65
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Selecting the functionFirst activation /
Programming a
speed Temporarily exceeding the
speed setting
Deactivation (off)
- Press this button or
the brake or clutch
pedal.
Reactivation
- Following deactivation of the cruise
control, press this button.
Your vehicle will return to the last
programmed
speed.
Alternatively,
you can repeat the "first
activation"
procedure.
It is possible to accelerate and drive
momentarily at a speed greater than
the
programmed
speed
setting.
The
value
programmed
flashes.
When the accelerator pedal is
released, the vehicle will return to the
programmed
speed.
-
Reach the chosen speed by
pressing
the
accelerator.
-
Press the
SET - or SET +
button.
This
programmes/activates
the
speed
setting and the vehicle will maintain
this
speed.
-
Place the switch in the
CRUISE
position.
The
cruise
control
is
selected but is not yet active and
no
speed
has
been
programmed.
Steering mounted controls
EASE OF USE and COMFORT
4
66
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Changing the
programmed speedSwitching the system off
Operating fault Cancelling the programmed
speed setting
When the vehicle becomes stationary,
after switching off the ignition, the
system
no longer memorises a speed.
There are two methods of memorising
a speed higher
than
the
previous
one:
-
Place the dial in position
0 or switch
off the ignition to switch everything
off.
Good practice
Without using the accelerator
-
Press the
SET + button.
A brief press increases the speed by 1 mph (km/h).
A maintained press increases the speed in
steps
of 5 mph (km/h).
Using the accelerator
-
Exceed the memorised speed until
the speed required is reached,
-
Press the
SET + or SET - button.
To memorise a speed lower than the
previous
one:
-
Press the
SET - button.
A brief press decreases the speed by
1
mph (km/h).
A maintained press decreases the
speed
in steps of 5 mph (km/h).The programmed speed setting is
cleared
and replaced by three dashes.
Contact a CITROËN dealer or a
qualified
workshop to have the system
checked.When changing the programmed
speed setting by means of a
maintained press, pay attention as
the speed can increase or decrease
rapidly
.
Do not use the cruise control on
slippery roads or in heavy traffic.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed
setting.
In any event, the cruise control cannot
replace the need to observe the speed
limits and the need for vigilance on the
part of the driver.
It is advisable to keep your feet near
the
pedals.
To avoid any jamming under the
pedals:
-
ensure
that the mat and its fixings
on
the floor are positioned correctly,
-
never place one mat on top of
another
.
Steering mounted controls
