2016 Ram ProMaster City cylinder

WARNING!(Continued)
high brake temperatures, excessive lining wear, and
possible brake damage. You would not have your full
braking capacity in an emergency.
Brake Master Cylinder
The fluid in the master cylinder should be checked when
performing under hood services or immediately if the
“Brake Warning Light” is illuminated.
Be sure to clean the top of the master cylinder area before
removing the cap. If necessary, add fluid to bring the
fluid level up to the requirements described on the brake
fluid reservoir. With disc brakes, fluid level can be
expected to fall as the brake pads wear. Brake fluid level
should be checked when pads are replaced. However,
low fluid level may be caused by a leak and a checkup
may be needed. Use only manufacturer’s recommended brake fluid. Re-
fer to “Fluids, Lubricants, And Genuine Parts” in “Main-
taining Your Vehicle” for further information.
WARNING!
•
Use only manufacturer’s recommended brake
fluid. Refer to “Fluids, Lubricants, And Genuine
Parts” in “Maintaining Your Vehicle” for further
information. Using the wrong type of brake fluid
can severely damage your brake system and/or
impair its performance. The proper type of brake
fluid for your vehicle is also identified on the
original factory installed hydraulic master cylinder
reservoir.
• To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that has
been in a tightly closed container. Keep the master
(Continued)
7
MAINTAINING YOUR VEHICLE 373

WARNING!(Continued)
cylinder reservoir cap secured at all times. Brake
fluid in a open container absorbs moisture from the
air resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or pro-
longed braking, resulting in sudden brake failure.
This could result in a collision.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.
• Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in a collision.
Power Steering Fluid
Check the fluid level with the vehicle on flat ground and
engine cold. Fluid should be between MIN and MAX
references on the reservoir body.
The level may go over the MAX line when oil is hot.
If topping off is required, make sure the oil you use is
approved. Refer to “Fluids, Lubricants and Genuine
Parts” in the section for further information.
WARNING!
Because it is flammable, do not allow the power
steering fluid to come into contact with hot engine
parts
NOTE: Power steering fluid consumption is very low. If
you need to top off your fluid often and multiple times
have your system inspected by your authorized dealer.
374 MAINTAINING YOUR VEHICLE

Chassis
ComponentFluid, Lubricant, or Genuine Part
Automatic Transmission Use only MOPAR ZF 8&9 Speed ATF Automatic Transmission Fluid, or equivalent.
Failure to use the correct fluid may affect the function or performance of your
transmission.
Brake Master Cylinder We recommend you use MOPAR DOT 4.
Power Steering Reservoir Use Pentosin CHF 11S power steering fluid meeting FCA Material Standard MS-11655.
7
MAINTAINING YOUR VEHICLE 399

Once A Month Or Before A Long Trip:
•Check engine oil level.
• Check windshield washer fluid level.
• Check tire pressure and look for unusual wear or
damage. Rotate tires at the first sign of irregular wear,
even if it occurs before the oil indicator system turns
on.
• Check the fluid levels of the coolant reservoir and
brake master cylinder, fill as needed.
• Check function of all interior and exterior lights.
Required Maintenance Intervals
Refer to the maintenance schedules on the following
page for the required maintenance intervals.At Every Oil Change Interval As Indicated By Oil Change Indicator System:
•Change oil and filter
• Rotate the tires. Rotate at the first sign of irregu-
lar wear, even if it occurs before the oil indicator
system turns on.
• Inspect battery and clean and tighten terminals as
required
• Inspect brake pads, shoes, rotors, drums, hoses,
lines and park brake
• Inspect engine cooling system protection and
hoses
• Inspect exhaust system
• Inspect engine air cleaner if using in dusty or
off-road conditions 8
MAINTENANCE SCHEDULES 403

Fluid Change......................... .376
Fluid Level Check ...................375, 376
Fluid Type ........................ .375, 399
Special Additives ...................... .375
Auto Up Power Windows ....................27
Auxiliary Electrical Outlet (Power Outlet) ........130
Axle Lubrication ......................... .399
Battery ............................ .156, 359
Charging System Light ...................156
Keyless Transmitter Replacement (RKE) ........19
Belts, Seat ...............................88
Body Builders Guide ........................6
Body Mechanism Lubrication .................361
B-Pillar Location ......................... .260
Brake Assist System ...................... .246
Brake Fluid ............................ .399
Brake, Parking .......................... .241
Brake System ........................ .244, 372Anti-Lock (ABS)
....................... .244
Fluid Check ....................... .373, 399
Master Cylinder ....................... .373
Parking ............................. .241
Warning Light ........................ .159
Brake/Transmission Interlock .................228
Bulb Replacement ..................... .392, 393
Bulbs, Light .......................... .90, 392
Camera, Rear ........................... .128
Capacities, Fluid ......................... .396
Caps, Filler Fuel ................................ .289
Oil (Engine) ....................... .349, 357
Power Steering ........................ .240
Radiator (Coolant Pressure) ................370
Carbon Monoxide Warning ................87, 288
Cargo Tie-Downs ........................ .136
Car Washes ............................ .377
10
INDEX 421

Door.................................21
Lubrication, Body ........................ .361
Lug Nuts .............................. .312
Maintenance Free Battery ....................359
Maintenance Procedures ....................354
Maintenance Schedule ..................... .402
Malfunction Indicator Light (Check Engine) . . .168, 352
Manual, Service ......................... .414
Master Cylinder (Brakes) ....................373
Methanol .............................. .285
Mirrors .................................94
Electric Powered .........................96
Electric Remote .........................96
Exterior Folding .........................95
Outside ...............................94
Rearview ..............................94
Modifications/Alterations, Vehicle ...............7
Monitor, Tire Pressure System ................279MOPAR Parts
........................ .353, 413
MTBE/ETBE ........................... .285
Multi-Function Control Lever .................111
New Vehicle Break-In Period ..................85
Occupant Restraints ........................32
Octane Rating, Gasoline (Fuel) .............284, 397
Oil Change Indicator ...................... .186
Oil Change Indicator, Reset ..................186
Oil, Engine ......................... .355, 397
Capacity ............................ .396
Change Interval ....................... .356
Checking ............................ .355
Dipstick ............................. .355
Disposal ............................. .358
Filter ............................ .358, 397
Filter Disposal ........................ .358
Identification Logo ..................... .356
428 INDEX