2016 Peugeot Boxer catalytic converter

33EMISSIonS controLS
eOBD (european On Board Diagnosis)
is a diagnostics system which complies
with, among others, the standards on the

authorised emissions of:
-
CO (carbon monoxide),
-
HC (unburnt hydrocarbons),
-
NOx (nitrous oxides) or particles,
detected by oxygen sensors placed


upstream and downstream of the
catalytic converters.
tYrE undEr-InFLAtIon dEtEctIon
System which automatically checks the
pressures of the tyres while driving.
the tyre under-inflation detection


system is an aid to driving which does
not replace the need for vigilance on
the part of the driver.
this system does not avoid the need

to check the tyre pressures regularly
(including the spare wheel) and before a
long journey.
Driving with under-inflated tyres increases
fuel consumption.
the system continuously monitors the


pressures of the four tyres, as soon as the
vehicle is moving.
A pressure sensor is located in the valve of
each tyre.
the system triggers an alert if a drop in


pressure is detected in one or more tyres.
the tyre pressures must be checked


when the tyres cold (vehicle stopped
for 1 hour or after driving for less then
6 miles (10 km) at moderate speed).
Otherwise, add 0.3 bar to the values
indicated on the label.
the tyre pressures for your vehicle can be


found on the tyre pressure label.the driver is warned of any

malfunction of this emission
control system by the illumination
of this specific warning lamp in
the instrument panel.
there is a risk of damage to the catalytic


converter. Have it checked by a P
eugeOt
dealer or a qualified workshop.
to locate it, refer to the "technical
data
- Identification markings" section.
Driving with under-inflated tyres


adversely affects road holding, extends
braking distances and causes premature
tyre wear, particularly under arduous
conditions (vehicle loaded, high speed, long
journey).
2
rEAdY to SEt oFF
Instruments and controls

133
operating fault
If this alert persists, do not ignore the
warning; it indicates that a fault has occurred

in the exhaust / particle filter system.
Have the whole system checked by a
P
eugeOt dealer or a qualified workshop.
If there is risk of blockage of the
filter

, this warning lamp comes on
in the instrument panel.
Saturation / regeneration
Because of the higher exhaust

gas temperature resulting from the
normal operation of the particle filter, it is
recommended that you do not park the
vehicle over inflammable materials (grass,
dry leaves, pine needles,
...) so as to avoid


any risk of fire.
Particle filter system (diesel)
An addition to the catalytic converter, this
filter makes an active contribution to the
preservation of air quality by the retaining
of the unburnt pollutant particles. Black
exhaust fumes are thus no longer emitted.
operation
this filter

, fitted in the exhaust system,
accumulates particles of soot.
the engine


management unit controls the automatic
periodic elimination of the soot particles
(regeneration).
the regeneration procedure is invoked


according to the quantity of particles
accumulated and the driving conditions
of the vehicle. During this phase, you
may notice some unusual phenomena
-


increased idling speed, cooling fan running,
increase in smoke and higher exhaust gas
temperature
- which does not af

fect the
operation of the vehicle or the environment. After prolonged idling or driving at very
low speeds, you may occasionally
notice water vapour being emitted from the
exhaust when accelerating.
this is of no


consequence to the running of the vehicle or
to the environment.to regenerate the filter, it is advised to
drive as soon as possible, when traffic
conditions and the law permit, at a speed
of at least 40
mph (around 60 km/h), with


an engine speed above 2 000 rpm for about
fifteen
minutes (until the warning lamp and/
or the message disappears).
If possible, avoid switching of

f the engine
before the end of regeneration of the
filter; repeated interruptions could cause
premature deterioration of the engine oil. It
is not recommended to end regeneration of
the filter with the vehicle stationary.
this alert tells you that the particle filter


is starting to fill up (in conditions of urban
driving of exceptionally long duration: low
speeds, traffic jams etc.).
7
CHeCKS
Levels and checks

