13
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press the switch 1 to fully open
the moonroof. Press the switch
2 to close the moonroof. To stop the moonroof
in a midway position while opening or closing, momentarily press the switch to
the
1 side or 2 side.
(EYESIGHT EQUIPPED VEHICLES ONLY)
1
2
Personalize
1980916_16a_Subaru_Forester_QRG_061015.indd 136/10/15 11:00 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
15
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob
downward to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a reduced brightness
high beam will be automatically turned on when the engine has started, the
parking brake is fully released and the light switch is in the “OFF” or “
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
1980916_16a_Subaru_Forester_QRG_061015.indd 156/10/15 11:00 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
