220
Changing a bulb
The lamps have polycarbonate lenses with
a
protective coating:
F
d
o not clean them using a dr y or
abrasive cloth, nor with a
detergent
or solvent product,
F
u
se a sponge and soapy water or a pH
neutral product,
F
w
hen using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a
bulb should only be done after
the lamp has been switched off for several
minutes (risk of serious burns).
F
D
o not touch the bulb directly with your
fingers, use a
lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a
failed bulb with a new
bulb with the same type and specification. In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a
few minutes.
Risk of electrocution
Xenon bulbs (D5S-25W) must be replaced
by a
CITROËN dealer or a qualified
workshop.
Light-emitting diodes (LED)
For the replacement of this type of bulb,
you must contact a
CITROËN dealer or
a
qualified workshop.
Front lamps
Model with xenon headlamps
1.Dipped beam headlamps (D5S-25W).
2. Main beam headlamps (H7-55W).
3. Daytime running lamps/sidelamps
(6
light-emitting diodes – LEDs).
4. Direction indicators
(6
light-emitting diodes – LEDs).
5. Foglamps (H11-55W).
In the event of a breakdown
221
Model with halogen headlamps
1.Dipped beam headlamps (H7-55W).
2. Main beam headlamps (H7-55W).
3. Daytime running lamps/sidelamps
(4
light-emitting diodes – LEDs).
4. Direction indicators (PW Y24W).
(light emitting diodes – LEDs).
5. Foglamps (H11-55W).
For bulbs with lugs (type H7, etc.), take
care to obser ve their correct installation so
as to ensure the best lighting per formance.
Directional dipped beam
headlamps (xenon model)
Replacement of D5S xenon bulbs
must be done by a
CITROËN dealer or
a
qualified workshop as there is a risk of
electrocution.
In case of a
fault in one of the two D5S
bulbs, it is recommended to also replace
the bulb on the opposite side.
Main beam headlamps (xenon
model) Dipped beam headlamps
(halogen model)
F Remove the protective plastic cover by
pulling the tab.
F
P
ush the connector.
F
P
ull the bulb to change it.
To reassemble, proceed in reverse order.
F
T
urn the protective plastic cover to remove
it.
F
D
isconnect the connector.
F
U
nhook the clips.
F
P
ull the bulb to change it.
To reassemble, proceed in reverse order.
8
In the event of a breakdown
