2017 FIAT FULLBACK width

the Multi Communication System
(MCS), the Smartphone Link Display
Audio or the DISPLAY AUDIO. When
you move the gearshift lever or the
selector lever to any other position, the
screen will return to its original
indication.
159)
NOTE Because the rear view camera
has a special lens, the lines on the
ground between parking spaces may
not look parallel on the screen.
NOTE In the following situations, the
screen indication may be difficult to see.
There is no abnormality.
Low light (night time)
When the light of the sun or the light
from a vehicle’s headlamps shines
directly into the lens
If a fluorescent light shines directly
into the lens, the screen indication may
be flicker. There is no abnormality.
NOTE If the camera is hot and is then
cooled by rain or a car wash, the lens
can mist up. This phenomenon does
not indicate a malfunction.
NOTE If the atmospheric temperature
is extremely hot or extremely cold, the
rear view camera images may not be
clear. There is no abnormality.
NOTE If a radio set is installed near the
camera, the rear view camera images
may cause electrical system
interference and the system may stop
functioning properly.NOTE It is not possible to fully see
obstacles when the lens is dirty. If the
lens becomes contaminated by water
droplets, snow, mud, or oil, wipe off the
contamination, taking care not to
scratch the lens.
NOTE Please observe the following
cautions. Ignoring them could lead to a
camera malfunction.
Do not subject the camera to
physical shock such as striking it
strongly or throwing a thing.
Do not adhere organic substances,
waxes, oil remover, and glass cleaner to
the camera. If adhered to them,
immediately wipe off.
Do not splash the camera with
boiling water.
Never spray or splash water on the
camera or around it.
Do not disconnect, disassemble or
modify the camera.
Do not scratch the camera, as this
may cause damage to the rear view
camera images.
Reference lines on the screen
Reference lines and upper surface of
the rear bumper (A) are displayed on
the screen.
Red line (B) indicates approximately
50 cm behind the rear bumper.
Two Green lines (C) indicate
approximately 20 cm outside of the
vehicle body
Short transverse lines (1 to 3)
indicate distance from the rear bumper.
1. Approximately at the rear edge of
the rear bumper 2. Approximately
100 cm 3. Approximately 200 cm
160)
Errors between the display and the
actual road surface
The reference lines for distance and
vehicle width are based on a level, flat
road surface. In the following cases,
errors are produced between the
display reference lines and the distance
on the actual road surface.
When the rear of the vehicle is
weighed down with the weight of
passengers and luggage in the
vehicle
The reference lines are displayed closer
than the actual distance. Therefore
when there is an obstacle on the
upward slope, it appears farther than its
345AG0027115
200
STARTING AND DRIVING
actual position.

A. Actual objects
B. Objects shown on the screen
When there is an upward slope
behind the vehicle
The reference lines are displayed closer
than the actual distance. Therefore
when there is an obstacle on the
upward slope, it appears farther than its
actual position.
A. Actual objects
B. Objects shown on the screenWhen there is a downward slope
behind the vehicle
The reference lines are displayed farther
than the actual distance.
Therefore when there is an obstacle on
the downward slope, it appears closer
than its actual position.
A. Actual objects
B. Objects shown on the screen
When solid objects are located
close to the vehicle
When solid objects are located close to
the vehicle, the displayed distance on
the screen may differ from the actual
distance.When approaching solid objects
The reference lines for distance and
vehicle width are intended to indicate
the distance to a flat object such as a
level, flat road surface. This may make
the distance to a projecting object
shown on the screen differ from the
actual distance to the projecting object.
Do not use them as a guide to
distances to solid objects.
346AHA104720
347AHA103736
348AHA103749
349AHE100241
201

Reference Length
1 Front track 1,520 mm
2 Overall width
1,785 mm, 1,815 mm
(*1)
3 Front overhang 865 mm
4 Wheel base 3,000 mm
5 Rear overhangWithout rear bumper 1,330 mm
With rear bumper 1,410 mm
6 Overall lengthWithout rear bumper 5,195 mm
With rear bumper 5,275 mm
7 Ground clearance (unladen)
200 mm, 205 mm
(*1)
8 Overall height (unladen)
1,775 mm, 1,780 mm(*1)
9 Rear track 1,515 mm
10 Cargo bed length 1,850 mm
11 Cargo bed width 1,470 mm
12 Cargo bed height
845 mm, 850 mm
(*1)
(*1) Vehicles with wide fender
The vehicle overall length and height may vary depending on the equipment installed.
Minimum turning radius
Body 6.3 m
Wheel 5.9 m
277

Reference Length
1 Front track 1,520 mm
2 Overall width
1,785 mm, 1,815 mm
(*)
3 Front overhang 865 mm
4 Wheel base 3,000 mm
5 Rear overhangWithout rear bumper 1,340 mm
With rear bumper 1,420 mm
6 Overall lengthWithout rear bumper 5,205 mm
With rear bumper 5,285 mm
7 Ground clearance (unladen)
200 mm, 205 mm
(*)
8 Overall height (unladen)
1,775 mm, 1,780 mm(*)
9 Rear track 1,515 mm
10 Cargo bed length 1,520 mm
11 Cargo bed width 1,470 mm
12 Cargo bed height
845 mm, 850 mm
(*)
(*) Vehicles with wide fender
Minimum turning radius
Body 6.3 m
Wheel 5.9 m
279

Reference Length
1 Front track1,520 mm
2 Overall width1,785 mm
3 Front overhang865 mm
4 Wheel base3,000 mm
5 Rear overhangWithout rear bumper 1,215 mm
With rear bumper 1,295 mm
6 Overall lengthWithout rear bumper 5,080 mm
With rear bumper 5,160 mm
7 Ground clearance (unladen)200 mm
8 Overall height (unladen)1,780 mm
9 Rear track1,515 mm
10 Cargo bed length2,265 mm
11 Cargo bed width1,470 mm
12 Cargo bed height845 mm
Minimum turning radiusBody 6,3 m
Wheel 5,9 m
281