2016 SUBARU CROSSTREK navigation

TIPS FOR THE NAVIGATION SYSTEM
244
TIPS FOR THE NAVIGATION SYSTEM
GPS (GLOBAL POSITIONING
SYSTEM)
REGARDING ERRORS IN CURRENT
POSITION DISPLAY
The system displays the vehicle current position based on
GPS information and data from various sensors and road
maps. However, when the radiowave signals from GPS
satellites are weak or when signals are received from only
two satellites or less, errors may occur in the position.
Modifying or adjusting the system will not prevent these
errors.
LIMITATIONS OF THE NAVIGATION SYSTEM
This navigation system calculates the current position using
satellite signals, various vehicle signals, map data, etc.
However, an accurate position may not be shown depending
RQ VDWHOOLWH FRQGLWLRQV URDG FRQ

TIPS FOR THE NAVIGATION SYSTEM
245
NAVIGATION SYSTEM
8
CAUTION
OThe installation of window tinting may obstruct the GPS
signals. Most window tinting contains some metallic content
that will interfere with GPS signal reception of the antenna in
the instrument panel. We advise against the use of window
tinting on vehicles equipped with navigation systems.

” Accurate current position may not be shown in the
following cases:
‡When driving on a small angled Y-shaped road.
‡ When driving on a winding road.
‡ When driving on a slippery road such as in sand,
gravel, snow, etc.
‡ When driving on a long straight road.
‡ When freeway and surface streets run in parallel.
‡ After moving by ferry or vehicle carrier.
‡ When a long route is searched during high speed
driving.
‡ After repeating a change of direction by going
forward and backward, or turning on a turntable in
a parking lot.
‡ When leaving a covered parking lot or parking
garage.
‡ When a roof carrier is installed.
‡ When driving with tire chains installed. ‡
When the tires are worn.
‡ After replacing a tire or tires.
‡ When using tires that are smaller or larger than the
IDFWRU\VSHFL¿FDWLRQV
‡ When the tire pressure in any of the 4 tires is not
correct.

” Inappropriate route guidance may occur in the
following cases:
‡When turning at an intersection off the designated
route guidance.
‡ If you set more than 1 destination but skip any of
them, auto reroute will display a route returning to
the destination on the previous route.
‡ When turning at an intersection for which there is
no route guidance.
‡ When passing through an intersection for which
there is no route guidance.
‡ During auto reroute, the route guidance may not be
available for the next turn to the right or left.
‡ During high speed driving, it may take a long time
for auto reroute to operate. In auto reroute, a detour
route may be shown.
‡ After auto reroute, the route may not be changed.
‡ If an unnecessary U-turn is shown or announced.

TIPS FOR THE NAVIGATION SYSTEM
246‡
If a location has multiple names and the system
announces 1 or more of them.
‡ When a route cannot be searched.
‡ If the route to your destination includes gravel,
unpaved roads or alleys, the route guidance may
not be shown.
‡ Your destination point might be shown on the
opposite side of the street.
‡ When a portion of the route has regulations
prohibiting the entry of the vehicle that vary by time
or season or other reasons.
‡ The road and map data stored in the navigation
system may not be complete or may not be the
latest version.
NOTE
O This navigation system uses tire turning data and is designed to
ZRUN ZLWK IDFWRU\VSHFL

VOICE RECOGNITION SYSTEM OPERATION
251
Siri/VOICE RECOGNITION SYSTEM
9
VOICE RECOGNITION SYSTEM OPERATION
VOICE RECOGNITION SYSTEM
The voice recognition system enables the navigation,
audio, hands-free systems, etc. to be operated using voice
commands.
Refer to the command list for samples of voice commands.

:3
USING THE VOICE RECOGNITION SYSTEM
STEERING SWITCH
XTy p e A
XTy p e B
Talk switch

” Press the talk switch to start the voice recognition
system.

” To cancel voice recognition, press and hold the talk
switch or the source switch.
MICROPHONE
The microphone is built into the map light slits.

”It is unnecessary to speak directly into the
microphone when giving a command.
NOTE
O :DLWIRUWKHFRQ

VOICE RECOGNITION SYSTEM OPERATION
253
Siri/VOICE RECOGNITION SYSTEM
9

”With navigation function:
To use the voice recognition system for navigation
function, say the command to change to the
QDYLJDWLRQIXQFWLRQ

VOICE RECOGNITION SYSTEM OPERATION
256
EXPRESSION EXAMPLES FOR EACH FUNCTION
CommandExpression examples
Call by specifying
contact Phone the number of
.
Ring
’s
number.
Call by specifying
phone number Phone
.
Search artists to
listen to song Put on the artist
.
Listen to the singer .
Search album names
to listen to song Listen to album
.
Play me the album .
Use navigation
function* Go to GPS
.
Go to address entry .
*: With navigation function

COMMAND LIST
258 XCommands for changing the audio mode
Voice command PhraseFunction
AM mode
change play AM, select AM Switch to AM
mode
FM mode change play FM, select FM Switch to FM
mode
SiriusXM radio
mode change play XM, select XM Switch to SiriusXM
mode
CD mode change play CD, select CD Switch to CD
mode
USB mode
change play USB, select USB Switch to USB
mode
SD mode
change* play microSD, select
microSD Switch to SD
mode
iPod mode
change play iPod, select iPod Switch to iPod
mode
AUX mode
change select AUX Switch to AUX
mode
Audio off mode
change audio off, turn off audio Turn off the Audio
Audio on mode
change audio on, turn on audio Turn on the Audio
*: With navigation function
X
Commands for changing the mode
Voice command PhraseFunction
Hands-free mode
change [go to] phone, phone
screen, phone menu
Switch to HF mode
Audio mode
change go to audio Switch to audio
mode
aha mode
change go to aha Switch to aha
mode
Pandora*
1 mode
change go to Pandora Switch to Pandora
mode
Navigation mode
change*
2
navigation,
go to navigation,
go to NAV system Switch to the voice
command on NAV
system
*1: Pandora is available in the United States, Australia, and New Zealand.
*2: With navigation function

COMMAND LIST
260
Voice commandPhraseFunction
Dislike on/off dislike/unselect dislike,
thumbs down/unselect
thumbs down 0DUN³'LVOLNH´ÀDJ
Unmark it
Go* go there, route,
guidance, take me
there When station
has location
information, user
can say “go” to
navigation.
Map check in, mark location Location
information
obtained from
GPS updated to
server
Call call, dial it Making a call from
a content (with
phone info)
Refresh refresh, reload screen Refresh the
selected station
to get the latest
information
*: With navigation function
X
Commands for AM control
Voice command PhraseFunction
Direct frequency
tuning tune to AM
Designate the
frequency to
VZLWFKWRDVSHFL¿F
radio station
Preset number
tuning tune to preset
Select a preset
channel to switch
WRDVSHFL¿FUDGLR
station
X
Commands for FM control
Voice command PhraseFunction
Direct frequency
tuning tune to FM
Designate the
frequency to
VZLWFKWRDVSHFL¿F
radio station
Preset number
tuning tune to preset
Designate the
preset channel to
VZLWFKWRVSHFL¿F
radio station