Page 859 of 919
Rear Tail/Stop, Turn Signal And Backup Lamps
1. Remove the two screws that pass through the bedsheet metal. 2. Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the outboard
side of the lamp housing from the two plastic snap
post retainers in the outer box side panel.
3. Disconnect the wiring harness connectors from the bulb socket.
Tail Lamp Screw LocationsPulling Out The Tail Lamp
7
MAINTAINING YOUR VEHICLE 857
Page 860 of 919
4. Rotate the bulb socket counterclockwise 1/4 turn tounlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
6. Reverse the procedure to install the bulb and housing.
Center High-Mounted Stoplamp (CHMSL) With
Cargo Lamp
1. Remove the two screws holding the housing/lens to the body as shown. 2. Separate the connector holding the housing and wir-
ing harness to the body.
CHMSL Mounting Screw Locations
858 MAINTAINING YOUR VEHICLE
Page 861 of 919
3. Turn the desired bulb socket ¼ turn and remove thesocket and bulb from housing. 4. Pull the desired bulb straight from the socket.
CHMSL Connector Location
CHMSL Bulb And Socket
7
MAINTAINING YOUR VEHICLE 859
Page 862 of 919
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.• Outside Bulbs: Cargo Lamps
• Inside Bulb: Center High-Mounted Stop Lamp
5. Reverse the procedure for installation of bulbs and housing.
Cab Top Clearance Lamps — If Equipped
1. Remove the two screws from the top of the lamp.
Removing Rear Screw From Clearance Lamp
860 MAINTAINING YOUR VEHICLE
Page 863 of 919
2. Rotate the bulb socket ¼ turn and pull it from the lampassembly. 3. Pull the bulb straight from it’s socket and replace.
Removing Bulb Socket From Clearance Lamp
Removing The Bulb From The Bulb Socket
7
MAINTAINING YOUR VEHICLE 861
Page 864 of 919
Rear Lamp Bar ID Marker (Dual Rear Wheels) — If
Equipped
1. Loosen the two screws and the housing to gain accessto the bulb sockets. 2. Turn the socket ¼ turn counterclockwise to access the
bulb.
3. Pull the bulb straight out from the socket.
4. Reverse the procedure for installation of the bulbs and housing.
Screw Locations
862 MAINTAINING YOUR VEHICLE
Page 865 of 919
Side Marker Lamps (Dual Rear Wheels) — If
Equipped1. Push rearward on the side marker lamp assembly.
2. Pull the entire assembly from the fender.
3. Turn the socket ¼ turn counterclockwise and removefrom assembly to access the bulb.
4. Pull the bulb straight out from socket.
5. Reverse the procedure for installation of the bulbs and housing.
Side Marker Lamp Locations
7
MAINTAINING YOUR VEHICLE 863
Page 900 of 919

Brake/Transmission Interlock.................489
Bulb Replacement ..................... .852, 854
Bulbs, Light ......................... .122, 852
Cab Top Clearance Lights ...................860
Camera, Rear ........................... .212
Camper ............................... .271
Capacities, Fluid ......................... .864
Caps, Filler Oil (Engine) .......................... .801
Power Steering ........................ .615
Radiator (Coolant Pressure) ................821
Carbon Monoxide Warning ...............119,680
Cargo Light ............................ .180
Car Washes ............................ .834
Center High Mounted Stop Light ..............858
Center Seat Storage Compartment .............242
Certification Label ........................ .687
Chart, Tire Sizing ........................ .638Check Engine Light (Malfunction Indicator Light) . .795
Checking Your Vehicle For Safety
..............118
Checks, Safety ............................118
Child Restraint ............................85
Child Restraints Booster Seats ...........................90
Child Restraints .........................85
Child Seat Installation .................104, 106
How To Stow An Unused ALR Seat Belt .......102
Infants And Child Restraints ................88
Install A LATCH-Compatible Child Restraint . . . .101
Installing Child Restraints Using The Vehicle Seat
Belt ................................ .103
Locating The LATCH Anchorages ............98
Lower Anchors And Tethers For Children .......93
Older Children And Child Restraints ..........89
Seating Positions ........................92
Cigar Lighter ........................... .235
Clean Air Gasoline ....................... .677
898 INDEX