2016 SUBARU FORESTER light

21
Controls
Cruise Control
Increase Speed
Push up the “RES/SET” switch to the
“RES” side; hold until your vehicle
reaches the desired speed and release.
To increase speed using the accelerator
pedal, press the pedal until you reach
the desired speed. Push down the
“RES/SET” switch to the “SET” side
to set the speed. Decrease Speed
Push down the “RES/SET” switch to
the “SET” side; hold until your vehicle
slows to the desired speed and release.
To decrease the speed using the brake
pedal, press the pedal to release
cruise control temporarily. When the
speed decreases to the desired speed,
push down the “RES/SET” switch to
the “SET” side to set the speed.
To activate the cruise control, press
the “
” button. The indicator light
on the instrument panel will turn
on. To deactivate cruise control,
press the “
” button again.
Press the accelerator pedal
until your vehicle reaches
the desired speed. Push
the switch to the “SET”
side and release. Ease
off the accelerator pedal.
Your vehicle will maintain
the desired speed.
To cancel the cruise
control, push the brake
pedal or press the
“CANCEL” button.
If you have a manual
transmission, you can
push in the clutch pedal. To resume your
speed after canceling,
push the switch to
the “RES” side.
SI-DRIVE

(if equipped):
Press S#/I for
Sport Sharp mode,
S/I for Sport mode,
or either button for
Intelligent mode.
1980916_16a_Subaru_Forester_QRG_061015.indd 216/10/15 11:00 AM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

23
1
Automatic Transmission Shift Mode
The automatic transmission gives you ultimate control with two different driving
modes: Normal Mode and Manual Mode.
Normal Mode
When the selector lever is in the “D” (Drive) position, the tran\
smission is in
Normal shift mode. The shift position indicator on the instrument panel \
shows
“D”, and the transmission automatically shifts into a suitable for\
ward gear.
Manual Mode
In Manual Mode, you select the desired gear position to obtain necessary
acceleration and engine braking. Moving the selector lever left into the\
manual
gate
1 from the “D” (Drive) position causes the transmission to change in\
to
Manual Mode. To shift, use the paddle shift control switches. The shift position
indicator shows the selected gear position.
When Manual Shifting Operation is Possible
• Arrow-shaped lights in the center of the instrument panel show whether an
upshift is possible and whether a downshift is possible.
• Both arrows are on: Upshifting and downshifting are both possible.
• Up arrow only is on: Only upshifting is possible.
• Down arrow only is on: Only downshifting is possible.
While
Operating
1980916_16a_Subaru_Forester_QRG_061015.indd 236/10/15 11:00 AM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

26
Additional Information
Fuel
• 2.5 liter DOHC Non-turbo models use regular unleaded gasoline with an octane rating of
87 AKI or higher. Consult the Owner’s Manual for more detailed information.
• 2.0 liter DOHC Turbo model’s engine is designed to operate at maximum performance
using unleaded gasoline with an octane rating of 93 AKI or higher. If 93 AKI fuel is
not readily available, unleaded gasoline with an octane rating of 91 AKI or h\
igher may
be temporarily used. However, you may notice a slight decrease in maximum engine
performance while using 91 AKI fuel.
Regular unleaded gasoline with an octane rating of 87 AKI or higher may \
also be
used. Using regular unleaded gasoline will not be detrimental to engine durability, nor
will it affect your warranty coverage. However, depending on your driving habits and
conditions, you may notice a decrease in maximum engine performance, fuel economy
or slight engine vibration or knocking. It is not recommended to use 87 AKI when towing.
Consult the Owner’s Manual for more detailed information.
Fuel Capacity
• 15.9 US gal (60 liters, 13.2 lmp gal)
• When the low fuel indicator light is displayed on the instrument panel, \
approximately
2.6 US gallons of fuel remain.
• If you have recently fueled your vehicle, the Check Engine light on the instrument pa\
nel
may stay on due to a missing or loose fuel filler cap (the cap should\
be tightened until a
click is heard).
1980916_16a_Subaru_Forester_QRG_061015.indd 266/10/15 11:00 AM

Steering Wheel & Instrument Panel
Master and Valet Keys, Keyless Access System
operation, Push Button Start* and Remote Start*
Tilt/Telescopic Steering Column Adjustments
and Paddle Shift operation*
Front & Rear* Wiper and Washer Controls
Headlights, DRL, Parking Lights, Hazard Lights,
Interior Lights, and Fog Lights*
Gauges, Warning Lights, Multi Function Display*
settings and Parking Brake operation
Safety, Comfort & Convenience
All Wheel Drive System, Emergency towing of AWD,
VDC, X-Mode* and Hill Holder* operation
Rear Vision Camera*
All Weather Package operation - Heated Seats,
Exterior Mirrors & Windshield Wiper De-icer
Review operation of climate control system
Power windows, locks, exterior mirrors, seat
and Power Moonroof* operation
Hood Release and fluid reservoir locations
Fuel Filler Door, Trunk Release, Rear Gate operation
and location of Spare Tire*, Jack & Tools
STARLINK Audio System & Bluetooth
Bluetooth - Pair owner’s phone(s) & show operation
(Download SUBARU STARLINK and MySubaru Apps*)
STARLINK Audio* and Navigation* system controls
(Sources, Presets, List & Back buttons)
Driver Assist Technology
Subaru EyeSight™ System* and SRF*
Blind Spot Detection* and Rear Cross Traffic Alert*
*If Applicable
Owner Signature(s) ________________________________________________________________
Subaru Sales Consultant ___________________________________________________________
Subaru Sales Manager _____________________________________________________________
1980916_16a_Subaru_Forester_QRG_061015.indd 306/10/15 11:00 AM