91
ES350_QG_OM33B82U_(U)
Garage Door Opener
nProgramming HomeLink®
The HomeLink® wireless control system in your vehicle has 3 buttons which can be
programmed to operate 3 di fferent devices. Refer to the programming methods on
the following pages to determine the method which is appropriate for the device.
HomeLink
® indicator light
Garage door operation indicators
HomeLink
® icon
Illuminates while HomeLink
® is
operating.
Buttons
n Programming HomeLink®
Press and release the HomeLink® button you want to program and check that
the HomeLink
® indicator light flashes (orange).
Perform within 60 seconds of , or the indicator light will stop flashing and
programming will not be able to be completed.
Point the remote control transmitter
for the device at the rear view mir-
ror, 1 to 3 in. (25 to 75 mm) from
the HomeLink
® buttons.
Keep the HomeLink
® indicator
light in view while programming.
For U.S.A. owners Press and hold the handheld trans-
mitter button until the HomeLink
®
indicator light changes from slowly
flashing orange to rapidly flashing
green (rolling code) or continu-
ously lit green (fixed code), then
release the button.
The garage door opener can be programmed to operate garage doors, gates, entry
doors, door locks, home lighting systems, security systems, and other devices.
1
2
3
4
1
31
2
3
92
ES350_QG_OM33B82U_(U)
Programming an entry gate (for U.S.A. owners)/Programming a device in the
Canadian market
Press and release the remote control transmitter button at 2 second intervals,
repeatedly, until the HomeLink
® indicator light changes from slowly flashing
(orange) to rapidly flashing (green) (rolling code) or continuously lit (green)
(fixed code).
Test the HomeLink
® operation by pressing the newly programmed button and
observing the indicator light:
l Device with fixed code: If the indicator light is solid/continuous, program- ming has been completed and your garage door or other device should oper-
ate when the HomeLink
® button is pressed and released.
l Device with rolling code: If the indicator light flashes rapidly, your garage door opener motor (or other device) is equipped with a rolling code. Com-
plete the programming process by firmly pressing and holding the pro-
grammed HomeLink
® button for 2 seconds and then release the button.
l If the garage door or other device doe s not operate, proceed to “Program-
ming a rolling code system”.
Repeat the steps above to program an other device for any of the remaining
HomeLink
® buttons.
n Programming other devices
For U.S.A. owners:
To program an entry gate, see the OWNER’S MANUAL.
To program other devices, contact your Lexus dealer.
For Canadian owners: To program all other devices, follow the same procedure as for garage door pro-
gramming.
n Operating HomeLink®
Press the appropriate HomeLink® button. The HomeLink® indicator light should
turn on.
3
4
5
