2016 Ram 3500 Chassis Cab radio

•Six TPM sensors (Dual Rear Wheel [DRW] applica-
tions)
• Pressure display in the Electronic Vehicle Information
Center (EVIC)/Driver Information Display (DID)
The TPIS system will display all four (Single Rear Wheel
[SRW] applications) or six (Dual Rear Wheel [DRW]
applications) tire pressure values EVIC/DID display.
If a system fault is detected, the EVIC/DID will display a
SERVICE TPM SYSTEM message for a minimum of five
seconds and then display dashes (- -) in place of the
pressure value to indicate which sensor is not being
received.
If the ignition switch is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the SERVICE TPM SYSTEM message
will no longer be displayed, and a pressure value will
display in place of the dashes. A system fault can occur
due to any of the following: •
Signal interference due to electronic devices or driving
next to facilities emitting the same radio frequencies as
the TPM sensors.
• Installing aftermarket window tinting that contains
materials that may block radio wave signals.
• Accumulation of snow or ice around the wheels or
wheel housings.
• Using tire chains on the vehicle.
• Using wheels/tires not equipped with TPM sensors.
General Information
This device complies with Part 15 of the FCC rules and
RSS-210 of Industry Canada. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
5
STARTING AND OPERATING 493

HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on the
upper switch bank just below the radio.Push the switch to turn on the Hazard Warning
flasher. When the switch is activated, all direc-
tional turn signals will flash on and off to warn oncoming
traffic of an emergency. Push the switch a second time to
turn off the Hazard Warning flashers.
This is an emergency warning system and it should not
be used when the vehicle is in motion. Use it when your
vehicle is disabled and it is creating a safety hazard for
other motorists.
When you must leave the vehicle to seek assistance, the
Hazard Warning flashers will continue to operate even
though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers
may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate action.
• On the highways — slow down.
• In city traffic — while stopped, place the transmission
in NEUTRAL, but do not increase the engine idle
speed while maintaining the motion of the vehicle
with the brakes.
NOTE: There are steps that you can take to slow down
an impending overheat condition:
• If your air conditioner (A/C) is on, turn it off. The A/C
system adds heat to the engine cooling system and
turning the A/C off can help remove this heat.
• You can also turn the temperature control to maximum
heat, the mode control to floor and the blower control
to high. This allows the heater core to act as a
supplement to the radiator and aids in removing heat
from the engine cooling system.
532 WHAT TO DO IN EMERGENCIES

WARNING!
•Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is ON. You can be injured by
moving fan blades.
• Remove any metal jewelry such as rings, watch
bands and bracelets that could make an inadvertent
electrical contact. You could be seriously injured.
• Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
1. Set the parking brake, shift the automatic transmission into PARK and turn the ignition to LOCK.
2. Turn off the heater, radio, and all unnecessary electri- cal accessories.
Correct Positive Jumping Location (Diesel Model
Shown)
546 WHAT TO DO IN EMERGENCIES

Cleaning Headlights
Your vehicle is equipped with plastic headlights and fog
lights that are lighter and less susceptible to stone break-
age than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution fol-
lowed by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MOPAR Glass Cleaner, or any commercial
household-type glass cleaner. Never use an abrasive typecleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or windows
equipped with radio antennas. Do not use scrapers or
other sharp instrument that may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or cloth that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft cloth. A mild soap solution may
be used, but do not use high alcohol content or
abrasive cleaners. If soap is used, wipe clean with a
clean damp cloth.
2. Dry with a soft cloth.
602 MAINTAINING YOUR VEHICLE

Power SeatsDown ........................... .140, 141
Forward ......................... .140, 141
Rearward ........................ .140, 141
Recline .............................. .140
Tilt ................................ .141
Up ............................. .140, 141
Power Steering Fluid ...................... .624
Pregnant Women And Seat Belts ...............63
Pretensioners Seat Belts ..............................64
Programmable Electronic Features ..........279, 302
Programming Transmitters (Remote Keyless Entry) . .24
PTO (Power Take-Off) ..................... .416
Radial Ply Tires ......................... .471
Radiator Cap (Coolant Pressure Cap) ........584, 587
Radio Frequency General Information ............18, 20, 32, 35, 45 Radio Operation
......................... .343
Radio (Sound Systems) .....................339
Rain Sensitive Wiper System .................172
Rear Axle (Differential) ..................591, 592
Rear ParkSense System ..................182, 192
Rear Window Features .....................223
Rear Window, Sliding ..................... .224
Reclining Rear Seats ...................... .147
Recorder, Event Data .......................81
Recreational Towing ...................... .523
Shifting Into Transfer Case Neutral (N) ........526
Shifting Out Of Transfer Case Neutral (N) ......528
Reformulated Gasoline .....................494
Refrigerant .......................... .574, 575
Reminder, Seat Belt .........................51
Remote Control Starting System .........................32
Remote Keyless Entry (RKE) ................24, 26
Programming Additional Key Fobs ...........20
658 INDEX

Programming Additional Transmitters.........20
Remote Sound System (Radio) Controls .........341
Remote Starting
Uconnect Customer Programmable Features. .317, 335
Uconnect Settings ....................317, 335
Remote Starting System ......................32
Replacement Keys .........................20
Replacement Parts ........................ .562
Replacement Tires ........................ .478
Reporting Safety Defects ....................639
Restraint, Head .......................... .147
Restraints, Child ...........................82
Restraints, Occupant ........................49
Rotation, Tires .......................... .482
Safety Checks Inside Vehicle ..................115
Safety Checks Outside Vehicle ................117
Safety Defects, Reporting ....................639
Safety, Exhaust Gas ........................114 Safety Information, Tire
.....................455
Safety Tips ..............................114
Schedule, Maintenance .....................626
Seat Belt Adjustable Upper Shoulder Belt Anchorage ......58
Automatic Locking Retractor (ALR) ...........64
Energy Management Feature ................64
Lap/Shoulder Belt Operation ................55
Lap/Shoulder Belts .......................53
Lap/Shoulder Belt Untwisting ...............57
Pregnant Women ........................63
Seat Belt Extender .......................62
Seat Belt Pretensioner .....................64
Seat Belt Reminder .......................51
Seat Belt System .........................49
Seat Belt Maintenance ..................... .603
Seat Belt Reminder .........................51
Seat Belts ............................ .50, 115
Adjustable Shoulder Belt ...................58
10
INDEX 659

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.