2016 SUBARU BRZ hood release

11
Headlight switch
Turn signal lever
Fog light switch

P. 202
P. 184
P. 208
Gauges and meters
Multi-information display P. 187
P. 197
Clock P. 267
Windshield wiper and washer switch P. 209
Hazard warning
flasher switch
P. 358
Tilt and telescopic steering
lock release lever
P. 65
Floor mat
P. 273
Engine hood lock release lever P. 296
Fuel filler lid opener P. 74
Push-button ignition switch (vehicles with a keyless
access with push button start system)
P. 162
AUX port
USB port P. 256
P. 256
Pictorial indexInstrument panel

: If equipped

296
4-3. Do-it-yourself maintenance
Engine hood
Release the lock from the inside of the vehicle to open the engine
hood.
Pull the engine hood release
lever.
The engine hood will pop up
slightly.
Push the auxiliary catch lever
to the left and lift the engine
hood.
Hold the engine hood open by
inserting the supporting rod
into the slot.
STEP 1
STEP 2
STEP 3

408 5-2. Steps to take in an emergency
■Overheating
If you observe the following, your vehicle may be overheating.
●The engine coolant temperature gauge enters the red zone or a loss of
power is experienced.
●Steam is coming from under the engine hood.
WARNING
■To prevent an accident or injury when inspecting under the engine
hood of your vehicle
●If steam is seen coming from under the engine hood, do not open the
engine hood until the steam has subsided. The engine compartment may
be very hot, causing serious injury such as burns.
●Keep hands and clothing away from the fan and other belts while the
engine is running.
●Do not loosen the radiator cap while the engine and radiator are hot.
Serious injury, such as burns, may result from hot coolant and steam
released under pressure.
Add engine coolant if neces-
sary.
Water can be used in an emer-
gency if engine coolant is
unavailable. (oP. 420)
Have the vehicle checked at the nearest SUBARU dealer as soon
as possible.
STEP 5

488
GAS STATION INFORMATION
Auxiliary catch lever
P. 296Trunk lid opener
P. 4 5
Engine hood lock release lever
P. 296
Fuel filler lid
P. 7 4
Tire inflation pressure
P. 424Fuel filler lid opener
P. 7 4
Fuel tank capacity
(Reference)13.2 gal. (50 L, 11.0 Imp. gal.)
Fuel type Unleaded gasoline only P. 75, 417
Cold tire inflation
pressureFront:
35 psi (240 kPa, 2.4 kgf/cm
2 or bar)
Rear:
35 psi (240 kPa, 2.4 kgf/cm
2 or bar)
Spare:
60 psi (420 kPa, 4.2 kgf/cm
2 or bar)P. 4 2 4
Engine oil capacity
(Drain and refill 
reference)• Without filter
• With filterqt. (L, Imp. qt.)
5.5 (5.2, 4.6)5.7 (5.4, 4.8)P. 418
Engine oil typeSUBARU approved engine oil
Oil grade:
ILSAC multigrade engine oil
API classification SN with the words
“RESOURCE CONSERVING”
Recommended oil viscosity:
SAE 0W-20P. 418