2016 SKODA RAPID bulb

MPG diagram park assist odometer radiator wiper blades

Page 160 of 184

SKODA RAPID 2016 1.G Owners Manual Removing/inserting the taillightFig. 191
Remove light / pull out connector
Read and observe
and on page 154 first.
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel

Removing/inserting the taillightFig. 191
Remove light / pull out connector
Read and observe
and on page 154 first.
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel trims into opening
A
» Fig. 191 .
›
Remove the cover by pulling the hook in the direction of arrow
1
.
›
Unscrew the screws
B
with the key from the tool kit.
›
Grasp the lamp and carefully remove in the direction of arrow
2
.
›
Press the latch on the connector in the direction of arrow
3
.
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow
4
.
Fitting
›
Insert the connector into the light and lock it securely.
›
Insert the lamp with the pin
B
» Fig. 192 on page 158 into the recesses
C
» Fig. 191 in the body.
›
Carefully push the cover in » .
›
Screw the lamp into place and install the cover. The cover must engage se-
curely.
› Close the boot lid.
CAUTION
■
When installing the light, ensure that the cable bundle does not become
pinched between the body and the lamp – risk of damage to the electrical in-
stallation and risk of water ingress.■
If you are not sure whether the cable bundle has become pinched, we recom-
mend that you have the light connection checked by a specialist garage.
■
Ensure that the vehicle paintwork and the tail lamp are not damaged when
removing and installing the tail lamp.
Replacing the bulbs in the taillight assembly
Fig. 192
Outer part of the lamp/inner part of the lamp
Read and observe
and on page 154 first.
Outer part of the lamp
›
Turn the holder with the bulb
A
» Fig. 192 in the direction of the arrow
1
.
›
Remove the holders with the bulbs from the light housing in the direction of
the arrow
2
.
›
Reinsert the holder with the bulb into the light housing and turn in the oppo-
site direction of the arrow
1
to the stop.
Inner parts of the lamp
›
Unlock the bulb holder using the marked area with arrows » Fig. 192 and re-
move the bulb holder from the light.
›
Turn the respective light bulb counter-clockwise to the stop and remove it
from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder in the tail lamp assembly. 
158Do-it-yourself

Page 161 of 184

SKODA RAPID 2016 1.G Owners Manual The lamp holder must engage firmly.159Fuses and light bulbs

Page 173 of 184

SKODA RAPID 2016 1.G Owners Manual Gear changeGear recommendation38
Information on the selected gear38
Gear changing Gear stick
88
Genuine parts116
Glasses compartment71
GPS See Owner´s Manual -Infotainment
6
H
Handbrake
87
Warning li

Page 175 of 184

SKODA RAPID 2016 1.G Owners Manual R
Radio See Owner´s Manual - Infotainment
6
Raise vehicle142
Rear fog light56
Warning light32
Rear seats63
Rear view camera Function keys
99
Orientation lines99
Rear View Camera Operation
99
Rear vie

Page: < prev 1-8 9-16

headlamp brake rotor tire type power steering fluid fuel filter location snow chains