2017.5 OPEL MOVANO_B clock

Vehicle care193Load compartment light
1. Remove lamp assembly using aflat blade screwdriver.
2. Detach wiring connector from lamp assembly.
3. Remove lens cover and renew bulb.
4. Install lens cover and attach wiring connector to lamp
assembly.
5. Install lamp assembly.
Front door panel light
1. Remove lamp assembly using a flat blade screwdriver.
2. Rotate bulb holder anti-clockwise to disengage.
3. Renew bulb and insert the bulb holder.
4. Install lamp assembly.
Rear courtesy lights
Have bulbs replaced by a workshop.
Glovebox light
Have bulbs replaced by a workshop.
Instrument panel illumination
Have bulbs replaced by a workshop.

210Vehicle careNote
If applicable, fit anti-theft bolts
nearest the tyre valve (otherwise it
may not be possible to refit the wheel cover).
10. Stow the replaced wheel 3 210
and the vehicle tools 3 198.
11. Have the new wheel balanced on the vehicle. Check the tyre
pressure of the installed tyre
3 246 and also the wheel bolt/nut
torque as soon as possible.
Have the defective tyre renewed or
repaired.
Spare wheel Some vehicles are equipped with atyre repair kit instead of a spare wheel
3 204.
If mounting a spare wheel which is
different from the other wheels, this
wheel might be classified as a
temporary spare wheel and the
corresponding speed limits apply,
even though no label indicates this.
Seek the assistance of a workshop to
check the applicable speed limit.Caution
The use of a spare wheel that is smaller than the other wheels or in combination with winter tyres
could affect driveability. Have the defective tyre replaced as soon as
possible.
The spare wheel is held under the
vehicle frame using a winch and
secured by tightening a cable using
the wheel wrench and adapters
(depending on vehicle).
It may be necessary to jack the
vehicle up to gain access to the spare
wheel on a fully loaded vehicle with a flat rear tyre.
To release the spare wheel, loosen
cable by connecting the wheel
wrench and adapters (depending on
vehicle) to the slot position illustrated
and lower the wheel fully by turning
wrench clockwise.
Caution
Only use the wheel wrench and
adapters (depending on vehicle)
to lower the spare wheel.
The use of pneumatic tools is
prohibited. This may result in
damage to the winch cable and
equipment.

212Vehicle careThen tighten cable using the wheel
wrench and adapters by connecting
to the slot position illustrated above
and turning wrench anticlockwise
until the wheel is secured in the fully
raised position.9 Warning
Ensure the front of the wheel (side
with tyre valve) is facing upwards
when the spare wheel is
reinstalled below the vehicle
frame.
Temporary spare wheel
Caution
The use of a spare wheel that is smaller than the other wheels or in combination with winter tyres
could affect driveability. Have the defective tyre replaced as soon as
possible.
Only mount one temporary spare
wheel. Do not drive faster than
80 km/h. Take curves slowly. Do not use for a long period of time.
If your vehicle gets a flat tyre on the
rear while towing another vehicle,
mount the temporary spare wheel in the front and the full tyre in the rear.
Tyre chains 3 204.
Summer and winter tyres
If you use winter tyres, the spare
wheel may still be fitted with a
summer tyre.
If you use the spare wheel when it is
fitted with a summer tyre the vehicle's driveability may be affected,
especially on slippery road surfaces.
Directional tyres Fit directional tyres such that they rollin the direction of travel. The rolling
direction is indicated by a symbol
(e.g. an arrow) on the sidewall.
The following applies to tyres fitted
opposing the rolling direction:
● Driveability may be affected. Have the defective tyre renewed
or repaired as soon as possible
and fit it instead of the spare
wheel.● Do not drive faster than 80 km/h.
● Drive particularly carefully on wet
and snow-covered road
surfaces.

Vehicle care215far away from the discharged
vehicle battery as possible,
however at least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump start.
2. After five minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of
one minute.
3. Allow both engines to idle for approx. three minutes with the
leads connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle The towing eye and wheel wrench are
stowed with the vehicle tools 3 198.
Disengage the cover using a suitable
tool and remove.
Screw the towing eye clockwise into
the front towing point and tighten fully using the wheel wrench.
Attach a tow rope - or better still a tow
rod - to the towing eye, never to the
bumper or front suspension units.
Caution
Do not tow the vehicle from the
rear. The front towing eye must
only be used for towing and not
recovering a vehicle.
Switch on ignition to permit operation
of brake lights, horn and windscreen
wipers, and move the steering wheel
slightly to release the steering wheel
lock.
Switch off the air suspension system 3 140.
Transmission in neutral.
Caution
Vehicles with manual
transmission automated: If neutral cannot be selected, the vehiclemust only be towed with the drive
wheels raised off the ground.
The vehicle should always be
towed with the ignition switched
off.
Manual transmission automated
3 150.

253Changing tyre and wheel size ...203
Charging system .......................... 97
Child locks ................................... 28
Child restraint installation locations ................................... 65
Child restraints.............................. 63
Child restraint systems ................63
Cigarette lighter ........................... 89
Cleaning the vehicle ...................217
Climate control ............................. 16
Climate control systems .............116
Clock ............................................ 87
Coat hooks ................................... 73
Collision damage repair ..............250
Control indicators.......................... 93
Control of the vehicle .................133
Controls ........................................ 84
Convex shape .............................. 36
Coolant ....................................... 178
Coolant and antifreeze ...............222
Coolant heater ............................ 123
Cornering light ....................111, 187
Coupling ball bar ........................172
Cruise control ....................101, 159
Cupholders .................................. 73
D
Danger, Warnings and Cautions ...4
Dashboard .................................... 10
Daytime running lights ...............110Declaration of conformity ............248
DEF ............................................ 143
Demisting and defrosting ..............16
Diesel exhaust fluid ....................143
Diesel fuel ................................... 168
Diesel fuel filter .......................... 183
Diesel fuel system bleeding .......183
Diesel particle filter ....................142
Door locks..................................... 23
Door open .................................. 101
Doors ............................................ 28
DPF (diesel particle filter) ...........142
Drink holders ................................ 73
Driver assistance systems ..........159
Driver Information Centre ...........102
Driving characteristics and towing tips .............................. 171
Driving economically................... 133
Driving hints ................................ 133
E ECO mode .................................. 133
ecoScoring.................................. 104
Electric adjustment ......................36
Electrical accessories ...................87
Electrical system......................... 194
Electronic climate control system 118
Electronic driving programmes ..152
Electronic Stability Program 99,
157, 172Electronic Stability Program off ...99
Emergency exit .......................39, 41
End-of-life vehicle recovery .......176
Engine compartment fuse box ...195
Engine coolant ........................... 178
Engine coolant temperature ........99
Engine coolant temperature gauge ....................................... 91
Engine data ............................... 227
Engine Drag Torque Control ......157
Engine exhaust .......................... 142
Engine identification ...................225
Engine oil ...........177, 222, 226, 245
Engine oil additives ....................222
Engine oil level monitor ................92
Engine oil pressure ....................100
Engine oil viscosity grades .........222
Enhanced Traction function....... ................................ 156, 157, 159
Event data recorders ..................250
Exhaust gases ............................ 142
Exit lighting ................................ 115
Exterior care .............................. 217
Exterior light ............................... 101
Exterior lighting ....................14, 108
Exterior mirrors ............................. 36
F Fault ........................................... 153
Fire extinguisher ........................... 80