2016 Hyundai Sonata Hybrid USB port

6-12 I Voice Recognition
Media Commands
* Check the following before you use media commands.
1.
If no media is connected or if no playable files exist at the time when you use these commands, a voice message will tell you
that this is not available.
2. If you say the name of the media that is currently playing again, then that media will continue playing.
e.g.) Saying “USB” while USB content is playing.
Command Operation
"J Music Continues the last media you played.
"J iPod Plays the iPod currently connected. This
will work the same when an iPhone is con-
nected. If a USB is connected, then it will
be played instead of the iPod.
"J USB Plays the music on the USB currently con-
nected.
If an iPod is connected, then the iPod will
be played instead of the USB.
"J Bluetooth Audio Plays the music on the Bluetooth phone
currently connected.
This may not be supported depending on
the Bluetooth connection status.
"J AUX Plays external devices that are currently
connected.
"J My Music Plays My Music files stored in the system.
"J Pandora Radio Plays Pandora Radio that is currently con-
nected.
)@-'&@(<64"@/>
1BSUJOEE


 )@-'&@(<64"@/>
1BSUJOEE





10-6 I Appendix
Problem Possible Cause Countermeasure
The USB
does not
work
!Ÿ
USB memory is
damaged

!Ÿ
USB memory has
been contaminated

!Ÿ
A separately pur-
chased USB HUB is
being used

!Ÿ
A USB extension
cable is being used

!Ÿ
A USB which is not
a Metal Cover Type
USB Memory is
being used

!Ÿ
An HDD type, CF,
SD Memory is being
used

!Ÿ
There are no music
files which can be
played
!Ÿ
Please use after formatting
the USB into FAT 12/16/32
format

!Ÿ
Remove any foreign sub-
stances on the contact surface
of the USB memory and
multimedia terminal

!Ÿ
Directly connect the USB
memory with the multimedia
terminal on the vehicle

!Ÿ
Directly connect the USB
memory with the multimedia
terminal on the vehicle

!Ÿ
Use standard USB Memory

!Ÿ
Use standard USB Memory

!Ÿ
Only MP3, WMA file formats
are supported. Please use
only the supported music file
formats
The iPod is
not recog-
nized even
though it has
been
connected
!Ÿ
There are no titles
which can be played

!Ÿ
The iPod firmware
version has not
been properly
updated

!Ÿ
The iPod device
does not recognize
downloads

!Ÿ
Use iTunes to download and
save MP3 files into the iPod

!Ÿ
Use iTunes to update the firm-
ware version and reconnect the
iPod with the device

!Ÿ
Reset the iPod and reconnect
with the device
i Information
While operating the device, if an abnormality occurs that cannot be
corrected with the abo
ve described measures, press the
RESET
key to
reset the system.
Press and hold the
RESET key (over 1 second). The device power will
turn off and the system will reset.
)@-'&@(<64"@/>
1BSUJOEE


 )@-'&@(<64"@/>
1BSUJOEE


 

36
Precautions Required
for Successful Voice
Recognition
1. Voice recognition supports only
the commands that are displayed
on the screen and written in the
User’s Guide.
2. To ensure the correct recognition
and execution of your command,
say your command when you hear
the beep after a voice prompt.
3. Voice recognition automatically
ends if:
1) A call is incoming or outgoing
2) A media (USB or iPod, etc.) is
connected or disconnected
3) The front or rear view camera
is operated (optional)
4) The car engine starts or stops
5) A system key, such as
RADIO key or MEDIA key is
selected
6) An emergency occurs, for
example re-searching for the
route after the navigation
route has been lost 4.
The microphone that recognizes
your voice is located over the
head part in the driver’s seat.
To make your commands bet-
ter understood, keep your body
straight in the driver’s seat when
speaking the command.
5. Speaking naturally and clearly will
ensure better recognition of your
voice commands.
6. In the following cases voice rec-
ognition will be affected by ambi-
ent noise.
1) The sound of the wind if any
window or the sun roof is
open.
2) High speed blower from the
air v

ents. Set climate control
to blow lower than level 3.
3)


Vibrations from passing
through a tunnel.
4) Vibrations from driving on an
uneven road.
5) Storms and heavy rain.
Voice Recognition
)@-'&@(<64"@/>
23(JOEE


 <64"@/>
23(JOEE


 


ß
1
 

45
Media Commands
* Check the following before you use media commands.
1.

If no media is connected or if no playable files exist at the time when you use these
commands, a voice message will tell you that this is not available.
2. If you say the name of the media that is currently playing again, then that media will continue playing.
e.g.) Saying “USB” while USB content is playing.
Command Operation
"J Music Continues the last media you played.
"J iPod Plays the iPod currently connected. This will work the
same when an iPhone is connected. If a USB is con-
nected, then it will be played instead of the iPod.
"J USB Plays the music on the USB currently connected.
If an iPod is connected, then the iPod will be played
instead of the USB.
"J Bluetooth Audio Plays the music on the Bluetooth phone currently connected.
This may not be supported depending on the Bluetooth
connection status.
"J AUX Plays external devices that are currently connected.
"J My Music Plays My Music files stored in the system.
"J Pandora Radio Plays Pandora Radio that is currently connected.
1. Audio CD Command
Command Operation
!¹ Play Plays a paused track.
Maintains the current settings during playback.
!¹ Pause Pauses a track that is currently playing.
Maintains current settings while paused during playback.
!¹ Track <1~99> Plays a desired track number.
!¹ Shuffle Plays tracks or files randomly.
Maintains current settings during shuffled playback.
!¹ Shuffle Off Cancels Shuffle and plays tracks sequentially.
Maintains current settings during sequential playback.
!¹ Repeat Plays the current track repeatedly.
Maintains the current settings during repeat playback.
!¹ Repeat Off Cancels Repeat and plays multiple tracks or files.
Maintains current settings during multiple track playback.
)@-'&@(<64"@/>
23(JOEE



<64"@/>
23(JOEE


 


ß
1