8. Hold down the brake pedal and press the START button. The vehicle instruments and gauges will
light up, and the green READY light will come ON.
If the green READY light does not come on, press the START button to turn the
Hybrid
System OFF. Carefully disconnect the negative cable then the positive cable. It is
recommended you visit a NISSAN dealer for repair.
9. After the green READY light in the meter display comes ON, carefully disconnect the
negative
cable and then the positive cable.
10. Replace the vent caps (if so equipped) . Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid.
11. Reinstall the fusible link box cover.
NOTE:
If it is not possible to turn the hybrid system ON by following this procedure, it is
recommended you contact a NISSAN dealer immediately.
4-2 Shift Selector Lever Lock Release
If the 12-volt battery is low or discharged, the selector lever cannot be moved from the Park (P) position. If a
booster battery is not available, the selector lever lock can be manually released. To manually release the
selector lever lock, perform the following procedure: 1. Push the ignition switch to the LOCK or OFF position.
2. Apply the parking brake.
3. Remove the shift lock cover (A)using a suitable tool.
4. Push down the shift lock (C)using a suitable tool as
shown in the illustration.
5. Push the selector lever button (B)and move the selector
lever to the Neutral (N) position (D)while holding down
the shift lock. C B
D
A
AAYIA0459ZZ
DG–36
7. Release pawls using a suitable tool and remove cluster
lid C(1). : Pawl
8.
Apply the parking brake. Make sure the vehicle cannot move with the parking brake applied.
9.
Remove shift lock override button cover (1)using
suitable tool, and insert suitable tool into opening (A)
to depress the shift lock override button. Move shift
selector to “N” position while depressing shift lock
override button.
10. Remove the shift selector knob with the following procedure. a. Slide the selector lever knob cover (1)down. Do not damage the selector lever knob cover.
b.
Pull out the lock pin (2)from the shift selector
knob (3).
c. Pull the shift selector knob and the selector lever knob cover upwards to remove them.
11. Remove the shift selector finisher.
12. Shift the selector lever to “P” position.
13. Disconnect the harness connector (A)from the CVT
shift selector. 1
AAYIA0472ZZ
1
A
AAYIA0484ZZ
2
13
AAYIA0494ZZ
A
AAYIA0495ZZ
DG–43
