Page 38 of 398

36
Trip computer, a few definitions
Range
(miles or km)the distance which can still be 
travelled with the fuel remaining in 
the tank (related to the average fuel 
consumption over the last few miles 
(kilometres) travelled).
thi
s value may vary following a change 
in the style of driving or the relief, 
resulting in a significant change in the 
current fuel consumption.
When the range falls below 20 miles (30 km), 
dashes are displayed. After filling with at least 
5 litres of fuel, the range is recalculated and is 
displayed when it exceeds 60 miles (100 km). If dashes are displayed continuously 
while driving in place of the digits, 
contact a P
eu
ge
Ot d
 ealer or a 
qualified workshop.
thi
s function is only displayed from 
20
 m
ph (30 km/h).
Current fuel consumption
(mpg or l/100 km or km/l)
Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
Calculated since the last trip 
computer reset.
Average speed
(mph or km/h)
Calculated since the last trip 
computer reset.
Distance travelled
(miles or km)
Calculated since the last trip 
computer reset.
Stop & Start time 
counter
(minutes / seconds or 
ho urs / m inutes)
If your vehicle is fitted with Stop & Start, a time 
counter calculates the time spent in S
tOP m
ode 
during a journey.
It resets to zero every time the ignition is 
switched on. 
Instruments  
         
        
        
     
        
        Page 50 of 398
48
308_en_Chap02_ouvertures_ed02-2015
System for the central locking or unlocking 
of the vehicle using the door lock or from a 
distance.
It is also used to locate and start the vehicle, as 
well as providing protection against theft.
Remote control key
Unfolding / Folding the key
F Press this button to unfold or fold the key.
Complete unlocking
Using the keyUsing the remote control
F Press the open padlock to unlock 
t
he vehicle.
unl
ocking is confirmed by rapid 
flashing of the direction indicators for 
approximately two seconds.
According to version, the door mirrors 
unfold at the same time.
F 
tur
n the key to the front of the vehicle to 
unlock the vehicle.
If your vehicle has an alarm, this is not 
deactivated. Opening a door will trigger the 
alarm, which can then be stopped by switching 
the ignition on.
If you do not press the button, you risk 
damaging the remote control. 
Access  
         
        
        
     
        
        Page 63 of 398

61
308_en_Chap02_ouvertures_ed02-2015
Back-up key
Unlocking/locking using the 
integral key with Keyless 
Entry and Starting
the integral key is used to lock and unlock the 
v ehicle when the electronic key cannot operate:
-
 ce
ll battery flat, vehicle battery discharged 
or disconnected, ...
-
 ve
hicle located in an area with strong 
electromagnetic signals.
F
 Ma
intain a pull on button 1 , to extract the 
integral key 2 .
Locking the driver's door
F Insert the integral key in the door lock, then 
t
urn it to the rear.
Unlocking the driver's door
F Insert the integral key in the door lock, then 
turn it to the front.
Locking the passenger doors
F Open the doors.
F Fo r the rear doors, check that the child lock 
is not on.
F
 In
sert the integral key in the latch located 
on the edge of the door and turn it an 
eighth of a turn to the right for the right 
hand door, and to the the left for the left 
hand door.
F
 Cl
ose the doors and check that the vehicle 
has locked correctly from the outside.
If the alarm is activated, the audible 
signal on opening a door with the key 
(integral with the remote control) will 
stop when the ignition is switched on.
Unlocking the passenger doors
F Pull the interior door opening control.
F
or more information on the child lock, 
refer to the corresponding section.
2 
Access  
         
        
        
     
        
        Page 65 of 398

63
308_en_Chap02_ouvertures_ed02-2015
Lost keys, remote control, electronic key
Visit a PeugeOt dealer with the vehicle's registration certificate, your personal identification documents and if possible, the label bearing the 
key code.
the Peu
ge
Ot d
 ealer will be able to retrieve the key code and the transponder code required to order a new key
Remote control
the high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the 
v ehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from 
working and the remote control would have to be reinitialised.
the r
emote control does not operate when the key is in the ignition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition or take the electronic key when you leave the vehicle, even for 
a short time.
Electrical interference
the Keyless ent ry and Starting electronic key may not operate if close to certain electronic devices: telephone, laptop computer, strong 
magnetic fields, ...
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
Don't forget to turn the steering to engage the steering lock.
When purchasing a second-hand vehicle
Have the key codes memorised by a Peu geOt d ealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
2 
Access  
         
        
        
     
        
