2016 VAUXHALL MERIVA stop start

Vehicle care173
Press the safety catch and open the
bonnet.
Secure the bonnet support.
If the bonnet is opened during an
Autostop, the engine will be restarted automatically for safety reasons.
Closing
Before closing the bonnet, press the
support into the holder.
Lower the bonnet and allow it to fall
into the latch from a low height
(20-25 cm). Check that the bonnet is engaged.Caution
Do not press the bonnet into the
latch, to avoid dents.
Engine oil
Check the engine oil level manually
on a regular basis to prevent damage
to the engine.
Ensure that the correct specification
of oil is used. Recommended fluids
and lubricants 3 220.
The maximum engine oil
consumption is 0.6 l per 1000 km.
Check with the vehicle on a level
surface. The engine must be at
operating temperature and switched
off for at least five minutes.
Pull out the dipstick, wipe it clean,
insert it to the stop on the handle, pull
out and read the engine oil level.
Insert dipstick to the stop on the
handle and make half a turn.
Different dipsticks are used
depending on engine variant.

176Vehicle care
The brake fluid level must be betweenthe MIN and the MAX marks.
When topping up, ensure maximum cleanliness as contamination of the
brake fluid can lead to brake system
malfunctions. Have the cause of the
loss of brake fluid remedied by a
workshop.
Only use high-performance brake
fluid approved for the vehicle.
Brake and clutch fluid 3 220.
Vehicle battery
The vehicle battery is maintenance-
free provided that the driving profile
allows sufficient charging of the
battery. Short-distance-driving and
frequent engine starts can discharge
the battery. Avoid the use of
unnecessary electrical consumers.
Batteries do not belong in household
waste. They must be disposed of at
an appropriate recycling collection
point.
Laying up the vehicle for more than
four weeks can lead to battery
discharge. Disconnect the clamp from the negative terminal of the vehicle
battery.
Ensure the ignition is switched off
before connecting or disconnecting
the vehicle battery.
The anti-theft alarm siren must be
deactivated as follows: Switch the
ignition on then off, disconnect the
vehicle's battery within 15 seconds.
Vehicle battery discharge protection
3 127.
Replacing the vehicle battery
Notice
Any deviation from the instructions
given in this paragraph may lead to
a temporary deactivation of the stop-
start system.
When the vehicle battery is being
replaced, please ensure that there
are no open ventilation holes in the
vicinity of the positive terminal. If a
ventilation hole is open in this area, it
must be closed off with a dummy cap, and the ventilation in the vicinity of the
negative terminal must be opened.
Only use vehicle batteries that allow
the fuse box to be mounted above the vehicle battery.
In vehicles with an AGM (Absorptive
Glass Mat) battery, make sure to
have the battery replaced with
another AGM battery.

Vehicle care177
An AGM battery can be identified by
the label on the battery. We
recommend the use of an original
Vauxhall vehicle battery.
Notice
Using an AGM vehicle battery
different from the original Vauxhall
vehicle battery may result in a lower performance.
9 Warning
When fitting a battery with a length
deviating from the original one, itis essential to ensure a proper
fitting of the buffer element.
We recommend that you have the
vehicle battery replaced by a
workshop.
Stop-start system 3 141.
Charging the vehicle battery9 Warning
On vehicles with stop-start
system, ensure that the charging potential does not exceed
14.6 volts when using a battery
charger. Otherwise the vehicle
battery might be damaged.
Jump starting 3 212.
Warning label

