
WHAT IS COVERED AND
HOW LONG
Basic Warranty
This warranty covers repairs and
adjustments needed to correct defects
in materials or workmanship of any
part supplied by Scion, subject to the
exceptions indicated under “What Is
Not Covered” on pages 14-15.
Coverage is for 36 months or
36,000 miles, whichever occurs first,
with the exception of wheel alignment
and wheel balancing, which are
covered for 12 months or 12,000 miles,
whichever occurs first.
Powertrain Warranty
This warranty covers repairs needed to
correct defects in materials or
workmanship of any component listed
in the next two columns and supplied
by Scion, subject to the exceptions
indicated under “What Is Not Covered”
on pages 14-15.
Coverage is for 60 months or
60,000 miles, whichever occurs first.
Engine
Cylinder block and head and all
internal parts, timing gears and
gaskets, timing chain/belt and cover,
flywheel, valve covers, oil pan, oil
pump, engine mounts, turbocharger
housing and all internal parts, super
charger housing and all internal parts,
engine control computer, water pump,
fuel pump, seals and gaskets.Transmission and Transaxle
Case and all internal parts, torque
converter, clutch cover, transmission
mounts, transfer case and all internal
parts, engine control computer, seals
and gaskets.
Front-Wheel-Drive System
Final drive housing and all internal
parts, axle shafts, drive shafts,
constant velocity joints, front hub and
bearings, seals and gaskets.
Rear-Wheel-Drive System
Axle housing and all internal parts,
propeller shafts, U-joints, axle shafts,
drive shafts, bearings, supports, seals
and gaskets.
Corrosion Perforation
Warranty
This warranty covers repair or
replacement of any original body panel
that develops perforation from
corrosion (rust-through), subject to the
exceptions indicated under “What Is
Not Covered” on pages 14-15.
Coverage is for 60 months, regardless
of mileage.
For information on how to protect your
vehicle from corrosion, refer to
sections related to maintenance and
care in the
Owner’s Manual.
NEW VEHICLE LIMITED WARRANTY
WARRANTY
Your Warranties in Detail
13

22,500 miles or 18 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace engine oil and oil filter1
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICE VERIFICATION:
D ATE:
MILEAGE:
30,000 miles or 24 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace cabin air filterReplace engine air filterReplace engine oil and oil filter1
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and brake
pads/discs2
Drive beltsDrive shaft bootsEngine coolant3
Exhaust pipes and mountingsFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gear boxSteering linkage and bootsTransmission fluid or oil
DEALER SERVICE VERIFICATION:
D ATE:
MILEAGE:
1Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or
equivalent.
2Inspect thickness measurement and disc runout.3Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this
guide for more information. MAINTENANCE LOG
MAINTENANCE
Maintenance Log
37

52,500 miles or 42 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace engine oil and oil filter1
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICE VERIFICATION:
D ATE:
MILEAGE:
60,000 miles or 48 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace cabin air filterReplace engine air filterReplace engine oil and oil filter1
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and brake
pads/discs2
Drive beltsDrive shaft bootsEmission hoses and tubesEngine coolant3
Exhaust pipes and mountingsFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gear boxSteering linkage and bootsTransmission fluid or oil
DEALER SERVICE VERIFICATION:
D ATE:
MILEAGE:
1Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or
equivalent.
2Inspect thickness measurement and disc runout.3Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this
guide for more information. MAINTENANCE LOG
MAINTENANCE
Maintenance Log
39

82,500 miles or 66 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace engine oil and oil filter1
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICE VERIFICATION:
D ATE:
MILEAGE:
90,000 miles or 72 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace cabin air filterReplace engine air filterReplace engine oil and oil filter1
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and brake
pads/discs2
Drive beltsDrive shaft bootsEngine coolant3
Exhaust pipes and mountingsFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gear boxSteering linkage and bootsTransmission fluid or oil
DEALER SERVICE VERIFICATION:
D ATE:
MILEAGE:
1Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or
equivalent.
2Inspect thickness measurement and disc runout.3Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this
guide for more information. MAINTENANCE LOG
MAINTENANCE
Maintenance Log
41

112,500 miles or 90 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace engine oil and oil filter1
Rotate tiresVisually inspect brake linings/drums
and brake pads/discs
DEALERSERVICE VERIFICATION:
D ATE:
MILEAGE:
120,000 miles or 96 months
Check installation of driver’s floor
mat
Inspect and adjust all fluid levelsInspect wiper bladesReplace cabin air filterReplace engine air filterReplace engine coolant2
Replace engine oil and oil filter1
Rotate tiresTighten nuts and bolts on body and
chassis
Inspect the following:Ball joints and dust coversBrake lines and hosesBrake linings/drums and brake
pads/discs3
Drive beltsDrive shaft bootsEmission hoses and tubesExhaust pipes and mountingsFuel lines and connections, fuel tank
band and fuel tank vapor vent system
hoses
Fuel tank cap gasketRadiator and condenserSteering gear boxSteering linkage and bootsTransmission fluid or oil
DEALER SERVICE VERIFICATION:
D ATE:
MILEAGE:
1Reset the scheduled maintenance indicator light. Use 0W-20 Genuine Toyota Motor Oil or
equivalent.
2NOTE: Initial replacement at 120,000 miles/120 months. Replace every 60,000 miles/60 months
thereafter. Refer to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back
of this guide for more information.
3Inspect thickness measurement and disc runout. MAINTENANCE LOG
MAINTENANCE
Maintenance Log
43

Nuts and Bolts on Chassis
and
Body
Re-tighten the seat-mounting bolts
and front/rear suspension member
retaining bolts to specified torque.
Radiator and Condenser
Inspect for debris, corrosion and signs
of damage. Have any problem repaired
immediately by a qualified technician.
Spark Plugs
Replace at specified intervals. Install
new plugs of the same type as
originally equipped. A qualified
technician should perform this
operation.
Steering Linkage and Boots
With the vehicle stopped, check for
excessive freeplay in the steering
wheel. Inspect the linkage for bending
and damage and the dust boots for
deterioration, cracks and damage.
Replace any damaged parts. A qualified
technician should perform these
operations.
Tire Rotation
Tires should be rotated according to the
instructions in the
Owner’s Manual.
When rotating tires, check for damage
and uneven wear. Replace if necessary.
Transmission Fluid or Oil
Inspect at specified intervals. When
performing inspections, check each
component for signs of leakage. If you
discover any leakage, have it repaired
by a qualified technician immediately.
Wiper Blades
The wiper blades should not show any
signs of cracking, splitting, wear,
contamination or deformation. The
wiper blades should clear the
windshield without streaking or
skipping.
EXPLANATION OF MAINTENANCE ITEMS Maintenance Log
46
MAINTENANCE