2017 Citroen C3 RHD ECO mode

.
Driving recommendations 147
Starting / Switching off the engine with the key

1
49
Starting / Switching off the engine with Keyless Entry and Starting

1
52
Parking brake

1
55
5 -speed manual gearbox

1
56
Automatic gearbox (EAT6)

1
57
Gear ef ficiency indicator

1
61
Hill start assist

1
62
Stop & Start

1
63
Memorising speeds

1
66
Speed limit recognition

1
67
Speed limiter

1
71
Cruise control

1
74
Fatigue detection system

1
78
Lane Departure Warning System

1
79
Blind Spot Monitoring System

1
80
Parking sensors

1
83
Reversing camera

1
85
Under-inflation detection
1

86
ConnectedCAM C
ITROËN
™ 18
9
Driving
Fuel tank 192
Misfuel prevention (Diesel)
1
94
Snow chains

1
96
Towing a trailer

1
97
Energy economy mode

1
98
Changing a wiper blade

1
99
Roof bars

2
00
Bonnet
20

1
Petrol engines

2
02
Diesel engines

2
03
Checking levels

2
04
Checking components
20

8
AdBlue
® and SCR system
(BlueHDi Diesel) 2 10
AIRBUMP
® protectors 2 14
Practical information
Warning triangle 2 15
Running out of fuel (Diesel)
2
15
Temporary puncture repair kit

2
16
Spare wheel

2
21
Changing a bulb

2
29
Changing a fuse

2
36
12 V battery

2
43
To w i n g
2

47
In the event of a breakdown
Engines 249
Weights
2
49
Dimensions
2

52
Identification markings
2

53
Technical data
Alphabetical index
For the audio and telematic systems,
refer to the supplement to the handbook
or go to the following internet address:
http://service.citroen.com/ddb/
Contents

8
Running out of fuel, Diesel (priming pump) 2 15
AdBlue
® and SCR system
(BlueHDi Diesel) 2 10 -213
Maintenance - Technical data
Checking levels 20 4-207
- o il
-

b
rake fluid
-
c

oolant
-

s
creenwash fluid
-

a
dditive (Diesel with particle filter)
Checking components
20

8-209
-
b

attery
-

a
ir / passenger compartment filter
-

o
il filter
-

p
article filter (Diesel)
-

b
rake pads / discs Changing bulbs
2

29-235
-

f
ront lamps
-

r
ear lamps
-
i

nterior lighting
Petrol engines

2
50
Diesel engines
2
51
Dimensions
2
52
Identification markings
2
53
Opening the bonnet
2
01
Under the bonnet, petrol

2
02
Under the bonnet, Diesel

2
03
12 V battery

2
43 -246
Load reduction, economy mode
1
98
Engine compartment
fuses
2
36 -237, 241-242
Over view

9
Optimise the use of your gearbox
With a manual gearbox, move off gently and change up without waiting.
During acceleration change up early.
If your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the
temperature in the passenger compartment down (sunroof and window
blinds...).
Switch off the air conditioning, unless it has automatic regulation, as
soon as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the ambient light
level does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
With an automatic gearbox, give preference to automatic mode and
avoid pressing the accelerator pedal heavily or suddenly.
The gear efficiency indicator invites you to engage the most suitable
gear: as soon as the indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an automatic gearbox, this indicator appears
only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and
CO
2 emissions and also help reduce the background traffic noise. A s a passenger, if you avoid connecting your multimedia devices
(film, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
.
Eco-driving

12
Display
1. Exterior temperature.
2. Cruise control or speed limiter settings.
S

peed suggested by the speed limit
recognition system.
3.
D

igital speedometer (mph or km/h).
4.
G

ear efficiency indicator and/or gear
selector position, gear and Sport and Snow
modes for an automatic gearbox.
5.
T

rip computer and Stop & Start time
counter. 6.
D

isplay zone: trip distance recorder (miles
or km), service indicator or Range related
to the AdBlue
® and the SCR system (miles
or km), total distance recorder, warning
messages or system status messages.
If your vehicle is not fitted with an audio system
or a touch screen, you can also configure
certain equipment using this display.
For more information on the Configuration of
the equipment on vehicles without a screen,
refer to the corresponding section.
Instruments

13
Visual indicators informing the driver that a system is in operation, switched off or has a fault.
Indicator and warning lamps
When the ignition is switched on
Certain warning lamps come on for a few
seconds in the instrument panel when the
vehicle's ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps may
be accompanied by an audible signal and a
message.
The warning lamps may come on continuously
(fixed) or flash.Certain warning lamps may come on in
one of two modes: fixed (continuous) or
flashing.
Only by relating the type of illumination
to the operation of the vehicle can it
be determined whether the situation is
normal or a fault has occurred. In the
event of a fault, the illumination of the
warning lamp may be accompanied by
a message.
Refer to the tables in the following
pages for more information.
When switching on the ignition, the
displays in the instrument panel appear
dynamically and progressively. This is
normal operation.
1
Instruments

16
Warning / indicator lampStateCause Action / Observations
Stop & Star t fixed.
When the vehicle stops (red lights,
traffic jams,
...) the Stop & Start system
has put the engine into STOP mode.The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable,
or
START mode is invoked
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Blind spot
monitoring
system
fixed.
The system has been activated. For more information on the Blind spot monitoring
system, refer to the corresponding section.
Instruments

49
A few definitions…
Range
(miles or km)
This value may vary following a change
in the style of driving or the relief,
resulting in a significant change in the
current fuel consumption.
When the range falls below 20 miles (30 km),
dashes are displayed.
After filling with at least 5 litres of fuel, the
range is recalculated and is displayed if it
exceeds 60 miles (100 km). This function is only displayed from
20
mph (30 km/h).
Current fuel
consumption
(mpg or l/100 km or km/l)
Distance travelled
(miles or km)
Stop & Star t time counter
(minutes / seconds or hours /
minutes)
A time counter calculates the time spent in
STOP mode during a journey.
It resets to zero every time the ignition is
switched on.
Average fuel consumption
(mpg or l/100 km or km/l)
Calculated since the last trip computer reset.
If dashes are displayed continuously
while driving in place of the digits,
contact a CITROËN dealer or a
qualified workshop.
The distance which can still be travelled with
the fuel remaining in the tank (at the average
fuel consumption seen over the last few miles
(kilometres) travelled).
Calculated over the last few seconds.
Average speed
(mph or km/h)
Calculated since the last trip computer reset. Calculated since the last trip computer reset.
1
Instruments

85
Mode AUTO
In cold weather with the engine cold,
the air flow is increased gradually until
the comfort setting has been reached,
in order to limit the delivery of cold air
into the passenger compartment.
On entering the vehicle, if the interior
temperature is much colder or warmer
than the comfort setting requested,
there is no need to alter the value
displayed in order to reach more quickly
the required level of comfort. The
system compensates automatically and
corrects the temperature difference as
quickly as possible.
This setting is associated with AUTO mode
only. However, on deactivation of AUTO mode,
the last setting used remains on.
Changing the setting does not reactivate AUTO
mode if deactivated.
To change the current setting, press the button
several times in succession to access the
desired mode:
" Soft ": provides soft and quiet operation by
limiting air flow.
" Normal ": offers the best compromise between
a comfortable temperature and quiet operation
(default setting).
" Fast ": provides strong and effective air flow.
Automatic programme mode setting
F Go to the secondary page by
pressing this button to vary the
automatic comfort programme,
choosing one of the modes
offered.
3
Ease of use and comfort