17
508 _en_Chap01_instrument-bord_ed01-2016
Warning / indicator lampStateCause Action / Observations
Automatic
wiping fixed.
th
e wiper control is pushed
downwards. Automatic front wiping is activated.
to d
eactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
Passenger's
airbag system fixed in the seat belt
and passenger's front
airbag warning lamps
display.
the control switch, located in the glove
box, has been placed in the "ON"
position.
the
passenger's front airbag is activated.
In this case, do not install a rear ward
facing child seat on this seat.Move the control switch to the "OFF" position to
deactivate the passenger's front airbag.
In this case, you can install a rear ward facing child
seat, unless there is a fault with the airbags (airbag
warning lamp on).
Stop & Star t fixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Start system
has put the engine into S
tO
P mode.
th
e warning lamp goes off and the engine restarts
automatically in S
tA
R
t
mode, as soon as you want to
move off.
flashes for a few
seconds, then goes
of f. S
tO
P mode is temporarily
unavailable.
or
S
tA
R
t
mode is invoked
automatically. For more information on Stop & Start, refer to the
corresponding section.
1
Instruments
14
Hybrid4 system
508HY-comp_en_Chap00b_hybrid_ed01-2016
Never leave children alone inside the vehicle when the HYbrid4 system is active.
The RE ADY can come on after a RE ADY can come on after a RE ADYfew seconds if the HYbrid4 system is activated after going into energy economy mode.
Starting - switching off the HYbrid4 system
Starting the HYbrid4 system
Activation of the HYbrid4 system
In wintry conditions with the engine cold, the Diesel pre-heating warning lamp can stay on for a few seconds; wait until it goes off before releasing the brake pedal.
In the event of non-activation of the HYbrid4 system: If N is flashing in the instrument panel, move the gear selector to position A then to position N . If the " Foot on the brake " is displayed, press the brake pedal f i r m l y.
Place the gear selector at position N . Insert the electronic key in the reader. or With Keyless Entry and Starting, simply having the electronic key inside the vehicle is sufficient. or Insert the remote control key into the ignition switch and turn it towards the dashboard to position 2 (ignition on).
Press the brake pedal firmly. Make a single short press (about one second) on the " START/STOP " button. or Turn the remote control key fully towards the dashboard to position 3 (Starting). Maintain pressure on the brake pedal until the RE ADY lamp comes on, signalling RE ADY lamp comes on, signalling RE ADY
activation of the HYbrid4 system, confirmed by an audible signal.
On activation of the HYbrid4 system, the instrument panel lights up, the power indicator needle is placed at position " 0 ". The steering column automatically unlocks (perceptible noise and movement of the steering column). Depending on certain parameters, such as the state of charge of the high voltage battery or the ambient temperature, the HYbrid4 system itself determines whether it is necessary to
start the HDi Diesel engine. The mode selector is at the AUTO position.
