2016 MERCEDES-BENZ S-COUPE child restraint

[x] Cancel search: child restraint

Page 66 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual Removingth echild restrain tsystem and
deactivatin gth especial seat belt retractor:
XMak esur eyou observ eth echild restrain t
system manufacturer' sinstallation instruc -
tions.
XPress th erele

Page 67 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual All child restraint systems must meet the fol-
lowing standards:
RU.S. Federal Motor Vehicle Safety Stand-
ards 213 and 225
RCanadian Motor Vehicle Safety Standards
213 and 210.2
Confirmation that the

Page 68 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual tem is equipped with a Top Tether belt, this
should always be used.
Top Tether anchorages
The Top Tether anchorage points are installed
in the rear compartment behind the head
restraints on the parcel

Page 69 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual Always observe the child restraint system
manufacturer's installation and operating
instructions.
Forward-facing child restraint system
If you secure a child in a forward-facing childrestraint sys

Page 109 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual XBefore starting off, adjust the rear-view mir-ror and the exterior mirrors in such a way
that you have a good view of road and traf-
fic conditions (
Ypage 118).
XStore the seat, steering wheel and e

Page 110 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual heating should also not be used to dry
the seats.
Rclean the seat covers as recommended;
see "Interior care".
Rdo not transport heavy loads on the
seats. Do not place sharp objects on the
seat

Page 113 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual Adjust the seat properly before beginning
your journey. Always ensure that the backrest
is in an almost vertical position and that the
shoulder section of your seat belt is routed
across the center of

Page 116 of 410

MERCEDES-BENZ S-COUPE 2016  Owners Manual Problems with the seat ventilation
ProblemPossible causes/consequences andMSolutions
The seat ventilation has
switched off prema-
turely or cannot be
switched on.The on-board voltage is too low becaus
Page:   < prev 1-8 9-16 17-24 25-32 next >