2016 Peugeot Boxer tow

76
cAB FIttInGS
Front seat storage
there is a fixed storage tray, located under
the driver's seat.
central glove box
If this has a lock, you can lock it using
the
key
.
It permits access to the auxiliary sockets
(Jack and
uSB) used to transfer data to the


audio system. If your vehicle is fitted with a seat with
variable vibration reduction, it does not
have any storage compartments.the location under the passenger's seat

is dedicated to storage of the tool box,
containing the tools to be used when
changing a wheel or bulb or when towing the
vehicle...
to take out the box, turn the control a
quarter of a turn to release, then pull the box


forwards.
When putting it back in place, do not forget
to turn the control a quarter of a turn in the
opposite direction to secure the box in its
location.
Practical information

81
LoAd SPAcE FIttInGSSupport for stowing rail
Supports for securing a stowing rail are
available above the trims, on each side of
the vehicle.
Maximum load: 200 kg.
12 volt socket
Maximum power: 180 W.Lashing rings
Lashing rings are provided on the floor to
secure and make safe your loads: 8 for
L1 and L2 length vehicles, 10 for L3 and
L4
length vehicles.
two additional rings are located on the
partition behind the cab.
Maximum load: 500 kg.Side trim
the lower parts of the sides are fitted with
load protection trims.
As a safety precaution in case of sharp
braking, you are advised to place

heavy objects as far forwards towards the
cab as possible.
3
EASE oF uSE and coMFort
Practical information

84
ExtErIor FIttInGS
Protective grille
Depending on the country of sale, a
protective grille fitted to the inside of
the front bumper provides protection for
underbonnet components against flying
stones...
Very cold conditions protectors
Depending on the country of sale, protective
foam pads are present to avoid the ingress
of cold or snow to the upper part of the
underbonnet.
Located at the edge of each headlamp,
they are fitted to the front panel above the
radiator.
Slide them towards the outisde of the
vehicle to remove them.
Folding foot board
to faciltate the entry and exit of rear
passengers, your vehicle may be fitted with
a foot board, which is deployed on opening
the sliding side door.
Practical information

85
MIrrorS
door mirrors
these are divided into two zones:
A -
upper mirror
B -

Lower mirror
the mirror glass is spherical in order to


widen the lateral field of vision. Objects
seen in the mirror are in reality closer than
they appear.
therefore, this must be taken


into account in order to assess the distance
correctly.
the shell incorporates the direction indicator


side repeater and the aerials, according to
the equipment available on board (
gPS,


gSM, Radio, ...).
Electrical controls
the ignition switch must be in the MAr position.
turn the control to select the mirror zone.
1 Driver's mirror:
A1 -
upper mirror
B1 -

Lower mirror
then move the control in the direction of the


adjustment required.
2 Passenger mirror:
A2 -
upper mirror
B2 -

Lower mirror
then move the control in the direction of the


adjustment required.
rear view mirror
the lever located on the lower edge moves
the mirror into two positions.
For the day position, the lever is pushed.
For the night position to prevent dazzle, pull
the lever towards you.
Electric folding
Press this control.
defrosting the mirrors
Press the rear screen defrosting
button.
3
EASE oF uSE and coMFort
Mirrors and windows

98
PArKInG BrAKEHAzArd WArnInG LAMPS
Press this button, the direction indicators
flash.
they can operate with the ignition of

f.Applying
Pull the parking brake lever up to immobilise
your vehicle.
Check that the parking brake is applied
firmly before leaving the vehicle. Pull on the parking brake lever, only
with the vehicle stationary.
releasing
Pull the lever up slightly and press the
button to lower the parking brake lever.In the exceptional case of use of the
parking brake when the vehicle is
moving, apply the brake by pulling gently
to avoid locking the rear wheels (risk of
skidding).
If the parking brake is still on or has not
been released properly, this is indicated
by this warning lamp which comes on in
the instrument panel.
When parking on a slope, direct your wheels towards
the pavement and pull the parking brake lever up.
there is no advantage in engaging a gear after


