
SIENNA_OM_OM08013U_(U)
892. Instrument cluster
2
Instrument cluster
The brightness of the meter panel lights can be adjusted.
Pressing the button will adjust the
brightness  of  the  meter  panel
lights.
The  brightness  level  of  the  meters
when  the  surroundings  are  bright
(day  mode)  and  dark  (night  mode)
can  be  adjusted  individually.  How-
ever,  when  in  day  mode,  adjusting
the  brightness  level  will  also
change  the  brightness  level  of
night mode.
■ Outside temperature display
●In  the  following  situations,  the  correct  outside  temperature  may  not  be  dis-
played, or the display may take longer than normal to change.
• When stopped, or driving at low speeds (less than 12 mph [20 km/h])
• When  the  outside  temperature  has  changed  suddenly  (at  the  entrance/
exit of a garage, tunnel, etc.)
● The temperature range that can be displa yed is from -40°F (-40°C) to 122°F
(50°C). 
Vehicles with monochrome display
When  the  outside  temperature  drops  below  37°F  (3°C),  the  temperature
display flashes 10 times.
Vehicles with color display
When  the  outside  temperature  drops  below  37°F  (3°C),  the  ICE  warning
indicator will be displayed on the multi-information display. ( P. 84)
● When “--” or “E” is displayed, the system may be malfunctioning. Take your
vehicle to your Toyota dealer.
Meter panel light control
NOTICE
■ To prevent damage to the engine and its components
●Do not let the indicator needle of the tachometer enter the red zone, which
indicates the maximum engine speed.
● The engine may be overheating if the engine coolant temperature gauge is
in  the  red  zone  (H).  In  this  case,  immediately  stop  the  vehicle  in  a  safe
place, and check the engine after it has cooled completely. (P. 591) 

200
SIENNA_OM_OM08013U_(U)
4-1. Before driving
WARNING
Observe the following precautions. 
Failure to do so may result in death or serious injury.
■When the vehicle is parked
●Do  not  leave  cigarette  lighters  in  the  vehicle.  If  a  cigarette  lighter  is  in  a
place such as the glove box or on the floor, it may be lit accidentally when
luggage is loaded or the seat is adjusted, causing a fire.
● Do  not  attach  adhesive  discs  to  the  windshield  or  windows.  Do  not  place
containers  such  as  air  fresheners  on  the  instrument  panel  or  dashboard.
Adhesive discs or containers may act as lenses, causing a fire in the vehi-
cle.
● Do  not  leave  a  door  or  window  open  if  the  curved  glass  is  coated  with  a
metallized film such as a silver-colored one. Reflected sunlight may cause
the glass to act as a lens, causing a fire.
● Always  apply  the  parking  brake,  shift  the  shift  lever  to  P,  stop  the  engine
and lock the vehicle.
Do not leave the vehicle unattended while the engine is running.
● Do  not  touch the exhaust pipe while the engine is running or immediately
after turning the engine off. 
Doing so may cause burns.
■ When taking a nap in the vehicle
Always  turn  the  engine  off.  Otherwise,  if  you  accidentally  move  the  shift
lever  or depress  the accelerator  pedal, this  could  cause  an  accident or  fire
due  to  engine  overheating.  Additionally,  if  the  vehicle  is  parked  in  a  poorly
ventilated area, exhaust gases may collect and enter the vehicle, leading to
death or a serious health hazard. 
![TOYOTA SIENNA 2016 XL30 / 3.G Owners Manual SIENNA_OM_OM08013U_(U)
2194-1. Before driving
4
Driving
●Due to the added load of the trailer, your vehicle’s engine may over-
heat  on  hot  days  (at  temperatures  over  85°F  [30°C])  when   TOYOTA SIENNA 2016 XL30 / 3.G Owners Manual SIENNA_OM_OM08013U_(U)
2194-1. Before driving
4
Driving
●Due to the added load of the trailer, your vehicle’s engine may over-
heat  on  hot  days  (at  temperatures  over  85°F  [30°C])  when](/manual-img/14/6814/w960_6814-218.png)
SIENNA_OM_OM08013U_(U)
2194-1. Before driving
4
Driving
●Due to the added load of the trailer, your vehicle’s engine may over-
heat  on  hot  days  (at  temperatures  over  85°F  [30°C])  when  driving
up a long or steep grade. If the Engine coolant temperature gauge
overheating, immediately turn off th e air conditioning (if in use), pull
your vehicle off the road and stop in a safe spot. ( P. 591)
● Always place wheel blocks under both the vehicle’s and the trailer’s
wheels  when  parking.  Apply  the  pa rking  brake  firmly,  and  put  the
transmission  in  P.  Avoid  parking  on  a  slope,  but  if  unavoidable,  do
so only after performing the following:
Apply the brakes and keep them applied.
Have someone place wheel  blocks  under both the vehicle’s and
trailer’s wheels.
When  the  wheel  blocks  are  in  pl ace,  release  the  brakes  slowly
until the blocks absorb the load.
Apply the parking brake firmly.
Shift into P and turn off the engine.
● When restarting after parking on a slope:
With the transmission in P, start the engine. Be sure to keep the
brake pedal pressed.
Shift into a forward gear. If reversing, shift into R.
Release  the  parking  brake  and  brake  pedal,  and  slowly  pull  or
back away from the wheel blocks. Stop and apply the brakes.
Have someone retrieve the blocks.
1
2
3
4
5
1
2
3
4 

