2016 LEXUS NX300H remote control

5337-3. Do-it-yourself maintenance
7
Maintenance and care
NX300h_OM_USA_OM78082U
■Use a CR2032 lithium battery
●Batteries can be purchased at your Lexus dealer, local electrical appliance shops or
camera stores.
●Replace only with the same or equivalent type recommended by the manufacturer.
●Dispose of used batteries according to the local laws.
■When the card key battery needs to be replaced (if equipped)
The battery for the card key is available only at Lexus dealers. Your Lexus dealer can
replace the battery for you.
■If the electronic key battery is depleted
The following symptoms may occur:
●The smart access system with push-button start and wireless remote control will not
function properly.
●The operational range will be reduced.
WA R N I N G
■Removed battery and other parts
These parts are small and if swallowed by a child, they can cause choking. Keep away
from children. Failure to do so could result in death or serious injury.
NOTICE
■For normal operation afte r replacing the battery
Observe the following precautions to prevent accidents:
●Always work with dry hands.
Moisture may cause the battery to rust.
●Do not touch or move any other component inside the remote control.
●Do not bend either of the battery terminals.

591
8
When trouble arises
8-2. Steps to take in an emergency
NX300h_OM_USA_OM78082U
If the electronic key do es not operate properly
Use the mechanical key (P. 119) to perform the following operation
■Unlocking the door
Insert the mechanical key while pull-
ing on the driver’s door handle.
Unlocking the door.
Remove the key, return the handle, and then pull the handle again.
If communication between the electron ic key and vehicle is interrupted
(  P. 142) or the electronic key cannot be used because the battery is
depleted, the smart access system with push-button start and wireless
remote control cannot be used. In such cases, the doors can be opened and
the hybrid system can be started by following the procedure below.
Locking and unlocking the doors
1
2
3

5968-2. Steps to take in an emergency
NX300h_OM_USA_OM78082U
Start the engine of the second vehicle. Increase the engine speed slightly and
maintain at that level for approximately 5 minutes to recharge the 12-volt bat-
tery of your vehicle.
Open and close any of the doors of your vehicle with the power switch off.
Maintain the engine speed of the second vehicle and start the hybrid system
of your vehicle by turning the power switch to ON mode.
Make sure the “READY” indicator comes on. If the indicator light does not
come on, contact your Lexus dealer.
Once the hybrid system has started, remove the jumper cables in the exact
reverse order from which they were connected.
Close the exclusive jump starting terminal cover, and reinstall the fuse box
cover to its original position.
Once the hybrid system starts, have th e vehicle inspected at your Lexus dealer
as soon as possible.
■Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
●Turn off any unnecessary electrical components when the vehicle is running at a low
speed for an extended period, such as in heavy traffic.
■Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and th e draining effects of certain electrical appli-
ances. If the vehicle is left for a long time, the 12-volt battery may discharge, and the
hybrid system may be unable to start. (The 12-volt battery recharges automatically while
the hybrid system is operating.)
■When the 12-volt battery is removed or discharged
●In some cases, it may not be possible to unlock the doors using the smart access system
with push-button start when the 12-volt battery is discharged. Use the wireless remote
control or the mechanical key to lock or unlock the doors.
●The hybrid system may not start on the first attempt after the 12-volt battery has
recharged but will start normally after the second attempt. This is not a malfunction.
●The power switch mode is memorized by the vehicle. When the 12-volt battery is
reconnected, the system will return to the mode it was in before the 12-volt battery was
discharged. Before disconnecting the 12-volt battery, turn the power switch off.
If you are unsure what mode the power switch was in before the 12-volt battery dis-
charged, be especially careful when reconnecting the 12-volt battery.
●The power back door must be initialized. ( P. 1 3 4 )
6
7
8
9
10
11

6319-2. Customization
9
Vehicle specifications
NX300h_OM_USA_OM78082U
Customizable features
Some function settings are changed simultaneously with other functions being
customized. Contact your Lexus dealer.
When customizing vehicle features, ensure that the vehicle is parked in a safe
place with the shift lever in P and the parking brake set.
■Changing using the Remote TouchPress the “MENU” button on the Remote Touch.
Select “Setup” on the “MENU” screen and select “Vehicle”.
Various setting can be changed. Refer to the list of settings that can be
changed for details.
■Changing using the Lexus Display Audio controller Press the “MENU” button on the Lexus Display Audio controller.
Select “Setup” on the “MENU” screen and select “Vehicle”.
Various setting can be changed. Refer to the list of settings that can be
changed for details.
■Changing using the multi-information display
Press or of the meter control switches, select , and then
press .
Press or of the meter control switches, select the item, and then
press .
Press or of the meter control switches, select the desired setting,
and then press .
To go back to the previous screen or exit the customize mode, press .
Your vehicle includes a variety of electronic features that can be personalized
to suit your preferences. The settings of these features can be changed using
the multi-information display, the Remo te Touch or Lexus Display Audio con-
troller, or at your Lexus dealer.
Customizing vehicle features
1
2
1
2
1
2
3

