2016 MAZDA MODEL CX-5 ignition

3
CAUTION: RED KEY indicator light may illuminate if advance key
is placed in the cup holder. The key can sometimes not be detected in the
cup holder.
ADVANCED KEYLESS ENTRY SYSTEM
This system allows you to lock and unlock the doors without taking
the key out.
While Carrying the Advanced Key…
• Unlock the driver’s door by
pushing the driver’s door request
switch once.





• Unlock all doors (and liftgate)
by pushing the driver’s door
request switch once or
twice (depending on
personalization setting)
OR by pushing the passenger’s
door request switch once.
• Lock all doors (and liftgate) by
pushing any request switch once.


• Open the liftgate by pushing
the electric liftgate opener when
ignition is OFF. With ignition ON,
vehicle must be in Park (A / T) or
have parking brake set (M/ T).
Electric Liftgate Opener
Liftgate Request Switch
Key
Lock
Unlock
Panic Alarm
Advanced KeyDoor Request Switch
1945220_16d_Mazda_CX-5_SSG_062315.indd 36/23/15 9:32 AM

5
Starting The Engine
STARTING THE ENGINE WITH
ACCELERATED WARM-UP SYSTEM (AWS)
The CX-5 is equipped with SKYACTIV combustion technology.
This technology includes AWS (Accelerated Warm-up System) for
optimal emission performance during cold starting conditions.
While Carrying the Key…
• Start the engine by pushing the START/
STOP ENGINE button while pushing the
clutch pedal (M/ T) or the brake pedal (A / T).
• What you will notice? On start-up, the
engine speed and sound are higher (1500
RPM) for less than 1 minute to quickly
bring the catalyst to efficient operating
temperature. The RPM will reduce to idle
once the temperature is achieved. This is
normal engine operation under cold
start conditions.
• What this does? This heats up the catalytic converter faster to reduce
emissions and allows Mazda to use an exhaust header on the engine
(to improve efficiency and horsepower).
NOTE: Yo u can drive the vehicle during AWS activation, no need to wait.
• Shut the engine OFF by making sure the vehicle in park (A / T) and
setting the parking brake, then push the START/STOP ENGINE button.
• Activate Accessories (ACC ) by pushing the START/STOP
ENGINE button once without pushing the clutch or brake pedal.
• Turn the ignition to the ON position by pushing the START/STOP
ENGINE button twice without pushing the clutch or brake pedal.
START/STOP Button
Indicator Light
1945220_16d_Mazda_CX-5_SSG_062315.indd 56/23/15 9:32 AM

6
Emergency Engine Stop
Pushing and holding the START/STOP button or repeatedly pushing the
button while the engine is running will turn the engine OFF. Use only in case
of an emergency.
If the START/STOP ENGINE button indicator light flashes AMBER, this
could indicate a problem with the engine starting system. You may not
be able to start the engine or switch the ignition to ACC or ON. Have your
vehicle inspected at an Authorized Mazda Dealer as soon as possible.
NOTE: The engine may not start if the key cannot be detected. The Key
Indicator Light may flash RED or “Key not detected” may be displayed if the key is
placed in the cup holder.
1945220_16d_Mazda_CX-5_SSG_062315.indd 66/23/15 9:32 AM
www.MazdaUSA.com

7
Electric Parking Brake
ELECTRIC PARKING BRAKE
The electric parking brake equipment applies the parking brake using an
electric motor. The indicator light on the electric parking brake switch turns
on when the switch is turned on.
Applying the electric parking brake:
The electric parking brake can be applied regardless of the ignition switch
position. Securely depress the brake pedal and pull up the electric parking
brake switch. The electric parking brake is applied and the brake system
warning light and the electric parking brake switch indicator light turn on.
Releasing the electric parking brake:
The electric parking brake can be released while the ignition is switched
ON or while the engine is running. When the electric parking brake is
released, the brake system warning light and the electric parking brake
switch indicator light turn off.
Electric parking brake manual release:
Depress the brake pedal and press the electric parking brake switch.
Electric parking brake automatic release:
The parking brake is released automatically when
the accelerator pedal is depressed and all of the
following conditions met:
• The engine is running.
• The driver’s door is closed.
• The driver’s seat belt is fastened.
• A/T
- Selector lever is in the D, M, or R position.
• M/T
- The gear shift is in a position other
than neutral.
- The clutch pedal is depressed halfway
Indicator Light
FUEL ECONOMY:
To achieve the
best fuel economy, visit
www.fueleconomy.gov
for more information.
1945220_16d_Mazda_CX-5_SSG_062315.indd 76/23/15 9:32 AM

