4–13
When Driving
Instrument Cluster and Display
NOTE
When the ignition is switched to ACC or
off, the odometer or trip meters cannot be
displayed, however, pressing the selector
can inadvertently switch the trip meters or
reset them during an approximate ten-
minute period in the following cases:
After the ignition is switched to off from
ON. After the driver's door is opened.
Odometer
The odometer records the total distance
the vehicle has been driven.
Trip meter
The trip meter can record the total distance
of two trips. One is recorded in trip meter
A, and the other is recorded in trip meter
B.
For instance, trip meter A can record the
distance from the point of origin, and
trip meter B can record the distance from
where the fuel tank is filled.
When trip meter A is selected, pressing
the selector again within one second will
change to trip meter B mode.
When trip meter A is selected, TRIP A
will be displayed. When trip meter B is
selected, TRIP B will be displayed.
The trip meter records the total distance
the vehicle is driven until the meter
is again reset. Return it to “0.0” by
depressing and holding the selector for
one second or more. Use this meter to
measure trip distances and to compute fuel
consumption.
NOTE
(Vehicles with type B audio)
If the fuel economy data is reset using
the fuel economy monitor, or trip A
is reset using the trip meter when the
function which synchronizes the fuel
economy monitor and the trip meter is
on, the fuel economy data and trip A are
reset simultaneously.
Refer to Fuel Economy Monitor on page
4-69. Only the trip meters record tenths of
kilometers (miles). The trip record will be erased when:
The power supply is interrupted
(blown fuse or the battery is
disconnected).
The vehicle is driven over 9999.9 km
(mile).
Mazda3_8FA4-EA-15G_Edition1.indb 132015/05/11 14:00:35
4–17
When Driving
Instrument Cluster and Display
NOTE
Even though the distance-to-empty
display may indicate a sufficient amount
of remaining driving distance before
refueling is required, refuel as soon as
possible if the fuel level is very low or
the low fuel warning light illuminates.
The display may not change unless you
add more than approximately 9 L (2.3
US gal, 1.9 Imp gal) of fuel.
The distance-to-empty is the
approximate remaining distance the
vehicle can be driven until all the
graduation marks in the fuel gauge
(indicating the remaining fuel supply)
disappear.
If there is no past fuel economy
information such as after first
purchasing your vehicle or the
information is deleted when the battery
cables are disconnected, the actual
distance-to empty/range may differ from
the amount indicated.
Average fuel economy mode
This mode displays the average fuel
economy by calculating the total fuel
consumption and the total traveled
distance since purchasing the vehicle, re-
connecting the battery after disconnection,
or resetting the data. The average fuel
economy is calculated and displayed every
minute.
To clear the data being displayed, press the
INFO switch for more than 1.5 seconds.
After pressing the INFO switch, - - - L/100
km (- - - mpg) will be displayed for about
1 minute before the fuel economy is
recalculated and displayed.
Current fuel economy mode
This mode displays the current fuel
economy by calculating the amount of fuel
consumption and the distance traveled.
Current fuel economy will be calculated
and displayed every 2 seconds.
When you've slowed to about 5 km/h (3
mph), - - - L/100 km (- - - mpg) will be
displayed.
Average vehicle speed mode
This mode displays the average vehicle
speed by calculating the distance and the
time traveled since connecting the battery
or resetting the data.
Average vehicle speed will be calculated
and displayed every 10 seconds.
To clear the data being displayed, press the
INFO switch for more than 1.5 seconds.
After pressing the INFO switch, - - - km/h
(- - - mph) will be displayed for about
1 minute before the vehicle speed is
recalculated and displayed.
Mazda3_8FA4-EA-15G_Edition3.indb 172015/12/04 19:22:39
4–69
When Driving
Fuel Economy Monitor
*Some models.
Fuel Economy Monitor*
For vehicles with type B audio, the Control Status and Fuel Consumption are switched and
displayed by operating each icon in the display.
In addition, after completing a trip, the total energy efficiency to date is displayed in the
ending display when the ending display is turned on.
1. Select the icon on the home screen to display the applications screen.
2. Select the “Fuel Economy Monitor”.
3. Operate the commander switch or touch the screen and display the menu.
NOTE
When the menu is displayed by touching the screen, the display is hidden automatically after
6 seconds.
4. Select the icon in the menu and perform the operation. Each icon operates as follows:
Indication on displayControl status
Hides the menu display.
Displays the application screen.
Switches the Fuel Economy Monitor in the order of Control Status and Fuel Consumption.
Resets the fuel economy data.
Displays the following setting screen.Ending display on/off switchingOn/off switching for function which synchronizes
reset fuel economy data to trip meter (Trip A)
Fuel Consumption Display
Information regarding the fuel economy is displayed.
Indication on display Control status
Displays the fuel economy for the past 60 minutes.Displays the fuel economy every minute for the
past 1 to 10 minutes.
Displays the fuel economy every 10 minutes for the past 10 to 60 minutes.
Displays the average fuel economy over the past 5 resets and after the current reset.