SIENNA_OM_OM08013U_(U)
2314-2. Driving procedures
4
Driving
■Steering lock
After  turning  the  engine  switch  off  and  opening  and  closing  the  doors,  the
steering wheel will be locked due to the steering lock function. 
Operating the engine switch again automatically cancels the steering lock.
■ When the steering lock cannot be released
■ Steering lock motor overheating prevention
To  prevent  the  steering  lock  motor  from  overheating,  the  motor  may  be  sus-
pended if the engine is turned on and off repeatedly in a short period of time. 
In  this  case,  refrain  from  operating  the  engine.  After  about  10  seconds,  the
steering lock motor will resume functioning.
■ When the engine switch indicator flashes in amber
The system may be malfunctioning. Have the vehicle inspected by your Toy-
ota dealer immediately.
■ If the electronic key battery is depleted
P. 507
■ Operation of the engine switch
●When  operating  the  engine  switch,  one  short,  firm  press  is  enough.  If  the
switch is pressed improperly, the engine may not start or the engine switch
mode may not change. It is not necessary to press and hold the switch.
● If  attempting  to  restart  the  engine  immediately  after  turning  the  engine
switch off, the engine may not start in some cases. After turning the engine
switch off, please wait a few seconds before restarting the engine.
The  green  indicator  light  on  the  engine
switch  will  flash  and  a  message  will  be
shown  on  the  multi-information  display.
Press  the  engine  switch  while  turning  the
steering wheel left and right. 

238
SIENNA_OM_OM08013U_(U)
4-2. Driving procedures
Parking brake
To  set  the  parking  brake,  fully
depress  the  parking  brake  pedal
with  your  left  foot  while  depress-
ing the brake pedal with your right
foot.
(Depressing  the  pedal  again
releases the parking brake.)
■Usage in winter time
P. 313
Operating instructions
U.S.A.Canada
NOTICE
■Before driving
Fully release the parking brake.
Driving the vehicle with the parking brake set will lead to brake components
overheating,  which  may  affect  braking  performance  and  increase  brake
wear. 

296
SIENNA_OM_OM08013U_(U)
4-5. Using the driving support systems
■Reduced effectiveness of the EPS system
The  effectiveness  of  the  EPS  system  is  reduced  to  prevent  the  system  from
overheating when there is frequent steering input over an extended period of
time. The steering wheel may feel heavy as a result. Should this occur, refrain
from excessive steering input or stop the vehicle and turn the engine off. The
EPS system should return to normal within 10 minutes.
■ Operating conditions of hill-start assist control (vehicles with a hill-start
assist control system)
When  the  following  four  conditions  are  met,  the  hill-start  assist  control  will
operate:
●The  shift  lever  is  in  a  position  other  than  P  or  N  (when  starting  off  forward/
backward on an upward incline).
● The vehicle is stopped.
● The accelerator pedal is not depressed.
● The parking brake is not applied.
■ Automatic system cancelation of hill-sta rt assist control (vehicles with a
hill-start assist  control system)
The hill-start assist control will turn  off in any of the following situations:
● The shift lever is shifted to P or N.
● The accelerator pedal is depressed.
● The parking brake is applied.
● Approximately 2 seconds elapse after the brake pedal is released.
WARNING
■ The ABS does not operate effectively when
●The  limits  of  tire  gripping  performance  have  been  exceeded  (such  as
excessively worn tires on a snow covered road).
● The vehicle hydroplanes while driving at high speed on wet or slick roads.
■ Stopping distance when the ABS is  operating may exceed that of nor-
mal conditions
The ABS is not designed to shorten the vehicle’s stopping distance. Always
maintain  a  safe  distance  from  the  vehicle  in  front  of  you,  especially  in  the
following situations:
● When driving on dirt, gravel or snow-covered roads
● When driving with tire chains
● When driving over bumps in the road
● When driving over roads with potholes or uneven surfaces 

420
SIENNA_OM_OM08013U_(U)
6-1. Using the air conditioning system and defogger
Heated steering wheel/seat heaters
: If equipped
Heated steering wheel and seat heaters heat the side grips of the
steering wheel and seats, respectively.
WARNING
●Care should be taken to prevent injury if anyone in the following categories
comes in contact with the steering wheel and seats when the heater is on:
• Babies,  small  children,  the  elderly,  the  sick  and  the  physically  chal-
lenged
• Persons with sensitive skin
• Persons who are fatigued
• Persons  who  have  taken  alcohol  or  drugs  that  induce  sleep  (sleeping drugs, cold remedies, etc.)
● Observe the following precautions to prevent minor burns or overheating:
• Do  not  cover  the  seat  with  a  blanket  or  cushion  when  using  the  seat
heater.
• Do not use seat heater more than necessary.
NOTICE
● Do not put heavy objects that have an uneven surface on the seat and do
not stick sharp objects (needles, nails, etc.) into the seat.
● To prevent battery discharge, do not use the functions when the engine is
not running. 

591
SIENNA_OM_OM08013U_(U)
8
When trouble arises
8-2. Steps to take in an emergency
If your vehicle overheats
●The  needle  of  the  engine  coolant  temperature  gauge  ( P.   8 8 )
enters the red zone or a loss of engine power is experienced. (For
example, the vehicle sp eed does not increase.)
● The  warning  message  indicating  overheats  is  shown  on  the  multi-
information display. ( P. 555)
● Steam is coming from under the hood.
Stop the vehicle in a safe place and turn off the air conditioning sys-
tem, and then stop the engine.
If you see steam:
Carefully lift the hood after the steam subsides.
If you do not see steam:
Carefully lift the hood.
After the engine has cooled down su fficiently, inspect the hoses and
radiator core (radiator) for any leaks.
Radiator
Cooling fans
If  a  large  amount  of  coolant
leaks,  immediately  contact  your
Toyota dealer.
The following may indicate that  your vehicle is overheating.
Correction procedures
1
2
3
1
2