REMOVAL
NOTE:
Leaving the housing un-installed from the
module for extended periods of time could
cause the fuel tank to drain through the
stage 1 fuel filter module.1. Push the ignition switch to the OFF position and wait 2 minutes before disconnecting the
battery.
2. Disconnect the batteries.
3. Clean the area around the stage 1 fuel filter. 4. Drain the fuel filter housing. For additional
information, refer to “Draining water” in this
section.
5. Close the water-in-fuel drain.
6. Disconnect the wiring harness
Afrom the
water-in-fuel sensor.
7. Remove the fuel filter housing
Bfrom the
module
C.
NOTE:
It may be necessary to use a screwdriver in
the slots provided to remove the fuel filter
element from the housing.8. Remove the fuel filter element
Dby lifting it
out of the fuel filter housing.
9. Remove and discard the sealing o-ring
E
from the fuel filter housing.
LDI2895LDI2896
Do-it-yourself6-11
