NOTE: There are access covers over both headlamp bulb
access holes in the quad front lamp unit housing (if
equipped). These covers MUST be reinstalled after the
bulb has been replaced.
Fog Lamps — If Equipped
1. Reach under and behind the front bumper to access
the back of the front fog lamp housing.
2. Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
3. Rotate the bulb counterclockwise ¼ turn to unlock the
bulb from the housing.
4. Pull the bulb straight out from the housing. CAUTION!Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
7MAINTAINING YOUR VEHICLE 621
Traction ............................... .434
Traction Control ......................... .449
Trailer Sway Control (TSC) ................. .455
Trailer Towing .......................... .507
Cooling System Tips .................... .524
Hitches ............................. .512
Minimum Requirements ................. .514
Mirrors ............................. .141
Trailer And Tongue Weight ............... .513
Wiring .............................. .522
Trailer Towing Guide ...................... .513
Trailer Weight ........................... .513
Transfer Case ........................... .596
Electronically Shifted .................... .427
Fluid ............................... .629
Transmission ........................... .596
Automatic ........................ .408, 596
Fluid ............................... .629
Shifting ............................. .405 Transmitter Battery Service (Remote Keyless Entry) . .30
Transmitter Programming (Remote Keyless Entry) . . .25
Transmitter, Remote Keyless Entry (RKE) .........25
Transporting Pets .........................114
Tread Wear Indicators ..................... .480
Turn Signals ..................... .173, 265, 619
Uconnect
Customer Programmable Features ....... .323, 341
Operation ............................ .346
Uconnect Settings ...................... .312
Uconnect Settings ................... .323, 341
Uconnect 8.4A/8.4AN Voice Recognition
Additional Information .................. .396
Do Not Disturb ....................... .394
Siri Eyes Free ......................... .394
Uconnect 8.4 Settings
Customer Programmable Features — Units .... .33210 INDEX 669
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