8
Tires
TIRE PRESSURE MONITORING SYSTEM (TPMS)
For your safety, the CX-5 is equipped with TPMS that detects low
tire pressure in one or more tires. If the tire pressure starts getting
low in one or more tires, the system alerts the driver by turning on a
light in the instrument cluster (pp. 33-34) and sounding an alarm.
What to do? Don’t ignore the TPMS warning light. Stop and check your
tire pressure (when tires are cold) and inflate them to the proper pressure.
Properly inflated tires are safer, last longer, and increase fuel economy.
In the following cases, the TPMS must be “initialized” so the system can
operate normally.
• The tire pressure is adjusted (up or down) in one or more tires.
• A tire rotation is performed.
• Any tire or wheel is replaced.
• The vehicle’s battery is disconnected, replaced or completely dead.
Initialization Process (TPMS Warning Light is Illuminated)
1 Park the vehicle in a safe place and firmly apply the parking brake.
2 Let the tires cool, then adjust the tire pressure to the specified
pressure (See tire label located on the driver’s
side door opening) on all four (4) tires.
3 Switch the ignition ON, but leave the vehicle parked.
4 Push and hold the TPMS “Set Switch”
(left side of dash) until the TPMS warning light
in the instrument cluster flashes twice and

a beep sound is heard once.
CAUTION: If the TPMS “Set Switch” is pushed without adjusting the tire
pressure, the system cannot detect the normal tire pressure. The TPMS
warning light may not turn on, even if the tire pressure is low, or it may turn
on if the tire pressure is normal.
NOTE: Drastic changes in temperature or altitude may cause the TPMS
warning light to turn on.
1945220_16d_Mazda_CX-5_SSG_062315.indd 86/23/15 9:32 AM
www.MazdaUSA.com

18
Navigation System
NOTE: • For best results, say the full address without pausing between words.• Voice guidance can be skipped by pushing the talk button.• When prompt voice guidance is muted you will need to go into navigations settings
to turn the volume back on for the NAVI button to repeat the last instructions.
1 Turn the vehicle ignition OFF.
2 Locate the SD card slot inside the center console.
• Remove card: Open the cover and push the card once,
then pull it out.
• Insert card: Push the card in (label-side up), then close
t h e c o v e r.
To remove or insert the MAP SD card (to update the map database):
NOTE: Select
Places Nearby for POIs (points of
interest) around the selected location, or select Add to
Favorites to register the selected location to Favorites.NOTE: The route can
be edited by selecting
other options.
7 If Go is selected or if no operation is performed with 10 seconds, the
route guidance is started. The set route can be checked by selecting MAP .
Planning A Route Using Voice Commands
You can navigate to any of the following places using your voice:
• An address, including home
• Favorites
• Cities and towns
• POI (Point of Interest) categories •
POIs for named brands of, for
example, restaurants, gas stations,
car rental and gyms.
• A recent destination
NOTE: POI searches for points of interest near your present location.
To plan a route to an address using your voice, do the following:
1 Push the TA L K button on the steering wheel.
2 When you hear the tone, you can say, for example “Address”.
3 When on the enter an address screen say the full address (without zip code)
for your destination, for example “123 Main St., Los Angeles, California”.
The system does not recognize zip codes.
4 Say “Yes” if the address is correct. If shown a list of addresses, say the
list number for the correct address or say “none of these”.
SD Card
• Visit www.mazdausa.com/navigation and download the most recent
map available for your device for free for 3 years from vehicle delivery.
Please refer to the Navigation System Owners Manual section of
www.mazdausa.com/navigation for additional information.
• Only use your MAP SD card for operating and updating your navigation
system. Do not insert the MAP SD card into another vehicle or into any
other device such as a camera.
• Do not put other SD cards in this slot.
1945220_16d_Mazda_CX-5_SSG_062315.indd 186/23/15 9:32 AM
www.MazdaUSA.com

25
Blind Spot Monitoring System
NOTE: Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
• The BSM system does not operate when the vehicle speed is lower than about
6.2 mph (10 km/h).
BLIND SPOT MONITORING (BSM) SYSTEM
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• If your vehicle speed is about 6.2 mph (10 km/h) or more, the BSM
will warn you of vehicles in the detection area by illuminating the
BSM warning lights located on the left and right door mirrors.
• If you operate a turn signal in the direction of an illuminated BSM warning
light, the system will also warn you with a beep and warning light flash.
• BSM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Refer to your Owner’s Manual for complete details.
Turning BSM System Off
Turning the BSM system off will turn off both the light and sound
indicators. To manually turn the BSM system off, push the BSM
OFF switch on the dash. The BSM OFF indicator will illuminate
in the instrument cluster when the BSM system is off. The BSM
system will retain the last setting before the ignition was turned off.
Your Vehicle
Detection Areas
Image
is for
reference.
1945220_16d_Mazda_CX-5_SSG_062315.indd 256/23/15 9:33 AM

28
Wipers
WINDSHIELD/REAR WINDOW WIPER/WASHER CONTROL LEVER
Pull lever
to dispense
windshield
washer fluid
1
2
3HILO
AUTO
OFF
MIST
Rear Window

Wiper/Washer
INT: Intermittent
ON: Normal speed
:
Washer/wip er
(hold as desired)
CAUTION:
If the ignition is ON, turn the AUTO wipers OFF when going
through a car wash, or while cleaning or touching the windshield.
NOTE: Vehicles not equipped with AUTO wipers will have INT wipers. Set
the lever to INT and choose an interval timing by rotating the ring between fast
and slow.
AUTO (if equipped): The rain sensor senses the amount of rainfall and
turns the wipers on or off. Rotate inner ring away from you (clockwise) for
more (
) sensitivity (requires less rain to turn wipers on) and toward you
(counterclockwise) for less () sensitivity (requires more rain to turn wipers on).
1945220_16d_Mazda_CX-5_SSG_062315.indd 286/23/15 9:33 AM
www.MazdaUSA.com