2016 RENAULT MASTER gearbox

5.7
TYRE INFLATION KIT (3/6)
To connect the compressor, open the
bonnet and connect black clamp 10
to earth 6 (refer to the information on
“Battery: troubleshooting” in Section 5).
Then connect red clamp 11 to termi-
nal 5.
Before starting the engine,
check that the handbrake is
applied and the gear lever
is in neutral or in position N
for sequential gearboxes.
With the engine running, press switch 7
to start inflating.
After a maximum of 15 minutes, stop in-
flating and read the pressure on pres-
sure gauge 9.
A pressure of at least 4.7 bar must be
reached.
Note: whilst the cylinder is emptying
(approximately 30 seconds), pressure
gauge 9 will briefly indicate a pressure
of up to 6 bar. Then the pressure drops.
1110
7
If the correct pressure cannot be
achieved, repair is impossible. Do
not drive the vehicle. Consult an ap-
proved dealer.
If the pressure is too high, press
button 8 to lower the pressure.
8
9
5
6
6
5

5.13
When removing dual wheels, unscrew
inflating extension piece 1.
Do not forget to reattach it when re-
fitting. Undo the wheel bolts by fitting the
wheel spanner
3 extended using the
hexagonal extension piece 2 (supplied
in the tool kit) and pressing down.
1
CHANGING A WHEEL: hydraulic jack (1/3)
Switch on the hazard warn-
ing lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or reverse, or N for se-
quential gearboxes).
Ask all the passengers to leave the
vehicle and keep them away from
traffic.
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
Anti-theft bolt
If you use anti-theft bolts, fit these
nearest the valve (otherwise it may
not be possible to fit the wheel trim).
2
3

5.16
CHANGING A WHEEL: jack (1/2)
2
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation ap-
plying to the country you are in.
Switch on the hazard war-
ning lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or reverse, or N for se-
quential gearboxes).
Ask all the passengers to leave the
vehicle and keep them away from
traffic.
To prevent any risk of injury
or damage to the vehi-
cle, raise the jack until the
wheel you are replacing is
a maximum of 3 centimetres off the
ground.
If necessary, remove the wheel trim.
Use the wheelbrace 2 to slacken off the
wheel bolts. Position it so as to be able
to push from above.Vehicle equipped with a jack with a
heightener
When changing a front wheel, use the
heightener 1 (figure A).
When changing a rear wheel, remove
the heightener 1 (figure B).
A
B
1

7.3
ALPHABETICAL INDEX (3/4)
coolant ................................................................\
........... 4.9
power-assisted steering pump ..................................... 4.10
lifting the vehicle changing a wheel .............................5.4, 5.13 → 5.15, 5.17
lighting: interior ...............................................................\
........... 3.16
lights: adjustment of headlight beam height ........................... 1.99
brake lights ....................................................... 5.25 – 5.26
daytime running lights ....................................... 5.21 – 5.22
dipped beam headlights .................. 1.95, 5.21 – 5.22, 5.25
direction indicators ............................................ 5.21 – 5.22
fog lights ............................................................. 1.98, 5.25
hazard warning ............................................................ 5.25
main beam headlights .............................. 1.96, 5.21 – 5.22
reversing lights ............................................................. 5.25
side lights ................................................. 1.95, 5.21 – 5.22
lights-on warning buzzer.................................................... 1.96
locking the doors .......................... 1.2 → 1.8, 1.11, 1.14 – 1.15
M
maintenance ............................................................\
.......... 2.12
maintenance: bodywork .......................................................... 4.14 – 4.15
interior trim ........................................................ 4.16 – 4.17
mechanical .......................................................6.10 → 6.15
mileage before service .....................................6.10 → 6.15
manufacturer’s plates .......................................................... 6.2
methods of restraint in addition to the front seat belts ..............
1.26 → 1.28
N
navigation system ..................................................... 1.92, 3.27
O
oil change ................................................................... 4.6 – 4.7 operating faults ......................................................5.42
→ 5.45
P
paintwork maintenance ..................................................... 4.14 – 4.15
reference ..............................................................\
.......... 6.2
parking distance control.......................................... 2.34 – 2.35
power-assisted steering..................................................... 1.91
puncture.................................... 5.2 → 5.10, 5.13 → 5.15, 5.17
R
radio fitting a radio ................................................................ 5.40
rear bench seat....................................................... 3.25 – 3.26
rear view camera .................................................... 2.36 – 2.37
rear view mirrors ................................................................ 1.71
remote control door locking batteries ..............................................................\
......... 5.35
remote control door locking unit ................................1.2 → 1.6
RENAULT ANTI-INTRUDER DEVICE (RAID) ................... 1.11
replacement parts ................................................................ 6.9
reverse gear selecting ..............................................................\
......... 2.14
running in ........................................................................\
..... 2.2
S
screen wash/wipe ................................................... 1.93 – 1.94
seat belt pretensioners front seat belt ...................................................1.26 → 1.28
seat belts ......................................................1.22 → 1.24, 1.29
see-me-home lighting ........................................................ 1.96
sequential gearbox ................................................2.41 → 2.46
service sheets........................................................6.10 → 6.15
signals and lights ...................................................1.95 → 1.99
speakers location ...............................................................\
......... 5.40