2016 TOYOTA GT86 oil dipstick

302
4-3. Do-it-yourself maintenance
FT86_EE
Engine compar tment
*: For right-hand drive vehicles: This is located on the opposite side of the
engine compartment.
Battery* (→P. 309)
Engine oil level dipstick
(→P. 303)
Engine oil filler cap
(→P. 304)
Washer fluid tank (→P. 313)Electric cooling fans
Condenser (if equipped)
(→P. 308)
Radiator (→P. 308)
Engine coolant reservoir
(→P. 306)
Fuse box (→P. 336)
86_OM_EE_OM18058E.book 302 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

303 4-3. Do-it-yourself maintenance
4
Maintenance and care
FT86_EE
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■Checking the engine oil
Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than five minutes for the oil to
drain back into the bottom of the engine.
Hold a rag under the end and
pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull the dipstick out and check
the oil level.
When checking the oil, look at both sides of the dipstick and use the
lower measurement to determine the level of oil.
Wipe the dipstick and reinsert it fully.
Low
Full
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
86_OM_EE_OM18058E.book 303 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

304 4-3. Do-it-yourself maintenance
FT86_EE■Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine.
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
Engine oil
selection→P. 438
Oil quantity
(Low → Full)1.0 L (1.1 qt., 0.9 Imp. qt.)
Items
Clean funnel
STEP 1
STEP 2
STEP 3
86_OM_EE_OM18058E.book 304 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

306 4-3. Do-it-yourself maintenance
FT86_EE
Engine coolant
The coolant level is satisfactory if it is between the “FULL” and “LOW”
lines on the reservoir when the engine is cold.
Reservoir cap
“FULL”
“LOW”
If the level is on or below the
“LOW” line, add coolant up to the
“FULL” line.
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
●Avoid overfilling, or the engine could be damaged.
●Check the oil level on the dipstick every time you refill the vehicle.
●Be sure the engine oil filler cap is properly tightened.
■If the coolant level drops within a short time after replenishing
Visually check the radiator, hoses, engine coolant filler cap, radiator cap,
drain cock and water pump.
If you cannot find a leak, have any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional pressure test the cap and
check for leaks in the cooling system.
86_OM_EE_OM18058E.book 306 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

438 6-1. Specifications
FT86_EE
Lubrication system
*: The engine oil capacity is a reference quantity to be used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
0W-20 and 5W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving”, SN
“Resource-Conserving” or ILSAC multigrade engine oil
Oil capacity
(Drain and refill 
reference*)
Without filter
With filter 5.2 L (5.5 qt., 4.6 Imp. qt.)
5.4 L (5.7 qt., 4.8 Imp. qt.)
86_OM_EE_OM18058E.book 438 ページ ２０１５年３月１７日　火曜日　午前１１時３１分