Control *  P. 441—
Washer Level 
Indicator*
●Comes on when the washer fluid 
gets low.●Refill the washer fluid.
2Refilling Window Washer Fluid  
P. 535—
Maintenance 
Minder 
Indicator
*
●Comes on for a few seconds 
when you turn the  ignition switch 
to ON 
(w*1, then goes off.●Comes on when the scheduled 
maintenance is due soon.
2 Maintenance MinderTM P. 511—
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  88 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 91 of 643

89
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Brake 
Depressing 
Indicator
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
●Blinks when the electric parking 
brake switch is pressed without 
depressing the brake pedal while 
the electric parking brake is in 
operation.
●Blinks while driving  - Press the electric 
parking brake switch with the brake pedal 
depressed.
2 Parking Brake  P. 482
—
●Blinks when the automatic brake 
hold button is pressed without 
depressing the brake pedal while 
the automatic brake hold is in 
operation.
●Blinks if the automatic brake hold 
is automatically canceled while it 
is in operation. The beeper 
sounds.
●Blinks while driving  - Press the 
automatic brake hold button with the 
brake pedal depressed.
2 Automatic Brake Hold  P. 485
●Immediately depress the brake pedal.
—
Continuously 
variable 
transmission 
models
Manual 
transmission 
models
Electric Parking Brake System
Automatic Brake Hold System
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  89 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 92 of 643

90
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Road Departure 
Mitigation (RDM) 
Indicator
*
●Comes on for a few seconds 
when you turn the ignition switch 
to ON 
(w*1, then goes off.●Comes on if there is a problem 
with the RDM system.
●Stays on constantly - Have your vehicle 
checked by a dealer.
●Comes on when the RDM system 
shuts itself off.●Stays on  - The temperature inside the 
camera is too high.
Use the climate control system to cool 
down the camera.
The system acti vates when the 
temperature inside the camera cools 
down.
2 Front Sensor Camera* P. 444
●Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your 
vehicle in a safe place, and wipe it off with 
a soft cloth.
●Have your vehicle checked by a dealer if 
the indicator and message come back on 
after you cleaned the area around the 
camera.
2 Front Sensor Camera* P. 444
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  90 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 93 of 643

91
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Adaptive Cruise 
Control (ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Amber)
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on if there is a problem 
with ACC with LSF.
●Comes on while driving  - Have your 
vehicle checked by a dealer.
●Comes on if anything covers the 
radar sensor cover and prevents 
the sensor from detecting a 
vehicle in front.
●May come on when driving in bad 
weather (rain, snow, fog, etc.)
●ACC with LSF has been 
automatically canceled.
●When the radar sensor gets dirty, stop 
your vehicle in a safe place, and wipe off 
dirt using a soft cloth.
●Have your vehicle checked by a dealer if 
the indicator does not go off even after 
you clean the sensor cover.
Adaptive Cruise 
Control ( ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Green)
*
●Comes on when you press the 
MAIN  button.2Adaptive Cruise Control (ACC) with 
Low Speed Follow (LSF)* P. 446—
●Comes on when ACC with LSF is 
in operation, but the temperature 
inside the front sensor camera is 
too high. ACC with LSF cancels 
automatically. The beeper sounds 
simultaneously.●Use the climate contro l system to cool 
down the camera.
●Goes off  - The camera has been cooled 
down. Pressing the  MAIN button can 
resume the system.
2 Front Sensor Camera* P. 444
2 Adaptive Cruise Control (ACC) with 
Low Speed Follow (LSF)
* P. 446
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  91 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 94 of 643

92
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Lane Keeping 
Assist System 
(LKAS ) Indicator 
(Amber)
*
●Comes on for a few seconds 
when you turn the ignition switch 
to ON 
(w*1, then goes off.●Comes on if there is a problem 
with the LKAS.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
Lane Keeping 
Assist System 
( LKAS ) Indicator 
(Green)
*
●Comes on when you press the 
MAIN  button.2Lane Keeping Assist System (LKAS)* 
P. 464—
●Comes on when the LKAS is in 
operation, or the LKAS button is 
pressed, but the temperature 
inside the front sensor camera is 
too high. The LKAS cancels 
automatically. The beeper sounds 
simultaneously.●Use the climate contro l system to cool 
down the camera.
●Goes off  - The camera has cooled down 
and the system is working normally.
2 Front Sensor Camera* P. 444
●Comes on when the area around 
the camera is blocked by dirt, 
mud, etc. Stop your vehicle in a 
safe place, and wipe it off with a 
soft cloth.
●May come on when driving in bad 
weather (rain, snow, fog, etc.)
●Have your vehicle checked by a dealer if 
the indicator and message come back on 
after you cleaned the area around the 
camera.
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  92 ページ  2018年10月25日 木曜日 午前11時56分 
         
        
        
     
        
        Page 95 of 643

93
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Collision 
Mitigation 
Braking 
System
TM 
(CMBSTM) 
Indicator*
●Comes on for a few seconds when 
you turn the igniti on switch to ON 
(w*1, then goes off.●Comes on when you deactivate 
the CMBSTM. A driver information 
interface message appears for five 
seconds.
●Comes on if there is a problem 
with the CMBSTM.
●Stays on constantly without the 
CMBSTM off  - Have your vehicle checked 
by a dealer.
2 Collision Mitigation Braking 
SystemTM (CMBSTM)* P. 490
●Comes on if the CMBSTM is 
deactivated temporarily after the 
battery has been disconnected, 
then re-connected.●Drive a short distance at more than 12 
mph (20 km/h). The i ndicator should go 
off. If it does not, have your vehicle 
checked by a dealer.
* Not available on all models
17 CIVIC 4D HCM (KA KC KL)-31TBA6111.book  93 ページ  2018年10月25日 木曜日 午前11時56分