2016 MAZDA MODEL CX-3 windshield wipers

4–106
When Driving
i-ACTIVSENSE
CAUTION
 


¾ When driving off -road in areas where there is grass or forage, it is recommended that the
Smart City Brake Support (SCBS) system be turned off .




¾ Always use tires for all wheels that are of the specifi ed size, and the same manufacturer,
brand, and tread pattern. In addition, do not use tires with signifi cantly diff erent wear
patterns on the same vehicle as the Smart City Brake Support (SCBS) system may not
operate normally.
 


¾ The laser sensor (front) includes a function for detecting a soiled windshield and informing
the driver, however, depending on the conditions, it may not detect plastic shopping bags,
ice or snow on the windshield. In such cases, the system cannot accurately determine a
vehicle ahead and may not be able to operate normally. Always drive carefully and pay
attention to the road ahead.
NOTE
 


y The Smart City Brake Support (SCBS) system will not operate if the driver is deliberately
performing driving operations (accelerator pedal and steering wheel).
 


y The Smart City Brake Support (SCBS) system will operate under the following conditions.




y The engine is running.



y The Smart City Brake Support (SCBS) warning light (amber) does not illuminate.



y The vehicle speed is between about 4 to 30 km/h (2 to 18 mph).



y The Smart City Brake Support (SCBS) system is not turned off.



y The DSC is not malfunctioning.




y The Smart City Brake Support (SCBS) detects a vehicle ahead by emitting a near-infrared
laser beam and receiving the beam refl ected off the refl ector of the vehicle ahead, and
then using it for the measurement. Consequently, the Smart City Brake Support (SCBS)
may not operate under the following conditions:
 


y Refl ection of the laser is poor due to the shape of the vehicle ahead.



y The vehicle ahead is signifi cantly dirty.



y Under bad weather condition, such as rain, fog and snow.



y The window washer is being used or the windshield wipers are not used when it's
raining.
 


y The windshield is dirty.



y The steering wheel is turned completely left or right, or the vehicle is accelerated
rapidly and comes close to the vehicle ahead.
 


y Trucks with low loading platforms and vehicles with an extremely low or high profi le.



y Vehicles with certain shapes such as a vehicle carrier.
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC










*Some models.4–118
When Driving
i-ACTIVSENSE
Laser Sensor (Front) *
Your vehicle is equipped with a laser sensor (front). The laser sensor (front) is positioned
near the rearview mirror and used by the following systems.
 


y Smart Brake Support (SBS)



y Smart City Brake Support (SCBS)
Laser sensor (front)
CAUTION
Heed the following precautions to assure correct operation of the system.




¾ Keep the windshield clean at all times.



¾ Do not apply stickers to the surface of the windshield (including transparent stickers).



¾ If cracks or damage caused by fl ying gravel or debris is visible near the laser sensor
(front), stop using the system immediately and have your vehicle inspected by an
Authorized Mazda Dealer.
  See the next page on how to turn off the system. Refer to Personalization Features on
page 9-10 .
 


¾ Do not apply a coating agent to the windshield.



¾ When replacing the windshield wipers or windshield, consult an Authorized Mazda
Dealer.
 


¾ Never remove the sensor.



¾ A removed sensor will not meet the conditions for a class 1M laser under the IEC
60825-1 specifi cation and therefore eye safety cannot be assured.
 


¾ Do not peer into the sensor using optical instruments with a magnifi cation function
such as magnifying glasses, and microscopic and objective lenses within a distance
of 100 mm (3.94 in) from the sensor.
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC










6–34
Maintenance and Care
Owner Maintenance
Wiper Blades
CAUTION
 


¾ Hot waxes applied by automatic car
washers have been known to aff ect the
wiper's ability to clean windows.
 


¾ To prevent damage to the wiper blades,
do not use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
 


¾ When the wiper lever is in the AUTO
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 


¾ If the windshield above the rain
sensor is touched.
 


¾ If the windshield above the rain
sensor is wiped with a cloth.
 


¾ If the windshield is struck with a hand
or other object.
 


¾ If the rain sensor is struck with a hand
or other object from inside the vehicle.
  Be careful not to pinch hands or fi ngers
as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.
Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
Replacing Windshield Wiper
Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION
To prevent damage to the wiper arms
and other components, do not try to
sweep the wiper arm by hand.
NOTE
When raising both windshield wiper arms,
raise the driver's side wiper arm fi rst.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side fi rst while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windshield.
1. Raise the wiper arm.
2. Open the clip and slide the blade
assembly in the direction of the arrow.
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC










6–60
Maintenance and Care
Appearance Care
Maintaining the Finish
Washing
CAUTION
 


¾ When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 


¾ If the windshield above the rain
sensor is touched or wiped with a
cloth.
 


¾ If the windshield is struck with a hand
or other object from either outside or
inside the vehicle.
  Keep hands and scrapers clear of the
windshield when the wiper lever is in the
position and the ignition is
switched ON as fi ngers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
  If you are going to clean the windshield,
be sure the wipers are turned off
completely (when it is most likely
that the engine is left running) this is
particularly important when clearing ice
and snow.
 


¾ Do not spray water in the engine
compartment. Otherwise, it could result
in engine-starting problems or damage
to electrical parts.
 