Calculates the average fuel economy every minute after vehicle travel begins, and displays it.
Mazda3_8FA4-EA-15G_Edition1.indb 692015/05/11 14:00:58
4–71
When Driving
Drive Selection
*Some models.
Drive Selection*
Drive selection is a system to switch the vehicle's drive mode. When the sport mode
is selected, vehicle's response against accelerator operation is enhance\
d. This provides
additional quick acceleration which may be needed to safely make maneuvers such as lane
changes, merging onto freeways, or passing other vehicles.
CAUTION
Do not use the sport mode when driving on slippery roads such as wet or snow-covered
roads. It may cause tire slipping.
NOTE
When the sport mode is selected, driving at higher engine speeds increases and it may
increase fuel consumption. Mazda recommends that you cancel the sport mode on normal
driving.
Drive mode cannot be switched in the following conditions:
ABS/TCS/DSC is operating The Mazda Radar Cruise Control (MRCC) system/cruise control is operating. Steering wheel is being operated abruptly
Mazda3_8FA4-EA-15G_Edition1.indb 712015/05/11 14:00:59
5–57
Interior Features
Audio System
*Some models.
Applications
NOTE
Depending on the grade and specification,
the screen display may differ.
Select the
icon on the home screen to
display the Applications screen. The
following information can be verified.
Top screenItemFunction
HD
Radio™
Traffic
Map —
—
Fuel
Economy
Monitor Fuel Consumption
Control Status
(Vehicles with
i-ELOOP)
Settings Refer to Fuel
Economy Monitor
on page 4-69.
Maintenance
Scheduled
Maintenance
Tire Rotation
Oil ChangeRefer to
Maintenance
Monitor (Type B
audio) on page
6-21.
Warning
Guidance Warnings
currently active
can be verified. Refer to If a
Warning Light
Turns On or
Flashes on page
7-24.
Audio Control Switch
Operation
*
Without Bluetooth® Hands-Free
With Bluetooth® Hands-Free
Mazda3_8FA4-EA-15G_Edition1.indb 572015/05/11 14:01:40
10–4
Index
FluidsClassification
...................................9-5
Fog Lights
...........................................4-46
Foot Brake
...........................................4-58
Forward Sensing Camera (FSC)
.......4-111
Front Seat
..............................................2-5
Fuel Filler lid and cap ............................ 3-29
Gauge
............................................4-14
Requirements ................................. 3-26
Tank capacity
..................................9-5
Fuel Consumption Display
.................4-69
Fuel Economy Monitor
.......................4-69
Control status display
....................4-70
Ending screen display
...................4-70
Fuel consumption display
.............4-69
Fuses
...................................................6-63
Panel description
...........................6-65
Replacement
..................................6-63
G
Gauges .................................................4-11
Glove Compartment
..........................5-140
H
Hazard Warning Flasher ......................4-54
Hazardous Driving
..............................3-45
Head Restraint
.....................................2-11
Headlights Control ........................................... 4-40
Flashing
.........................................4-44
High-low beam
..............................4-44
Leveling ......................................... 4-44
High Beam Control System (HBC)
....4-77
High Beam Control System (HBC)
indicator light (green)
....................4-79
Hill Launch Assist (HLA)
...................4-60
HomeLink Wireless Control System ...4-54
Hood Release
......................................6-24
Horn
....................................................4-53
I
i-ACTIVSENSE ..................................4-74
Active safety technology
...............4-74
Adaptive Front Lighting System
(AFS)
.............................................4-76
Blind Spot Monitoring (BSM)
......4-86
Camera and sensors
.......................4-75
Forward Sensing Camera (FSC) ...4-111
High Beam Control System
(HBC)
............................................4-77
Lane Departure Warning System
(LDWS)
.........................................4-80
Laser sensor (front)
.....................4-116
Mazda Radar Cruise Control
(MRCC) ......................................... 4-98
Pre-crash safety technology
..........4-74
Radar sensor (front) .....................4-113
Radar sensors (rear) .....................4-118
Rear Cross Traffic Alert (RCTA) ...4-92
Smart City Brake Support
(SCBS)
........................................4-106
i-ELOOP
.............................................4-66
Control status display
....................4-68
Display
..........................................4-66
i-ELOOP indicator light
................4-68
i-ELOOP warning beep
.......................7-37
If a Warning Light Turns On or
Flashes................................................. 7-24
If the Active Driving Display does not
operate
.................................................7-42
Ignition Switch
..............................................4-4
Ignition not switched off (STOP) warning
beep
.....................................................7-36
Immobilizer System
............................3-40
Indicator Lights
...................................4-23
Low engine coolant temperature
...4-25
Wrench
..........................................4-25
Inside Trunk Release Lever
................3-24
Inspecting Brake/Clutch Fluid Level ...6-32
Inspecting Coolant Level
....................6-30
Inspecting Engine Oil Level
...............6-30
Mazda3_8FA4-EA-15G_Edition1.indb 42015/05/11 14:03:02