6329-2. Customization
NX300h_OM_USA_OM78082U
Settings that can be changed using the Remote Touch or Lexus Display Audio
controller
Settings that can be changed us ing the multi-information display
Settings that can be changed by your Lexus dealer
Settings that can be changed using the vehicle switch
Definition of symbols: O = Available, – =Not available
■Door lock ( P. 1 2 4 , 5 9 1 )
Customizable Features
1
2
3
4
FunctionDefault
settingCustomized setting
Unlocking using a mechanical
key
Driver’s door
unlocked in first
step, all doors
unlocked in
second step
All doors
unlocked in first
step––O–
Automatic door locking func-
tion
Shift position
linked door
locking opera-
tionOffO–O–
Speed linked
door locking
operationO–O–
Automatic door unlocking
function
Shift position
linked door
unlocking oper-
ationOffO–O–
Driver’s door
linked door
unlocking oper-
ation
O–O–
1234

6339-2. Customization
9
Vehicle specifications
NX300h_OM_USA_OM78082U
■Smart access system with push-button start and wireless remote control
( P. 124, 140)
■Smart access system with push-button start ( P. 1 4 0 )
FunctionDefault
settingCustomized setting
Operation signal (emergency
flashers)OnOffO–O–
Operation buzzer volume5OffO–O–1 to 7
Time elapsed before the auto-
matic door lock function is
activated if a door is not
opened after being unlocked
60 seconds
Off
O–O–30 seconds
120 seconds
Open door reminder buzzer
(When locking the vehicle)OnOff––O–
1234
FunctionDefault settingCustomized setting
The doors that are unlocked
using the smart access system
with push-button start can be
selected Driver’s door All the doors O – O O
Smart access system with
push-button start On Off – – O –
Number of consecutive door
lock operations 2 timesAs many as
desired ––O–
1234

6349-2. Customization
NX300h_OM_USA_OM78082U
■Wireless remote control ( P. 1 2 4 )
■Automatic light control system ( P. 2 1 9 )
■Lights (P. 2 1 9 )
FunctionDefault
settingCustomized setting
Wireless remote control OnOff – – O –
Unlocking operation Driver’s door
unlocked in first
step, all doors
unlocked in
second stepAll doors
unlocked in first
step
O–O–
Panic function OnOff – – O –
The function that validates the switch of the wireless
remote control when locking
the door ( P. 1 2 9 ) When locking
the door
When unlock-
ing the door
––O–
1234
FunctionDefault
settingCustomized setting
Light sensor sensitivityStandard-2 to 2O–O–
Adjust the time elapsed
before the headlights auto-
matically turn off 30 seconds
Off
O–O–
60 seconds
90 seconds
1234
FunctionDefault settingCustomized setting
Daytime Running Lights
(Daytime running lights can
be disabled)OnOffO–O–
1234

6379-2. Customization
9
Vehicle specifications
NX300h_OM_USA_OM78082U
■Automatic air conditioning system (P. 4 3 0 )
■Eco drive mode ( P. 3 0 3 )
■Powe r w i n d ow s ( P. 166)
■Moon roof*1 ( P. 1 6 9 )
*1:If equipped
*2: This function cannot be customized unless power window operations, using the wire-
less remote control or mechanical key, is enabled.
FunctionDefault settingCustomized setting
Switching between outside air
and recirculated air mode
linked to “AUTO” switch
operation
OnOffO–O–
A/C Auto switch operationOnOffO–O–
1234
FunctionDefault settingCustomized setting
Heating/cooling operation
minimized in Eco drive modeOnOff––O–
1234
FunctionDefault settingCustomized setting
Mechanical key linked opera-
tionOffOn––O–
Wireless remote control
linked open operationOffOn––O–
1234
FunctionDefault
settingCustomized setting
Mechanical key linked opera-
tion
*2OffOn––O–
Wireless remote control
linked open or Tilt up opera-
tions
*2OffOn––O–
1234