193
Changing a bulb
The headlamps have polycarbonate
lenses with a protective coating:
F
d
o not clean them using a dr y or
abrasive cloth, nor with a detergent
or solvent product,
F
u
se a sponge and soapy water or a pH
neutral product,
F
w
hen using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a bulb should only be done after
the headlamp has been switched off for
several minutes (risk of serious burns).
F
D
o not touch the bulb directly with your
fingers, use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a failed bulb with a new
bulb with the same type and specification. Light emitting diodes (LED)
For the replacement of this type of bulb,
you must contact a CITROËN dealer or a
qualified workshop.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Front lamps
* LED: light emitting diodes. 1.
Daytime running lamps/sidelamps
(W21/5W or LED)*.
2. Direction indicators (PY21W).
3. Dipped beam headlamps (H7).
4. Main beam headlamps (H7).
5. Foglamps (H8).
F
I
f your vehicle is so equipped, tighten the
security bolt using the wheelbrace 1 fitted
with the security socket 5.
F
T
ighten the other bolts using wheelbrace 1
o n l y.
F
S
tore the tools in the box or in the right-
hand compartment (depending on version).
F
P
re-tighten the other bolts using wheelbrace
1 o n l y.
F
L
ower the vehicle again fully.
F
F
old the jack 2 and detach it.
8
In the event of a breakdown
196
F Unclip the lamp unit and carefully extract it pulling straight towards the outside.
F
H
old the lamp unit and disconnect the
connector.
F
T
urn the bulb holder of the faulty bulb a
quarter turn anti-clockwise and pull it out.
F
R
emove the bulb and replace it.
To refit the lamp, carry out these operations in
reverse order.
Make sure to engage the lamp unit in its
guides while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
Reversing lamp and foglamp
For the replacement of this type of bulb, contact
a CITROËN dealer or a qualified workshop.
Third brake lamp (LED)
For the replacement of this type of bulb, contact
a CITROËN dealer or a qualified workshop.
Number plate lamps (LED)
For the replacement of this type of bulb, contact
a CITROËN dealer or a qualified workshop.
Interior lighting
Courtesy lamps (W5W)
Front courtesy lamp
F Using a thin, flap blade screwdriver, unclip the entire console surrounding the courtesy
lamp.
Rear courtesy lamp
F Using a thin, flat blade screwdriver, unclip the courtesy lamp.
F
P
ull the faulty bulb out and change it.
F
P
ut in place the console around the
courtesy lamp and clip it correctly.
In the event of a breakdown
