2016 Peugeot Boxer tow

76
boxer_en_Chap03_ergo-et-confort_ed01-2015
cABIn FIttInGS
Front seat storage
there is a fixed storage tray under the
driver's seat.
central glove box
If fitted with a lock, you can lock it using
the key.
It gives access to the auxiliary sockets (Jack
and
u SB) intended for the transfer of data to
the audio system. If your vehicle is fitted with a seat with
variable damping, it does not have any
storage compartments.t
he space under the passenger's seat is
used to store the tool box containing the
tools required to change a wheel or bulb or
to tow the vehicle.
to take out the box, turn the control a


quarter turn to unlock it, then pull the box
forward.
When putting it back, don't forget to turn the
control a quarter turn in the other direction to
lock the box in its housing.
Practical information

81
boxer_en_Chap03_ergo-et-confort_ed01-2015
LoAd SPAcE FIttInGSSupport for stowing rail
Supports for securing a stowing rail are
available above the trims, on each side of
the vehicle.
Maximum load: 200 kg.
12 volt socket
Maximum power: 180 W.Lashing rings
Lashing rings are provided on the floor to
secure and make safe your loads: 8 for
L1 and L2 length vehicles, 10 for L3 and
L4 length vehicles.
two additional rings are located on the


partition behind the cab.
Maximum load: 500 kg.
Side trim
the lower parts of the sides are fitted with
load protection trims.
As a safety precaution in case of sharp

braking, you are advised to place
heavy objects as far forwards towards the
cab as possible.
Practical information
3
EASE oF uSE and coMFort

84
boxer_en_Chap03_ergo-et-confort_ed01-2015
ExtErIor FIttInGS
Protective grille
Depending on the country of sale, a
protective grille fitted to the inside of
the front bumper provides protection for
underbonnet components against flying
stones...
Very cold conditions protectors
Depending on the country of sale, protective
foam pads are present to avoid the ingress
of cold or snow to the upper part of the
underbonnet.
Located at the edge of each headlamp,
they are fitted to the front panel above the
radiator.
Slide them towards the outisde of the
vehicle to remove them.
Folding foot board
to faciltate the entry and exit of rear
passengers, your vehicle may be fitted with
a foot board, which is deployed on opening
the sliding side door.
Practical information

85
boxer_en_Chap03_ergo-et-confort_ed01-2015
MIrrorS
d
oor mirrors
these are divided into two zones:
A -
u pper mirror
B - Lower mirror
t

he mirror glass is spherical in order to
widen the lateral field of vision. Objects
seen in the mirror are in reality closer than
they appear.
t

herefore, this must be taken
into account in order to assess the distance
correctly.
t

he shell incorporates the direction indicator
side repeater and the aerials, according to
the equipment available on board (
g PS,
g

SM, Radio, ...).
Electrical controls
the ignition switch must be in the MAr position.
turn the control to select the mirror zone.
1 Driver's mirror:
A1 -

u pper mirror
B1 - Lower mirror
t

hen move the control in the direction of the
adjustment required.
2 Passenger mirror:
A2 -
u pper mirror
B2 - Lower mirror
t

hen move the control in the direction of the
adjustment required.
rear view mirror
the lever located on the lower edge moves
the mirror into two positions.
For the day position, the lever is pushed.
For the night position to prevent dazzle, pull

the lever towards you.
Electric folding
Press this control.
defrosting the mirrors
Press the rear screen defrosting
button.
Mirrors and windows
3
EASE oF uSE and coMFort

98
boxer_en_Chap05_Securite_ed01-2015
PAr KI n G B r AKEH A z A rd WA rn I n G LAMPS
Press this button, the direction indicators
flash.
t

hey can operate with the ignition off.Applying
Pull the parking brake lever up to immobilise
your vehicle.
Check that the parking brake is applied
firmly before leaving the vehicle. Pull on the parking brake lever, only
with the vehicle stationary.
releasing
Pull the lever up slightly and press the
button to lower the parking brake lever.In the exceptional case of use of the
parking brake when the vehicle is
moving, apply the brake by pulling gently
to avoid locking the rear wheels (risk of
skidding).
If the parking brake is still on or has
not been released properly, this is
indicated by this warning lamp which
comes on in the instrument panel.
When parking on a slope, direct your wheels towards
the pavement and pull the parking brake lever up.
t

here is no advantage in engaging a gear after
parking the vehicle, particularly if the vehicle is loaded.
the hazard warning lamps should only
be used in dangerous situations, when
stopping in an emergency or when
driving in unusual conditions.
Driving safely

