Page 39 of 306

37
Locking with the key
F Turn the key in the driver's door lock, towards the rear of the vehicle to lock it.
Check that the doors and boot are fully
closed.
Locating your vehicle
This function allows you to identify your vehicle
from a distance, particularly in poor light. Your
vehicle must be locked. F
P
ress the closed padlock button
on the remote control.
This will switch on the courtesy lights and the
direction indicators will flash for a few seconds.
Fault with the remote control
In the event of a malfunction with the remote
control, you can no longer unlock, lock or
locate your vehicle.
F
F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F
T
hen reinitialise the remote control.
Reinitialisation
F Switch off the ignition and remove the key from the switch.
F
P
ress the closed padlock button for a few
seconds.
F
R
eturn the key to position 2 ( ignition on).
F
S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Changing the battery
Reference: CR2032 / 3 Volts. If the problem persists, contact a CITROËN
dealer as soon as possible.
or If the battery is dead, you are
informed by illumination of this
warning light, an audible signal and a
message in the screen. F
U
nclip the cover using a small screwdriver
at the cut-out.
F
L
ift off the cover.
F
E
xtract the dead battery from its location.
F
P
lace the new battery into its location
observing the original direction.
F
C
lip the cover onto the casing.
2
Access
Page 41 of 306

39
Alarm
Perimeter protection
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...Self-protection function
The system checks for the putting out of
service of its components.
The alarm is triggered if the battery, the
central control or the siren wiring are put
out of service or damaged.
For all work on the alarm system, contact
a
CITROËN dealer or a qualified workshop.
Locking the vehicle
with alarm
Activation
F Turn the vehicle off and exit.
Deactivation
F Press the unlocking button on the remote control.
F
P
ress the locking button on the
remote control.
The alarm is activated: an indicator
light in the switch panel to the left of
the steering wheel flashes once per
second.
The alarm is deactivated: the
indicator lamp goes off.
Theft and break-in protection and deterrent
system. It provides perimeter protection as well
as a self-protection function.
The perimeter protection is activated 5 seconds
after pressing the locking button on the remote
control.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the alarm is
activated.
2
Access
Page 42 of 306
40
Triggering of the alarm
This is indicated by sounding of the siren and
flashing of the direction indicators for thirty
seconds.When the vehicle is unlocked using
the remote control, rapid flashing of
the indicator lamp informs you that
the alarm was triggered during your
absence. Upon ignition, this flashing
stops immediately.
Locking the vehicle without
activating the alarm
F Lock the vehicle using the key.
Failure of the remote control
Operating fault
When the ignition is switched on, continuous
illumination of the indicator light indicates a
fault with the system.
Have it checked by a
CITROËN dealer or a
qualified workshop. To deactivate the monitoring functions:
F
U
nlock the vehicle using the key.
F
O
pen the door; this sets off the alarm.
F
S
witch on the ignition; this stops the alarm.
Access
Page 43 of 306
41
Doors
Opening
From outsideFrom inside
Closing
F After unlocking the vehicle using the
remote control or the key, pull the door
handle. F
P ull the interior opening control for the
door. This action unlocks completely the
vehicle. When a door is not closed correctly:
-
w
hen the engine is running
,
this warning light comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-
w
hen the vehicle is moving
(speed higher than 6 mph
(10 km/h)), this warning light
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
2
Access
Page 45 of 306
43
Boot
Opening
Unlocking and releasing the boot
using the remote control
F Hold the centre button on the remote control down for more
than one second.
Releasing the boot from
the inside Opening the boot
F Raise the boot lid to its fully open position.
Closing
F Lower the boot lid using one of the interior
grab handles.
F
T
hen press the boot to close it.
If the tailgate is not fully closed: -
w
hen the engine is running ,
this warning light comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-
w
hen the vehicle is moving
(speed higher than 6 mph
(10
km/h)), this warning light
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
The boot lid is released and opens slightly.
F
P
ress the boot opening button located on
the left of the dashboard.
The boot lid is released and opens slightly.
2
Access
Page 47 of 306

45
Electric Windows
Manual controls
Turn the window handle located on the door
trim panel.
Electric controls
Model with front electric windows
Model with front and rear electric windows1
Left-hand front.
2 Right-hand front.
3 Right-hand rear.
4 Left-hand rear.
5 Deactivating the rear electric window
switches.
To open or close the window, press or pull
the switch. The window stops as soon as you
release the switch.
The electric window controls remain
active for approximately 45 seconds after
ignition is turned off, or until a front door is
opened. During this period of 45 seconds,
if you open a door while operating a
window, the window stops. Any new
electric window command will be ignored
until ignition is switched back on. With the warning light on, the switches are
deactivated. With the warning light off, the
switches are active.
Deactivating the rear window
controls
For the safety of your children, press
this button to deactivate all the rear
window controls, irrespective of their
positions.
Always remove the key from the ignition
when leaving the vehicle, even for a short
time.
If an electric windows meets an obstacle
during operation, you must reverse the
movement of the window. To do this, press
the appropriate switch.
When operating the passenger electric
window switches, the driver must ensure
that no one is preventing the windows
from closing correctly.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be particularly aware of children when
operating the windows.
2
Access
Page 53 of 306
51
Electric model
Adjustment
The objects observed are, in reality, closer
than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.
F
M
ove control A to the right or to the left to
select the corresponding mirror.
F
M
ove the control in all four directions to
adjust.
F
R
eturn control to the central position.
Manual folding
You can manually fold the mirrors (parking
obstruction, narrow garage,...)
F
T
urn the mirror towards the vehicle.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlights from other vehicles...
Adjustment
Day / night position
F Pull the lever to change to the "night" anti-dazzle position.
F
P
ush the lever to change to the normal
"day" position.
F
A
djust the mirror so that the glass is
directed correctly in the "day" position.
3
Ease of use and comfort
Page 54 of 306
52
Heating / Ventilation
This system operates only with the engine running.
1Temperature.
2 A ir f low.
3 Air distribution.
4 Air intake / Air recirculation
Manual air conditioning
(without display screen)
This system operates only with the engine running.
1Temperature.
2 A ir f low.
3 Air distribution.
4 Air intake / Air recirculation
5 Air conditioning.
Temperature
F Turn the thumb wheel from
blue (cold) to red (hot) to
modulate the temperature to
your liking.
Air flow
F Turn the thumb wheel to obtain a comfortable air flow.Deactivation
If you put the air flow control in the 0 position,
the temperature is no longer controlled.
A slight flow of air can still be felt, resulting from
the for ward movement of the vehicle.
Ease of use and comfort