Page 56 of 520

54
Changing the battery
Do not throw the remote control 
batteries away, they contain metals 
which are harmful to the environment.
ta
ke them to an approved collection 
point. If the battery is flat, you are 
informed by lighting of this warning 
lamp in the instrument panel, an audible signal 
and a message in the screen.
Reinitialisation
Locking the side-hinged doors
F If fitted to your vehicle, check that the 
electric child lock is not on.
F
  o
p
 en the left-hand door. Battery ref.: CR1620 / 3 volts.
F  
L
 ock the driver's door using the 
key.
F
 
P
 ress one of the remote control 
buttons.
F
  t
u
 rn the key to position 2 (Ignition on).
F
 
S
 witch off the ignition and remove the key 
from the ignition switch.
th
e remote control is fully operational again.
Unlocking
F  use the interior door handle.
Remote control problem
Following disconnection of the vehicle battery, 
replacement of the remote control battery or 
in the event of a remote control malfunction, 
you can no longer unlock, lock or locate your 
vehicle.
F 
F
 irst of all, use the key in the lock to unlock 
or lock your vehicle.
F
  t
hen
  reinitialise the remote control.
If the problem persists, contact a P
e
ugeot  
dealer as soon as possible.
F
  u
n
 clip the cover using a screwdriver in the 
cut-out.
F
 
R
 emove the cover.
F
  e
x
 tract the flat battery from its location.
F
 
P
 lace the new battery into its location 
observing the original direction.
F
 
C
 lip the cover in place.
F
 
I
nsert the key into the latch aperture on the 
edge of the door (without forcing) and slide 
the assembly upward.
F
 
R
emove the key.
F
 
C
lose the door and check from the outside 
that it has locked correctly. 
Access  
     
        
        Page 72 of 520

70
Changing the battery
Battery ref.: CR2032 / 3 volts.this replacement battery is available from a 
Peugeot  dealer or a qualified workshop.
A message appears in the instrument panel screen 
when replacement of the battery is needed.
Do not throw the remote control 
batteries away, they contain metals 
which are harmful to the environment.
ta
ke them to an approved collection 
point.
F
 
P
lace the remote control against the 
reader.
F
 
K
eeping it in place, switch on the ignition 
by pressing "S
tA
R
t/
S
t
o
P
".
th
e remote control is fully operational again.
Reinitialisation
Remote control problem
Following disconnection of the vehicle battery, 
replacement of the remote control battery or 
in the event of a remote control malfunction, 
you can no longer unlock, lock or locate your 
vehicle.
F
 
F
 irst, use the integral key in the door lock 
to unlock or lock your vehicle.
F
  t
hen
 , reinitialise the remote control.
If the problem persists, contact a 
P
e
ugeot  dealer or a qualified 
workshop as soon as possible.
F
  u
n
 lock the driver's door using the integral 
key.
F
 
P
 ress one of the remote control 
buttons.
F
 
P
 lace the integral key in the lock to unlock 
your vehicle. F
  u
n
 clip the cover using a small screwdriver 
at the cutout.
F
 
L
 ift off the cover.
F
 
R
 emove the flat battery from its location.
F
 
F
 it the new battery into its location 
observing the original direction of fitment.
F
 
C
 lip the cover onto the casing. 
Access  
     
        
        Page 283 of 520

281
Checks
12 V battery
the battery does not require any maintenance.
However, check regularly that the terminals 
are correctly tightened (versions without quick 
release terminals) and that the connections 
are clean.Refer to the manufacturer's 
service schedule for details of the 
replacement intervals for these 
components.
Air filter and passenger compartment filter
Replace the oil filter each time the 
engine oil is changed.
Refer to the manufacturer's 
service schedule for details of 
the replacement interval for this 
component.
Oil filterParticle filter (Diesel)
the start of saturation of the particle 
filter is indicated by the temporary 
illumination of this warning lamp 
accompanied by a message in the 
multifunction screen.
As soon as the traffic conditions permit, 
regenerate the filter by driving at a 
speed of at least 40 mph (60 km/h) until 
the warning lamp goes off.
If the warning lamp stays on, this 
indicates a low additive level.
For more information on Checking 
levels , refer to the corresponding 
section.
on a n
ew vehicle, the first particle 
filter regeneration operations may be 
accompanied by a "burning" smell, 
which is per fectly normal.
Following prolonged operation of the 
vehicle at very low speed or at idle, 
you may, in exceptional circumstances, 
notice the emission of water vapour at 
the exhaust on acceleration. 
t
h
 is does 
not affect the behaviour of the vehicle 
or the environment.un
less otherwise indicated, check these components in accordance with the manufacturer's 
service schedule and according to your engine.
ot
her wise, have them checked by a P
e
ugeot
 dealer or a qualified workshop.
For more information and the precautions to 
take before starting work on the 12 V batter y , 
refer to the corresponding section. Depending on the environment (e.g. dusty 
atmosphere) and the use of the vehicle 
(e.g.
 
city driving), replace them twice as often 
if necessary .
A clogged passenger compartment filter may 
have an adverse effect on the per formance 
of the air conditioning system and generate 
undesirable odours.
Versions equipped with Stop & Start are 
fitted with a 12 V lead-acid battery of 
specific technology and specification.
Its replacement should be carried 
out only by a P
e
ugeot
 dealer or a 
qualified workshop.
7 
Practical information  
     
        
        Page 323 of 520

321
12 V batterythe battery is located under the bonnet.
F  op en the bonnet using the interior release 
lever, then the exterior safety catch.
F
 
S
 ecure the bonnet stay.
Access to the battery
Procedure for starting the engine using another 
battery or charging a discharged battery.
General points
Lead-acid starter batteries
Protect your eyes and face before 
handling the battery.
All operations on the battery must be 
carried out in a well ventilated area and 
away from naked flames and sources 
of sparks, so as to avoid the risk of 
explosion or fire.
Wash your hands afterwards.
Versions equipped with Stop & Start are 
fitted with a 12 V lead-acid battery of 
specific technology and specification.
Its replacement should be carried 
out only by a P
e
ugeot
 dealer or a 
qualified workshop. If your vehicle has an automatic 
gearbox, do not try to start the engine 
by pushing the vehicle.
Batteries contain harmful substances 
such as sulphuric acid and lead.
th
ey must be disposed of in 
accordance with regulations and must 
not, in any circumstances, be discarded 
with household waste.
ta
ke used remote control batteries and 
vehicle batteries to a special collection 
point.
For more information on the Bonnet 
and Engine , refer to the corresponding 
section(s).
F
 
I
 f fitted to your vehicle, remove the plastic 
cover to access the (+) terminal.
th
e battery (-) terminal is not accessible.
A remote earth point is provided at the front of 
the vehicle.
8 
In the event of a breakdown