2016 JEEP WRANGLER warning

[x] Cancel search: warning

Page 523 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual WARNING!(Continued)
•Failure to equip your vehicle with tires having
adequate speed capability can result in sudden tire
failure and loss of vehicle control.
CAUTION!
Replacing original tires with t

Page 526 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual also increase as the vehicle is driven; this is normal and
there should be no adjustment for this increased pres-
sure.
The TPMS will warn the driver of a low tire pressure if
the tire pressure falls

Page 527 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual psi (207 kPa), but the “Tire Pressure Monitoring Telltale
Light” will still be ON. In this situation, the “Tire
Pressure Monitoring Telltale Light” will turn OFF only
after the tires have been

Page 530 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual 3. Lots of snow or ice around the wheels or wheelhousings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
Vehicles not equipped with EVIC will inform the dri

Page 531 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual If you install the spare tire in place of a road tire that
has a pressure below the low-pressure warning limit,
upon the next ignition key cycle, a chime will sound
and the “Tire Pressure Monitoring

Page 532 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual NOTE:It is particularly important, for you to regularly
check the tire pressure in all of your tires and to maintain
the proper pressure.
The Tire Pressure Monitor System (TPMS) consists of the
follow

Page 533 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual Should a low tire condition occur on any of the four
active road tire(s), you should stop as soon as possible,
and inflate the low tire(s) that is “flashing” on the graphic
display to the vehicle

Page 534 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual in place of the pressure value(s), indicating which Tire
Pressure Monitoring Sensor(s) is not being received.
If the ignition switch is cycled, this sequence will repeat,
providing the system fault st