2016 Ram 3500 Chassis Cab child restraint

2. Place a child restraint on the seat and adjust the tetherstrap so that it will reach over the seat back, under the
head restraint, through the tether strap loop behind
the seat and over to the tether strap loop behind the
center seat.
Head Restraint In Raised PositionTether Strap Loop With Center Head Restraint In Raised
Position
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 107

3. Pass the tether strap hook under the head restraintbehind the child seat, though the tether strap loop
behind the seat and over to the center tether strap
loop. 4. Attach the hook to the center tether strap loop (see
diagram). Tighten the tether strap according to the
child seat manufacturer ’s instructions.
Tether Strap Through Outboard Tether Strap Loop
Tether Strap Through Outboard Tether Strap Loop And
Attached To Center Tether Strap Loop
108 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

NOTE:If there are child seats in both of the outboard (left
and right) seating positions, the tether strap hooks of
both child seats should be connected to the center tether
strap loop. This is the correct way to tether two outboard
child seats.
Center Seat:
1. Raise the head restraint and reach between the rear seat and rear glass to access the tether strap loop.
2. Place a child restraint on the seat and adjust the tetherstrap so that it will reach over the seat back, under the
head restraint, through the tether strap loop behind
the seat and over to the tether strap loop behind either
the right or left outboard seat.
Tether Strap Loop With Head Restraint In Raised
Position
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 109

3. Pass the tether strap hook under the head restraintbehind the child seat, though the tether strap loop
behind the seat and over to the right or left outboard
tether strap loop. 4. Attach the hook to the outboard tether strap loop (see
diagram). Tighten the tether strap according to the
child seat manufacturer ’s instructions.
Tether Strap Through Center Tether Strap Loop
Tether Strap Through Center Tether Strap Loop And
Attached To Outboard Tether Strap Loop
110 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Installing Three Child Restraints:
1. Place a child restraint on each outboard rear seat.Route the tether straps following the directions for
right and left seating positions, above.
2. Attach both hooks to the center tether strap loop, but do not tighten the straps yet.
3. Place a child restraint on the center rear seat. Route the tether strap following the directions for the center
seating position, above.
4. Attach the hook to the outboard tether strap loop.
5. Tighten the tether straps according to the child seat manufacturer ’s instructions, tightening the right and
left tether straps before the center tether strap.
Left Outboard And Center Seating Position Shown
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 111

WARNING!
•An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchorage position directly
behind the child seat to secure a child restraint top
tether strap.
• If your vehicle is equipped with a split rear seat,
make sure the tether strap does not slip into the
opening between the seatbacks as you remove
slack in the strap.
Transporting Pets
Air Bags deploying in the front seat could harm your pet.
An unrestrained pet will be thrown about and possibly
injured, or injure a passenger during panic braking or in
a collision.
Pets should be restrained in the rear seat in pet harnesses
or pet carriers that are secured by seat belts.
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine and
drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 km), speeds up to 50 or
55 mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration within the
limits of local traffic laws contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detri-
mental and should be avoided.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur. For
the recommended viscosity and quality grades, refer to
“Maintenance Procedures” in “Maintaining Your Ve-
hicle.”
112 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Bulb Replacement........................ .615
Bulbs, Light ..........................117,614
Cab Top Clearance Lights ...................619
Camera, Rear ........................... .201
Capacities, Antifreeze (Engine Coolant) ..........621
Capacities, Fluid ......................... .621
Caps, Filler Oil (Engine) .......................... .566
Power Steering ........................ .434
Radiator (Coolant Pressure) ................587
Carbon Monoxide Warning ...............114,498
Cargo Light ............................ .168
Car Washes ............................ .598
Center High Mounted Stop Light ..............618
Center Seat Storage Compartment .............218
Certification Label ........................ .500
Chart, Tire Sizing ........................ .457
Check Engine Light (Malfunction Indicator Light) . .561 Checking Your Vehicle For Safety
..............114
Checks, Safety ............................114
Child Restraint ............................82
Child Restraints Booster Seats ...........................87
Child Restraints .........................82
Child Seat Installation .................99, 102
How To Stow An Unused ALR Seat Belt ........98
Infants And Child Restraints ................84
Install A LATCH-Compatible Child Restraint ....97
Installing Child Restraints Using The Vehicle Seat
Belt ..................................99
Locating The LATCH Anchorages ............94
Lower Anchors And Tethers For Children .......89
Older Children And Child Restraints ..........86
Seating Positions ........................88
Cigar Lighter ............................211
Clean Air Gasoline ....................... .494
648 INDEX

Programming Additional Transmitters.........20
Remote Sound System (Radio) Controls .........341
Remote Starting
Uconnect Customer Programmable Features. .317, 335
Uconnect Settings ....................317, 335
Remote Starting System ......................32
Replacement Keys .........................20
Replacement Parts ........................ .562
Replacement Tires ........................ .478
Reporting Safety Defects ....................639
Restraint, Head .......................... .147
Restraints, Child ...........................82
Restraints, Occupant ........................49
Rotation, Tires .......................... .482
Safety Checks Inside Vehicle ..................115
Safety Checks Outside Vehicle ................117
Safety Defects, Reporting ....................639
Safety, Exhaust Gas ........................114 Safety Information, Tire
.....................455
Safety Tips ..............................114
Schedule, Maintenance .....................626
Seat Belt Adjustable Upper Shoulder Belt Anchorage ......58
Automatic Locking Retractor (ALR) ...........64
Energy Management Feature ................64
Lap/Shoulder Belt Operation ................55
Lap/Shoulder Belts .......................53
Lap/Shoulder Belt Untwisting ...............57
Pregnant Women ........................63
Seat Belt Extender .......................62
Seat Belt Pretensioner .....................64
Seat Belt Reminder .......................51
Seat Belt System .........................49
Seat Belt Maintenance ..................... .603
Seat Belt Reminder .........................51
Seat Belts ............................ .50, 115
Adjustable Shoulder Belt ...................58
10
INDEX 659