11 0
boxer_en_Chap05_Securite_ed01-2015
GEnErAL P o I nt S on AI r BAGS
the airbags have been designed to optimise
the safety of the occupants in the event of
a serious collision; they work in conjunction
with the force limiting seat belts.
In the event of a serious collision, electronic
detectors record and analyse any abrupt
deceleration of the vehicle:
-

in the event of a serious collision, the

airbags are deployed instantly and
contribute towards better protection of
occupants of the vehicle; immediately
after the impact, the airbags rapidly
deflate so as to not hinder visibility or
the possible exit by the occupants,
-

in the event of a less serious impact,

an impact to the rear and in certain
conditions of rollover, the airbags are not deployed; the seat belts alone contribute
towards providing protection in these
situations.
Airbags only operate when the ignition is
switched on.Front airbags
these are fitted in the centre of the steering
wheel for the driver and in the dashboard for
the front passengers.
t

hey are deployed,
except the passenger's airbag if it has been
deactivated.
Deployment of the airbags is
accompanied by a slight discharge
of smoke and a noise, resulting from the
activation of the pyrotechnic charge included
in the system.
t

his smoke is not harmful but may be an
irritant to sensitive persons.
t

he noise of the detonation may result in a
slight loss of hearing for a short time.
o

perating fault If this warning lamp comes on,
contact a P
euge O t
dealer to

have the system checked.
Airbags

11 7
boxer_en_Chap05_Securite_ed01-2015
"ISoFIx" MountInGS
Your vehicle has been approved
to the latest ISOFIX regulation.
t
he ISOFIX child seats are fitted with two
latches which are secured easily on the
two front rings.
Some also have an upper strap which is
attached to the rear ring.
to attach this strap, remove and stow the


head restraint before installing the child seat
at the seating position (refit it once the child
seat has been removed).
t

hen fix the hook
on the rear ring and tighten the upper strap.
If fitted on your vehicle, the regulation
ISOFIX mountings are located by labels.
t

he mountings comprise three rings for each
seat:
-

two front rings, located between the

vehicle seat back and cushion, indicated
by a label,
-

a rear ring, for securing the upper

strap referred to as the
tOP


tet
H e R,
indicated by another label.
t

his ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in
your vehicle.
t

he incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
For information on the possibilities for fitting
ISOFIX child seats to your vehicle, refer to
the summary table for the location of the
ISOFIX child seats.
Child safety
5
SAFetY

11 8
boxer_en_Chap05_Securite_ed01-2015
LocAtI on S F or t HE I n S tALLAt I on o F IS o FI x c HIL d SEAt S
In accordance with european regulations, this table indicates the options for the installati\
on of ISOFIX child seats on the vehicle seats fitted
with ISOFIX mountings.
In the case of the universal and semi-universal ISOFIX child seats, the \
child seat's ISOFIX size category
, determined by a letter from A to G,
is indicated on the child seat next to the ISOFIX logo.
Less than
10 kg
(group 0)
u

p to 6 months approx Less than 10 kg

(group 0)
Less than 13 kg
(group 0+)

u p to 1 year approxFrom 9 to 18 kg

(group 1)
From 1 to 3 years approx
type of IS

o FI x child seat Infant carrierrearward facing forward facing
IS
o FI x size category F G
cdEcdAB1
r

ow 2 outer rear seats
with individual seats in
r ow 1 I
u FI
u FI
u F
r

ow 2 outer rear seats
with 2-seat bench in
r ow 1 I
u F
xI
u F
xI
u F
I
u F:
Seat suitable for the installation of

an ISOFIX child seat of the universal
category. Forward facing ISOFIX child
seats fitted with an upper strap secured
to the upper ring of the vehicle seats
equipped with ISOFIX mountings.
x

:
Seat not suitable for the installation of

an ISOFIX child seat of the size category
indicated.
Remove and stow the head restraint


before installing a child seat with
backrest on a passenger seat.
Refit the head restraint once the child seat
has been removed.
Child safety