¾ When washing and waxing the vehicle,
be careful not to apply excessive force to
any single area of the vehicle roof or the
antenna. Otherwise, you could dent the
vehicle or damage the antenna.
To help protect the fi nish from rust
and deterioration, wash your Mazda
thoroughly and frequently, at least once a
month, with lukewarm or cold water. If the vehicle is washed improperly, the
paint surface could be scratched. Here are
some examples of how scratching could
occur.
Scratches occur on the paint surface when:
 


y The vehicle is washed without fi rst
rinsing off dirt and other foreign matter.
 


y The vehicle is washed with a rough, dry,
or dirty cloth.
 


y The vehicle is washed at a car wash that
uses brushes that are dirty or too stiff.
 


y Cleansers or wax containing abrasives
are used.
NOTE
 


y Mazda is not responsible for scratches
caused by automatic car washes or
improper washing.
 


y Scratches are more noticeable on
vehicles with darker paint fi nishes.
To minimize scratches on the vehicle's
paint fi nish:




y Rinse off any dirt or other foreign matter
using lukewarm or cold water before
washing.
 


y Use plenty of lukewarm or cold water
and a soft cloth when washing the
vehicle. Do not use a nylon cloth.
 


y Rub gently when washing or drying the
vehicle.
 


y Take your vehicle only to a car wash
that keeps its brushes well maintained.
 


y Do not use abrasive cleansers or wax
that contain abrasives.
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC










9–14
Specifi cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings change method
Vehicle Auto-wiper
control
Refer to
Windshield
Wipers and
Washer on page
4-47 . The auto-wiper control
function can be
changed. On On/Off
*4 Refer to
Settings
on page
5-53 . —
Daytime
running lights
Refer to
Daytime
Running Lights
on page 4-45 . The function of the
daytime running lights
can be changed. On On/
Off
Refer to
Settings
on page
5-53 . —
Auto headlight
off *5
Refer to
Headlights on
page 4-41 . The time required
for headlights to turn
off after ignition is
switched off can be
changed. 30 seconds
120 seconds/ 90 seconds/
60 seconds/
30 seconds/
Off
*6
Refer to
Settings
on page
5-53 . —
Auto-light
control
Refer to
Headlights on
page 4-41 . The headlight
illumination on/
off timing based on
surrounding lightness/
darkness can be
changed. Medium High/
Med. High/
Medium/
Med. Low/
Low Refer to
Settings
on page
5-53 . —
High Beam
Control System
(HBC)
Refer to High
Beam Control
System (HBC)
on page 4-71 . The High Beam Control
System (HBC) function
can be changed.
*1 On On/Off Refer to
Settings
on page
5-53 . —
Adaptive
Front Lighting
System (AFS)
Refer to
Adaptive
Front Lighting
System (AFS)
on page 4-70 . The Adaptive Front
Lighting System
(AFS) function can be
changed.
*1
On On/Off Refer to
Settings
on page
5-53 . —
Lights-on
reminder*7
Refer to Lights-
On Reminder
on page 7-39 . The volume of the
lights-on reminder
warning alarm can be
changed. Off High/Low/
Off Refer to
Settings
on page
5-53 . —
Coming home
light system
Refer to
Coming Home
Light System
on page 4-44 . The time required for
the headlights to turn
off after closing all
of the doors can be
changed. 30 seconds 120 seconds/ 90 seconds/
60 seconds/
30 seconds/
Off Refer to
Settings
on page
5-53 . —
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC










10–8
Index
V
Vanity Mirrors ................................... 5-131
Vehicle Information Labels ................... 9-2
W
Warning Lights .................................... 4-25
Warning Sound is Activated ................ 7-39 Air Bag/Front Seat Belt Pretensioner
System Warning Beep ................... 7-39
Blind Spot Monitoring (BSM) System
warning beep ................................. 7-42
Collision warning .......................... 7-42
Ignition not switched off (STOP)
warning beep ................................. 7-40
Key left-in-luggage compartment
warning beep (With the advanced
keyless function) ........................... 7-41
Key left-in-vehicle warning beep (With
the advanced keyless function) ..... 7-41
Key removed from vehicle warning
beep ............................................... 7-41
Lane Departure Warning System
(LDWS) warning sound ................ 7-42
Lights-on reminder ........................ 7-39
Mazda Radar Cruise Control (MRCC)
System warnings ........................... 7-42
Over Rev. buzzer ........................... 7-43
Power steering warning buzzer ..... 7-42
Request switch inoperable warning
beep (With the advanced keyless
function) ........................................ 7-41
Seat belt warning beep .................. 7-40
Tire infl ation pressure warning
beep ............................................... 7-41
Warranty .............................................. 8-15
Weights.................................................. 9-6
Windows Power windows ............................. 3-30
Windshield Washer ............................. 4-51
Windshield Wipers .............................. 4-48
Winter Driving .................................... 3-41 Wiper
Replacing Windshield Wiper
Blades ............................................ 6-34
Replacing Rear Window Wiper
Blade ............................................. 6-35
$9@&)&"#@&EJUJPOJOEC


$9@&)&"#@&EJUJPOJOEC