parking the vehicle, particularly if the vehicle is loaded.
the hazard warning lamps should only
be used in dangerous situations, when
stopping in an emergency or when

driving in unusual conditions.
Driving safely

11 0
GEnErAL PoIntS on AIrBAGS
the airbags have been designed to optimise
the safety of the occupants in the event of
a serious collision; they work in conjunction

with the force limiting seat belts.
In the event of a serious collision, electronic
detectors record and analyse any abrupt
deceleration of the vehicle:
-
in the event of a serious collision, the
airbags are deployed instantly and


contribute towards better protection of
occupants of the vehicle; immediately
after the impact, the airbags rapidly
deflate so as to not hinder visibility or
the possible exit by the occupants,
-
in the event of a less serious impact,
an impact to the rear and in certain


conditions of rollover, the airbags are not deployed; the seat belts alone contribute
towards providing protection in these
situations.
Airbags only operate when the ignition is
switched on.Front airbags
these are fitted in the centre of the steering
wheel for the driver and in the dashboard for
the front passengers.
they are deployed,


except the passenger's airbag if it has been
deactivated.
Deployment of the airbags is
accompanied by a slight discharge
of smoke and a noise, resulting from the
activation of the pyrotechnic charge included
in the system.
this smoke is not harmful but may be an


irritant to sensitive persons.
the noise of the detonation may result in a


slight loss of hearing for a short time.
operating fault
If this warning lamp comes on,


contact a P
eugeOt dealer to
have the system checked.
Airbags

11 7
"ISoFIx" MountInGS
Your vehicle has been approved
to the latest ISOFIX regulation.
the ISOFIX child seats are fitted with two

latches which are secured easily on the
two front rings.
Some also have an upper strap which is

attached to the rear ring.
to attach this strap, remove and stow the
head restraint before installing the child seat


at the seating position (refit it once the child
seat has been removed).
then fix the hook


on the rear ring and tighten the upper strap.
If fitted on your vehicle, the regulation
ISOFIX mountings are located by labels.
the mountings comprise three rings for each


seat:
-
two front rings, located between the
vehicle seat back and cushion, indicated


by a label,
-
a rear ring, for securing the upper
strap referred to as the
tOP tetHeR,


indicated by another label.
this ISOFIX mounting system provides fast,


reliable and safe fitting of the child seat in
your vehicle.
the incorrect installation of a child seat


in a vehicle compromises the child's
protection in the event of an accident.
For information on the possibilities for fitting
ISOFIX child seats to your vehicle, refer to
the summary table for the location of the
ISOFIX child seats.
5
SAFetY
Child safety

11 8
LocAtIonS For tHE InStALLAtIon oF ISoFIx cHILd SEAtS
In accordance with european regulations, this table indicates the options for the installati\
on of ISOFIX child seats on the vehicle seats fitted
with ISOFIX mountings.
In the case of the universal and semi-universal ISOFIX child seats, the \
child seat's ISOFIX size category, determined by a letter from
A to G ,
is indicated on the child seat next to the ISOFIX logo.
Less than
10 kg
(group 0)
up to 6 months


approx Less than 10 kg

(group 0)
Less than 13 kg
(group 0+)

up to 1 year approx From 9 to 18 kg

(group 1)
From 1 to 3 years approx
type of ISoFIx child seat Infant carrier

rearward facingforward facing
IS
oFIx size category F

G
cdEcdAB1
row 2 outer rear seats


with individual seats in
row 1 IuF
IuF IuF
row 2 outer rear seats


with 2-seat bench in
row 1 IuFxIuFxIuF
I
uF:


Seat suitable for the installation of
an ISOFIX child seat of the universal


category. Forward facing ISOFIX child
seats fitted with an upper strap secured
to the upper ring of the vehicle seats
equipped with ISOFIX mountings.
x: Seat not suitable for the installation of
an ISOFIX child seat of the size category


indicated.
Remove and stow the head restraint
before installing a child seat with


backrest on a passenger seat.
Refit the head restraint once the child seat
has been removed.
Child safety