2017 CITROEN C-ELYSÉE lights

30
Every time the ignition is switched on, the
Service and engine diagnostic warning
lights come on and the AdBlue warning light
flashes, accompanied by the temporary
display of "NO START IN" and 0 km or miles
- ("NO
START IN 0 km" means "Starting
prevented") in the instrument cluster. Starting prevented
You have exceeded the authorised driving
limit: the starting prevention system
inhibits engine starting.To be able to start
the engine, you must call on a
CITROËN
dealer or a qualified workshop.
Distance recorders
Total distance recorder
System which measures the total distance
travelled by the vehicle during its life.
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.
Trip distance recorder
System which measures a distance travelled
during a day or other period since it was reset
to zero by the driver.
F

W
ith the ignition on, press the button until
zeroes appear.
or
Instruments

37
Locking with the key
F Turn the key in the driver's door lock, towards the rear of the vehicle to lock it.
Check that the doors and boot are fully
closed.
Locating your vehicle
This function allows you to identify your vehicle
from a distance, particularly in poor light. Your
vehicle must be locked. F

P
ress the closed padlock button
on the remote control.
This will switch on the courtesy lights and the
direction indicators will flash for a few seconds.
Fault with the remote control
In the event of a malfunction with the remote
control, you can no longer unlock, lock or
locate your vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
Reinitialisation
F Switch off the ignition and remove the key from the switch.
F

P
ress the closed padlock button for a few
seconds.
F

R
eturn the key to position 2 ( ignition on).
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Changing the battery
Reference: CR2032 / 3 Volts. If the problem persists, contact a CITROËN
dealer as soon as possible.
or If the battery is dead, you are
informed by illumination of this
warning light, an audible signal and a
message in the screen. F

U

nclip the cover using a small screwdriver
at the cut-out.
F

L

ift off the cover.
F

E

xtract the dead battery from its location.
F

P

lace the new battery into its location
observing the original direction.
F

C

lip the cover onto the casing.
2
Access

51
Electric model
Adjustment
The objects observed are, in reality, closer
than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.
F

M
ove control A to the right or to the left to
select the corresponding mirror.
F

M
ove the control in all four directions to
adjust.
F

R
eturn control to the central position.
Manual folding
You can manually fold the mirrors (parking
obstruction, narrow garage,...)
F

T
urn the mirror towards the vehicle.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlights from other vehicles...
Adjustment
Day / night position
F Pull the lever to change to the "night" anti-dazzle position.
F

P
ush the lever to change to the normal
"day" position.
F

A
djust the mirror so that the glass is
directed correctly in the "day" position.
3
Ease of use and comfort

64
Lighting control
In some climate conditions (low
temperature, humidity), the presence
of mist on the internal sur face of the
headlamp and rear lamp glass is normal;
this disappears a few minutes after the
lights are switched on.
Selection ring for main lighting
mode
Lighting off (ignition off) / Daytime
running lights (engine running).
Turn the ring to align the desired symbol with
the marking.
Side lights only.
Dipped or main beam headlights.
Dipping the headlights
Pull the lever to switch the lighting
between dipped and main beam
headlights.
Display
Illumination of the corresponding indicator
light in the instrument panel confirms that the
lighting selected is on.
Fog light selection ring
The fog lights operate with the dipped and main
beam headlights.
Rear fog light only
F To switch it on, turn the ring for wards.
F T o switch it off, turn the ring backwards.
In the lighting off and side lights modes, the
driver can switch on the main beam headlights
temporarily ("headlight flash") by keeping the
lever pulled.
Lighting and visibility

65
Front fog lights and rear fog light
Move the ring by rotating it:
F A 1st time for ward to switch the front fog
lights on.
F

A 2nd time for ward to switch the rear fog
light on.
F

1
st time backward to switch the rear fog
light of f.
F

2
nd time backward to switch the front fog
lights of f. The fog lights and side lights remain on if the
dipped beams are switched off manually.
F

T
urn the ring towards the rear to switch
off the fog lights, the side lights will then
switch off.
In good or rainy weather, both day and
night, using the front fog lights and the
rear fog light is prohibited. In these
situations, the power of their beams may
dazzle other drivers. They should only be
used in fog or falling snow.
In these weather conditions, it is your
responsibility to switch on the fog lights
and dipped headlights manually as the
sunshine sensor may detect sufficient
light.
Do not forget to turn of the front fog lights
and the rear fog light as soon as they are
no longer necessary. Switching off the lights when the
ignition is switched off
On switching off the ignition, all of the
lights turn off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated.
Switching on the lighting when
switching on the ignition
To reactivate the lighting control, rotate
the ring to the "0" position - lights off, then
to the desired position.
When the driver's door is opened, a
temporary audible signal warns you that
the vehicle's lighting is on.
The lighting, with the exception of the
side lights, switch off automatically after
a maximum duration of thirty minutes to
prevent discharging of the battery.
4
Lighting and visibility

66
Daytime running lights
(Depending on the country of sale.)
When starting the vehicle, the daytime running
lights come on automatically, if the lighting
control is in the "0" position.The daytime running lights go off
if the side lights and dipped beam
headlights are switched on.
This function cannot be deactivated.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual follow-me lighting goes off
automatically at the end of a given period of
time.
Manual guide-me-home
lighting
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been
switched off makes the driver's exit easier
when the light is poor.
Lighting and visibility

67
Headlight beam height adjustment
To avoid causing a nuisance to other road
users, the height of the headlight beams should
be adjusted according to the load in the vehicle.
Depending on the version, this adjustment can
be carried out using the control located:
-
U
nder the bonnet.
-

T
o the left of the steering wheel
Bonnet
F Raise the bonnet to access the control (one per headlight).
F

T
urn the control to adjust the height of the
headlight beam.
To the left of the steering wheel
0 1 or 2 people in the front seats.
- 5 people.
1 5 people + maximum authorised load in
the boot.
- Driver on his own + maximum authorised
load in the boot.
The higher number positions can be used, but
may limit the area illuminated by the headlights.
The initial setting is position "0". Travelling abroad
The design of the dipped beam headlights
allows, without modification, driving in a
country that drives on the other side of the
road to the country in which your vehicle
was sold.
4
Lighting and visibility

69
Courtesy lights
ACourtesy lights
B Map reading lights
Front and rear courtesy lights
In permanent lighting mode, the lighting
time varies according to the circumstances:
-

W
hen the ignition is off, approximately
ten minutes.
-

I
n energy savings mode, approximately
thirty seconds.
-

W
hen the engine is running, no limit.
Front map reading lights
F With the ignition on, press the corresponding switch.
In this position, the courtesy light
comes on gradually:
- When unlocking the vehicle.
-
W hen the key is removed from the ignition
switch.
-
W

hen opening a door.
-

W
hen actuating the locking button on the
remote control in order to locate your vehicle.
It switches off gradually:
-
W

hen locking the vehicle.
-

W
hen the ignition is switched on.
-

3
0 seconds after the last door is closed.Permanently off.
Permanent lighting.
4
Lighting and visibility