2016 SUBARU FORESTER spare tire

2
About EyeSight
EyeSight is a driving support system that uses a range of functions to assist the driver in
making decisions in order to provide for more safe and comfortable driving and to reduce
driver fatigue. EyeSight makes use of original stereo cameras designed by SUBARU. Two
CCD (Charge Coupled Device) cameras are used to process stereo images and identify the
vehicle in front, obstacles, traffic lanes and other items.
EyeSight
WARNING
Drivers are responsible for driving safely. Strive for safe driving at all
times. Always maintain a safe following distance behind the vehicle in
front of you, pay attention to your surroundings and the driving condi-
tions, operate the brake pedal and take other action as necessary in
order to maintain a safe following distance.
Never attempt to drive relying on EyeSight alone.
EyeSight is intended to assist the driver in making decisions in order to
reduce the chance of accidents or damage and lessen the burden on the
driver.
When a warning is activated, pay attention to what is in front of you and
to your surroundings, operate the brake pedal and take other action as
necessary.
This system is not designed to support driving in poor visibility or in
extreme weather conditions, or to protect against careless driving
when the driver is not paying complete attention to the road ahead. It
also cannot prevent collisions from occurring in all driving conditions.
There are limits to the EyeSight recognition performance and control per-
formance. Be sure to read the instructions concerning Adaptive Cruise
Control, the Pre-Collision Braking System, Pre-Collision Throttle
Management and Conventional Cruise Control before using them and be
sure to use them correctly. We are not liable for accidents or other prob-
lems resulting from failure to follow the instructions in this manual.
The EyeSight system in your vehicle is designed for use in countries in
which traffic operates on the right-hand side of the road. EyeSight for
LHD vehicles such as yours is not designed for use in countries in which
vehicles are driven on the left-hand side of the road.
xThe system may not operate correctly under the conditions listed below. When
these conditions occur, turn off the Pre-Collision Braking System. Also, do not
use Adaptive Cruise Control and Conventional Cruise Control.
- The tire pressure is not correct.*
- The temporary spare tire is installed on any wheel.*
- Tires that are worn or have large variations in wear conditions are installed.*
- Tires other than those of the designated size are installed.*
- An emergency repair is performed using the flat tire repair kit.
- The suspension has been modified.
- Tire chains are installed.
- The headlights are dirty or the optical axes are not aligned correctly. (Objects
are not correctly illuminated and are difficult to detect.)
- Vehicle operation has become compromised due to an accident or malfunc-
tion.
- The brake warning light is illuminated.
- The vehicle is tilted due to a heavy cargo load.
- The maximum number of occupants and/or the gross vehicle weight rating is
exceeded.
*The wheels and tires have functions that are critically important. Be sure to
use the correct ones. For details, refer to the Owner’s Manual for your vehicle.
xThe system may not operate correctly when towing a trailer or another vehicle.
Do not use Adaptive Cruise Control in these situations.