        Page 69 of 398

67
308_en_Chap02_ouvertures_ed02-2015
Volumetric monitoring
Deactivationthe tilt alarm is deactivated as well, if your 
vehicle has it.
F
 Sw
itch of the ignition and within 
ten seconds press this button 
until its indicator lamp is on fixed.
F
 
g
et o
 ut of the vehicle. Reactivationthe t
ilt alarm is reactivated as well, if your 
vehicle has it.
the i
ndicator lamp in the button goes off.
F
 Im
mediately lock the vehicle 
using the remote control or the 
"Keyless 
ent
ry and Starting" 
system.
Only the exterior perimeter protection system is 
active: the indicator lamp in the button flashes 
once per second.
to be e
ffective, this deactivation must be done 
every time the ignition is switched off. F
 Dea
ctivate the exterior perimeter 
monitoring by unlocking the 
vehicle using the remote control 
or the Keyless 
ent
ry and starting 
system.
F
 Re
activate the full alarm system 
by locking the vehicle using the 
remote control or the "Keyless 
ent
ry and starting" system.
the i
ndicator lamp in the button flashes once 
per second again.
Triggering of the alarm
this is indicated by sounding of the siren 
a nd flashing of the direction indicators for 
thirty
 s
econds.
the m
onitoring functions remain active until 
the alarm has been triggered eleven times in 
succession.
When the vehicle is unlocked using 
the remote control or the Keyless 
ent
ry and starting system, rapid 
flashing of the indicator lamp in the 
button informs you that the alarm was 
triggered during your absence.
When the ignition is switched on, this 
flashing stops immediately.
2 
Access  
         
        
        
     
        
        Page 70 of 398

68
308_en_Chap02_ouvertures_ed02-2015
Failure of the remote control
to deactivate the monitoring functions:
F  unl ock the vehicle using the key (integral 
with the remote control) in the driver's door 
lock.
F
 Op
en the door; the alarm is triggered.
F
 Sw
itch on the ignition; the alarm stops. 
the 
i
ndicator lamp in the button goes off.
Locking the vehicle without 
activating the alarm
F Lock or deadlock the vehicle using the key 
( integral with the remote control) in the 
driver's door lock.
Operating fault
When the ignition is switched on, 
fixed illumination of the indicator 
lamp in the button indicates a fault in 
the system.
Have it checked by a P
eu
ge
Ot 
d
ealer or a qualified workshop.
Automatic activation
this function is either not available, an option 
o r is standard.
2 minutes after the last door or the boot is 
closed, the system is activated automatically.
F
 
t
o av
 oid triggering the alarm on entering 
the vehicle, first press the unlocking button 
on the remote control or unlock the vehicle 
using the Keyless 
ent
ry and starting 
system. 
Access  
         
        
        
     
        
        Page 78 of 398
76
308_en_Chap03_ergonomie-et-confort_ed02-2015
Electric lumbar adjustment
You can deactivate the massage 
function at any time by pressing this 
switch, its indicator lamp goes off.
Deactivation
Activation
Massage function
this system provides the occupants of the front 
s eats with a lumbar massage. It only operates 
when the engine is running or in S
tOP m
ode of 
the Stop & Start system.
F
 Pr
ess this switch.
Its indicator lamp comes on and the massage 
function is activated for a period of 1 hour.
During this time, massage is per formed in  
6 cycles of 10 minutes (6 minutes of massage 
followed by 4 minutes break).
After one hour, the function is deactivated, the 
indicator lamp goes off.
Adjustment of intensity
Press this button to adjust the 
intensity of the massage.
two l
 evels of massage are available.
F
 Pr
ess the control to obtain the desired 
lumbar support. 
ease of use and comfort  
         
        
        
     
        
        Page 86 of 398

84
308_en_Chap03_ergonomie-et-confort_ed02-2015
230 V / 50 Hz power socket
A 230 V / 50 Hz socket (maximum power: 
120 W) is fitted in the rear storage box.
thi
s socket works with the engine running, as 
well as in S
tOP m
ode with Stop & Start.
F
 Op
en the central storage box,
F
 Ch
eck that the warning lamp is on green,
F
 Co
nnect your multimedia or other electrical 
device (telephone charger, laptop 
computer, CD-DVD player, baby food 
warmer...).
In the event of a fault with the socket, the green 
warning lamp flashes.
Have it checked by a P
eu
ge
Ot d
 ealer or a 
qualified workshop. Connect only one device at a time to 
the socket (no extension or multi-way 
connector).
Connect only devices with class II 
insulation (shown on the device).
Do not use a device with a metal case.
As a safety measure, when electrical 
consumption is high and when required 
by the vehicle's electrical system 
(particular weather conditions, electrical 
overload...), the current supply to the 
socket will be cut off; the green warning 
lamp goes off.
the d
ifferent "ports and sockets" can 
be either not available, an option or 
standard, depending on the trim level of 
the vehicle. 
ease of use and comfort