2016 JEEP GRAND CHEROKEE warning

[x] Cancel search: warning

Page 461 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual ENGINE START/STOP Button Functions — With
Driver ’s Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates similar to an
ignition switch. It has four position

Page 462 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual WARNING!(Continued)
•Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the cataly

Page 467 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual If the “SERVICE STOP/START SYSTEM” message ap-
pears in the DID, have the system checked by your
authorized dealer.
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine, an

Page 468 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual WARNING!(Continued)
•Unintended movement of a vehicle could injure
those in or near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a v

Page 473 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual PARK (P)
This range supplements the parking brake by locking the
transmission. The engine can be started in this range.
Never attempt to use PARK while the vehicle is in
motion. Apply the parking brak

Page 474 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual WARNING!(Continued)
someone or something. Only shift into gear when
the engine is idling normally and your foot is
firmly pressing the brake pedal.
• Unintended movement of a vehicle could injure
th

Page 476 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual brake and shift the transmission into PARK if you must
leave the vehicle.
WARNING!
Do not coast in NEUTRAL and never turn off the
ignition to coast down a hill. These are unsafe
practices that limit y

Page 480 of 745

JEEP GRAND CHEROKEE 2016 WK2 / 4.G Owners Manual •Transmission shifting will be more noticeable when
AutoStick is enabled.
• The system may revert to automatic shift mode if a
fault or overheat condition is detected.
NOTE: When Selec-Speed or Hi