Adaptive Cruise Control
21
Adaptive Cruise Control
Adaptive Cruise Control is a driving support system intended to allow more comfortable
driving on expressways, freeways and interstate highways. The vehicle in front in the same
traffic lane is detected by means of the stereo cameras, and your vehicle tracks the vehicle
in front (up to the maximum speed of the set vehicle speed) while automatically maintaining
a following distance that corresponds to the speed of the vehicle in front. Please remember
that you should not exceed posted speed limits. The vehicle is not equipped with a function
that helps maintain the vehicle’s standstill position without a driver’s operation.
Continued on next page Ÿ
WARNING
xThis system does not provide the driver with an automatic driving function
that handles all traffic conditions.
xDo not rely excessively on Adaptive Cruise Control. This system is not
intended to assist in driving when the driver is not paying full attention to
what is ahead of him/her due to distractions or a lack of concentration
while driving, or under conditions of poor visibility. It is not intended to pre-
vent rear-end collisions.
Strive for safe driving at all times. Always maintain a safe following dis-
tance behind the vehicle in front of you, pay attention to your surroundings
and the driving conditions, and operate the brake pedal and take other
action as necessary.
xSet the set vehicle speed within a range that is appropriate to the road con-
ditions and surrounding environment.
xThe system may not operate correctly under the conditions listed below.
When these conditions occur, do not use Adaptive Cruise Control.
- The tire pressure is not correct.*
- The temporary spare tire is installed on any wheel.*
- Tires that are worn or have large variations in wear conditions are
installed.*
- Tires other than those of the designated size are installed.*
- An emergency repair is performed using the flat tire repair kit.
- The suspension has been modified.
- Tire chains are installed.
- The headlights are dirty or the optical axes are not aligned correctly.
(Objects are not correctly illuminated and are difficult to detect.)
- Vehicle operation has become compromised due to an accident or mal-
function.
- The brake warning light is illuminated.
- The vehicle is tilted due to a heavy cargo load.
- The maximum number of occupants and/or the gross vehicle weight rat-
ing has been exceeded.
- When towing a trailer or another vehicle, etc.
*The wheels and tires have functions that are critically important. Be sure
to use the correct parts. For details, refer to the Owner’s Manual for your
vehicle.
xAdaptive Cruise Control is designed for use on expressways, freeways, toll
roads, interstate highways and similar limited access roads. It is not
intended to be used in city traffic. In the following conditions, do not use
Adaptive Cruise Control. Doing so may result in an accident.
- Ordinary roads (roads other than those mentioned above)
Depending on the driving environment (complexity of roads and other
factors), the system may not be able to perform as the traffic conditions
require, and that may result in an accident.
- Roads with sharp curves or winding roads
- Frozen roads, snow-covered roads or other slippery road surfaces
The tires may spin, causing loss of control of the vehicle.

Adaptive Cruise Control
26
ŸContinued from previous page
xEven when the following distance is short, the “brake more” warning may
not activate in the following cases.
- When the speed difference compared to the vehicle in front is small (the
two vehicles are travelling at almost the same speed)
- When the vehicle in front is traveling faster than your vehicle (the follow-
ing distance is gradually increasing)
- When another vehicle cuts into your lane very close to your vehicle
- When the vehicle in front decelerated suddenly
- When there are repeated uphill and downhill grades
CAUTION
xAfter Adaptive Cruise Control has started, it maintains control continuously
according to the behavior of the vehicle in front. When your vehicle comes
to a stop because the vehicle in front has stopped, the automatic braking
function will be cancelled immediately after stopping and the vehicle will
start creeping forward gradually (at the same time three short beeps and a
single long beep will sound). Be sure to depress the brake pedal and stop
the vehicle completely.
Note that the vehicle is not maintained at a standstill position and will not
automatically start moving from a standstill position.
xBraking may not be sufficient depending on the following conditions. Oper-
ate the brake pedal and decelerate as necessary.
- Vehicle conditions (amount of load, number of occupants, etc.)
- Road conditions (grade, slipperiness, shape, bumps, etc.)
- Vehicle maintenance status (brake systems, tire wear, air pressure, tem-
porary spare tire is being used, etc.)
- When the brakes are cold. (For example, just after the engine is started
or when the outside temperature is low.)
- For a short period of time when driving after the engine is started until the
engine has warmed-up
- When the brakes are overheated on downhill grades (braking effective-
ness may be reduced)
- When driving in rain or after washing the vehicle (the brakes may
become wet and braking effectiveness may be reduced)
- When the speed to potential obstacles is more than 20 MPH (30 km/h)