Vehicle care199
Select:● Light for comfort pressure up to
3 people.
● Eco for Eco pressure up to
3 people.
● Max for full loading.
Tyre pressure sensor matching
process
Each tyre pressure sensor has a
unique identification code. The
identification code must be matched
to a new wheel position after rotating the wheels or exchanging the
complete wheel set and if one or more tyre pressure sensors were replaced.
The tyre pressure sensor matching
process should also be performed
after replacing a spare wheel with a
road wheel containing the tyre
pressure sensor.
The malfunction light w and the
warning message or code should go
off at the next ignition cycle. The
sensors are matched to the wheel
positions, using a relearn tool, in the following order: left side front wheel,
right side front wheel, right side rear
wheel and left side rear wheel. The
turn signal light at the current active
position is illuminated until sensor is
matched.
Consult a workshop for service or
purchase a relearn tool. There are
two minutes to match the first wheel
position, and five minutes overall to
match all four wheel positions. If it
takes longer, the matching process stops and must be restarted.
The tyre pressure sensor matching
process is:
1. Apply the parking brake.
2. Turn the ignition on.3. On vehicles with automatic transmission: set the selector
lever to P.
On vehicles with manual
transmission: select neutral.
4. Press MENU on the turn signal
lever to select the Vehicle
Information Menu in the Driver
Information Centre.
5. Turn the adjuster wheel to scroll to
the tyre pressure menu.
6. Press SET/CLR to begin the
sensor matching process. A
message requesting acceptance
of the process should display.
7. Press SET/CLR again to confirm
the selection. The horn sounds
twice to signal the receiver is in
relearn mode.
8. Start with the left side front wheel.
9. Place the relearn tool against the tyre sidewall, near the valve stem.Then press the button to activate
the tyre pressure sensor. A horn
chirp and the brief activation of all turn signal lights confirm that the

247Operate pedal............................... 95
Outside temperature ....................84
Overrun cut-off ........................... 141
P Parking ................................ 17, 143
Parking assist ............................ 155
Parking brake ............................ 150
Parking lights ............................. 124
Particulate filter ........................... 144
Performance .............................. 229
Performing work ........................172
Personalisation ........................... 111
Pollen filter ................................. 136
Power outlets ............................... 86
Power steering fluid ....................175
Power windows ............................ 31
Preheating ................................... 97
Puncture ..................................... 206
Q Quickheat ................................... 135
R
Radio Frequency Identification (RFID) ..................................... 242
Radio remote control ...................20
Reading lights ............................ 126
Rear carrier system ......................63
Rear doors ................................... 26
Rear floor storage cover ..............74Rear fog light ............................... 99
Rear fog lights ........................... 124
Rear seats .................................... 41
Rear storage ................................. 73
Rear view camera ...................... 157
Rear window wiper/washer .......... 84
Recommended fluids and lubricants ........................ 220, 224
Reduced engine power ...............98
Refuelling ................................... 161
Remote control ............................. 20
Retained power off .....................139
Reversing lights .........................124
Ride control systems ..................152
Roof .............................................. 33
Roof load ...................................... 78
Roof rack ..................................... 78
S Safety belts ................................... 44
Safety net .................................... 75
Seat adjustment ....................... 6, 37
Seat belt ........................................ 8
Seat belt reminder .......................94
Seat belts ..................................... 44
Seat heating ................................. 40
Seat position ................................ 36
Selector lever ............................. 146
Service ............................... 136, 219
Service display ............................ 90Service information ....................219
Service vehicle soon .................... 95
Side airbag system ......................51
Sidelights .................................... 119
Side turn signal lights ................187
Software acknowledgement .......239
Spare wheel ............................... 209
Speedometer ............................... 88
Starting and operating ................139
Starting off ................................... 16
Starting the engine ....................140
Steering ...................................... 139
Steering wheel adjustment ......9, 81
Steering wheel controls ...............81
Steering wheel, heated .................81
Stop-start system........................ 141
Storage ......................................... 60
Storage compartments .................60
Sunvisor lights ........................... 126
Sun visors .................................... 33
Symbols ......................................... 4
T
Tachometer ................................. 88
Tailgate ......................................... 26
Tail lights ................................... 184
Technical data ............................ 227
Three-point seat belt .................... 45
Tools .......................................... 194
Top-tether fastening eyes ............59