136
BLuEHdI
A
nd AdBLuE® AddItIVE
AdBlue® is the brand name of the solution
needed for operation of the SCR system.
BlueHDI vehicles have a specific AdBlue
®
additive tank with a capacity of 15 litres.
It has an exterior filler located behind the
fuel filler flap below the fuel filler cap and
closed with a blue filler cap.
the objective of BlueHDi is to reduce by


up to 90% the emissions of NOx (nitrous
oxides) in the air, using a system that
converts NOx into water vapour and nitrogen
in a dedicated catalytic converter: SCR
(Selective Catalytic Reduction).
this objective meets the "euro 6" emissions


standard adopted by the
european union


aimed at limiting the emissions of pollutants
from internal combustion engines.
the SCR technology used on BlueHDi


engines involves the injection of AdBlue
®
fluid into the exhaust system.this operation can also be carried out
by a PeugeOt dealer or a qualified
workshop.
Scr technology
Filling of the AdBlue® tank can be done
using:
-
5 or 10 litres containers equipped with a
10 centimetre filler tube or the filling kit


available from P
eugeOt dealers,
-
1.89 litre botles that are screwed onto
the filler neck, available from P
eugeOt
dealers,
-
or when at a fuel filling station equipped
with a special

AdBlue
® delivery pump for
heavy or light vehicles.
AdBlue® additive

177
Quality of the fuel used for diesel engines
the Diesel engines are perfectly compatible with biofuels which conform t\
o current and future european standards (Diesel fuel which
complies with standard eN 590 mixed with a biofuel which complies with standard eN 14214) available at the pumps (containing up to 5%
Fatty Acid Methyl
ester).
EnGInES And GEArBoxES
diesel engine 2.0 litre BlueHdi 1 102.0 litre BlueHdi 110 S&S
2.0 litre BlueHdi 130
2.0 litre BlueHdi 130 S&S
2.0 litre BlueHdi 160
2.0 litre BlueHdi 160 S&S2.0 litre Hdi 160
Gearbox Manual
(6-speed)
Maximum power (hp) 11 0130 160160
eu standard maximum power (kW) 809611

8 120
Cubic capacity (cc) 1 9971 9971 9971 997
Bore x stroke (mm) 85 x 8885 x 8885 x 8885 x 88
Maximum power engine speed (rpm) 3 5003 7503 7503 750
eu standard maximum torque (Nm) 300340350340
Maximum torque engine speed (rpm) 1 5001 7501 7502 000
Fuel DieselDieselDieselDiesel
Catalytic converter Ye

s Ye s Ye sYe s
Particle filter Ye sYe sYe sYe s
engine oil capacity (in litres)
after draining and replacing the filter 6.6
6.66.65.25
9
teCHNICAL DAtA
Diesel engines

178
diesel engine2.2 litre Hdi 1 102
.2 litre Hdi 13 0
2.2 litre e-Hdi 130
2 .2 litre Hdi 150
2.2 litre e-H
di 1503 litre Hdi 180
Gearbox Manual

(6-speed)
Maximum power (hp) 11 0120 130150180
eu standard maximum power (kW) 81889611

0 130
Cubic capacity (cc) 2 1982 198 21982 999
Bore x stroke (mm) 86 x 94.686 x 94.686 x 94.6 95.8 x 104
Max power engine speed (rpm) 3 5003
5003 5003 600
eu standard max torque (Nm) 250320320400
Max torque engine speed (rpm) 1
5002 0002 0001 400
Fuel DieselDieselDieselDiesel
Catalytic converter Ye

s Ye s Ye sYe s
Particle filter Ye sNoYe s Ye sYe s
engine oil capacity (in litres)
after draining and replacing the oil filter 6.2
6.46.26.2 9
the B30 biofuel can be used in certain Diesel engines; however

, this use is subject to strict application of the special servicing con\
ditions
given in the warranty and maintenance record. Contact a P
eugeOt dealer or a qualified workshop.
the use of any other type of (bio)fuel (vegetable or animal oils, pure\
or diluted, domestic fuel...) is strictly prohibited (ris

k of damage to the
engine and fuel system).
Diesel engines