Pre-Collision Braking System
44
ŸContinued from previous page
- Even if the obstacle is a motorcycle, bicycle or pedestrian, depending on
the brightness of the surroundings as well as the relative movement, and
aspect or angle of the object, there may be cases when the system can-
not detect it.
- When the system determines that operation by the driver (based on
accelerator pedal operation, braking, steering wheel angle, etc.) is
intended as evasive action
- Vehicle maintenance status (brake systems, tire wear, tire pressure,
whether a temporary spare tire is being used, etc.)
- When towing a trailer or vehicle, etc.
- When the brakes are cold due to outside temperature being low or just
after starting the engine.
- When the brakes are overheated on downhill grades (braking effective-
ness is reduced)
- When driving in rain or after washing the vehicle (the brakes are wet and
braking effectiveness is reduced)
- Recognition conditions of the stereo cameras
In particular, the function may be unable to stop the vehicle or may not
activate in the following cases.
• Bad weather (for example heavy rain, a blizzard or thick fog)
• When visibility is poor due to sand, smoke or water vapor in the air or
when the vehicle in front or oncoming traffic causes water, snow, dirt,
dust or other substances to obscure the view through the windshield
• When driving at night or in a tunnel without the headlights on
• When driving at night or in a tunnel when there is a vehicle in front that
does not have its taillights on
• When approaching a motorcycle, bicycle or pedestrian at night
• When ambient light is poor in the evening or early morning
• When a vehicle, motorcycle, bicycle or pedestrian is outside the area
illuminated by the headlights
• When affected by strong light from the front (for example, sunlight at
dawn, sunset or headlight high beams, etc.)
• When there is snow, frost, dirt or dust on the windshield or it is clouded
• When fluid has not been fully wiped off the windshield during or after
washer use
• When the target cannot be correctly recognized because the stereo
cameras’ view is obstructed by water droplets from rain or the window
washer, or by the wiper blades.
• When the stereo cameras’ field of view is obstructed (for example by a
canoe on the roof of the vehicle)
• When the rear aspect of
the vehicle in front is
low, small or irregular
(the system may recog-
nize another part of the
vehicle as its rear and
will determine operation
from that)
- When there is an
empty truck or trailer
with no rear and/or
side panels on the
cargo bed
- With vehicles that
have cargo protruding
from their back ends
- With non-standard
shaped vehicles (vehicle transporters or vehicles with a sidecar
fitted, etc.)
- When the height of the vehicle is low, etc.
S01928

Pre-Collision Braking System
45
• When there is a wall, etc. in front of a stopped vehicle
• When there is another object near the vehicle
• When a vehicle, etc. is stopped in the lateral direction
• With vehicles that are backing up or with oncoming vehicles, etc.
• When the size and height of an obstacle is smaller than the limitations
of the stereo cameras’ recognition capability
- With small animals or children, etc.
- With pedestrians who are sitting or lying down
• When the detected
object is a fence, wall or
shutter, etc.
• When there is a wall or
door made of glass or a
mirror in front
• When the vehicle in front
suddenly swerves,
accelerates, or deceler-
ates.
• When a vehicle, motor-
cycle, bicycle or pedes-
trian cuts in from the
side or jumps out sud-
denly
• When you suddenly
change lanes and your
vehicle is immediately
behind an obstacle
• When there is a vehicle, motorbike, bicycle or pedestrian in a location
extremely close to your vehicle
• When the speed difference between your vehicle and an obstacle is 4
MPH (5 km/h) or less (As braking is performed once the obstacle is in
close proximity to your vehicle, depending on the shape and size of the
obstacle, there may be some cases when the obstacle is outside the
range of the cameras’ field of vision.)
• When driving on sharp curves, steep uphill grades or steep downhill
grades
• When driving on a bumpy or unpaved road
• When passing through the entrance or exit of a tunnel
lxFor your safety, do not test the Pre-Collision Braking System function by
yourself. There is a possibility that the vehicle will not stop or the function
will not work during the test and this may cause an unexpected accident.
xThe system may not operate correctly under the conditions listed below.
When these conditions occur, turn off the Pre-Collision Braking System.
- The tire pressure is not correct.*
- A temporary spare tire is installed.*
- Tires that are worn or have large variations in wear conditions.*
- Tires other than those of the designated size are installed.*
- Flat tires are repaired using the flat tire repair kit.
- The suspension has been modified.
- Tire chains are installed.
- The headlights are dirty or are not aligned correctly. (Objects are not cor-
rectly illuminated and are difficult to detect.)
- Vehicle operation has become compromised due to an accident or mal-
function.
- The brake warning light is illuminated.
- The vehicle is tilted due to a heavy cargo load.
- The maximum number of occupants and/or the gross vehicle weight rat-
ing has been exceeded.
*The wheels and tires have functions that are critically important. Be sure
to use the correct parts. For details, refer to the Owner’s Manual for your
vehicle.
S00653