equivalent in miles), place the car in a
safe and suitable area, engaging the
electric parking brake. Pick up the kit,
ensure the "ON-OFF" button is in0(off)
position, insert the electrical connector
in the 12V socket of the car. Remove
the valve cap of repaired tyre,
disconnect and pull out the black
inflation tube, connect it to the valve
and lock it with the lever. Check the tyre
pressure shown on the pressure gauge;
if the pressure is lower than 1.8 bar /
26 psi, the TYRE IS TOO DAMAGED
AND CANNOT BE REPAIRED. Remove
and place the kit in the specific
compartment and contact a Fiat
Dealership;
if the pressure is equal to or higher
than 1.8 bar / 26 psi, switch on the
compressor and reach the required
pressure. Disconnect and replace the
kit in the specific compartment. Drive
carefully drive to a Fiat Dealership as
soon as possible.
WARNING
153)Punctures on the sides of the tire may
not be repaired. Do not use the Fix&Go
automatic kit if the tyre was damaged as a
result of being used when underinflated.
154)Wear the protective gloves provided
with the Fix&Go automatic kit.155)Apply the adhesive label where it can
be easily seen by the driver as a reminder
that the tyre has been treated with the
Fix&Go automatic kit. Drive carefully,
particularly on bends. Do not exceed
80 km/h. Avoid sudden acceleration or
braking.
156)If the pressure has fallen below
1.8 bar, do not drive any further: the
Fix&Go automatic kit cannot guarantee
proper hold because the tyre is too
damaged. Contact a Fiat Dealership.
157)You must always indicate that the tyre
was repaired using the Fix&Go automatic
kit. Give the booklet to the technicians who
will be handling the tyre that was treated
using the Fix&Go Automatic kit.
158)Repairs are not possible in the case of
damage to the wheel rim (bad groove
distortion causing air loss). Do not remove
foreign bodies (screws or nails) from the
tyre.
159)Never operate the compressor for
longer than 20 consecutive minutes. Risk
of overheating. The Fix&Go Automatic kit is
not suitable for definitive repairs, so the
repaired tyres may only be used
temporarily.160)As required by current regulations,
the information on chemical substances for
the protection of human health and the
environment and on the safe use of the
sealing fluid are on the cannister label.
Compliance with the indications on the
label is an essential condition to ensure the
safety and the effectiveness of the product.
Remember to carefully read the label
before use; the user of the product is
responsible for any damages caused by
improper use. The sealing fluid has an
expiry date. Replace the bottle if the
sealant has expired.
IMPORTANT
68)In the event of a puncture caused by
foreign bodies, the kit may be used to
repair tyres showing damage on the tread
or shoulder up to max. 4 mm diameter.
IMPORTANT
3)Dispose of the bottle and the sealant
liquid properly. Have them disposed of in
compliance with national and local
regulations.
161
