2016 NISSAN SENTRA warning

[x] Cancel search: warning

Page 416 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual 1. Rotate the (high beam) coverAcounter-
clockwise to access the (high beam) bulb
socket
C. Rotate the bulb socketCcoun-
terclockwise and remove bulb.
2. Rotate the (low beam) cover
B(if so
equipp

Page 420 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual If you have a flat tire, refer to “Flat tire” in
the “In case of emergency” section of this
manual.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire

Page 421 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Incorrect tire pressure, including un-
der inflation, may adversely affect
tire life and vehicle handling.
WARNING
● Improperly inflated tires can fail
suddenly and cause an accident.
● The Gross

Page 426 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Other Tire-related Terminology
In addition to the many terms that are
defined throughout this section, Intended
Outboard Sidewall is (1) the sidewall that
contains a whitewall, bears white lettering
o

Page 428 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Wheel nut tightening torque:83 ft-lb (113 N·m)
The wheel nuts must be kept tight-
ened to specifications at all times. It
is recommended that wheel nuts be
tightened to specification at each
tire rot

Page 429 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Replacing wheels and tires
When replacing a tire, use the same size, tread
design, speed rating and load carrying capacity
as originally equipped. For additional information,
refer to “Wheels and ti

Page 430 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Wheel balance
Unbalanced wheels may affect vehicle handling
and tire life. Even with regular use, wheels can get
out of balance. Therefore, they should be bal-
anced as required.
Wheel balance service

Page 445 of 478

NISSAN SENTRA 2016 B17 / 7.G Owners Manual Use the following steps to mount the front license
plate:
1Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Inst