2016 HYUNDAI I20 inflation pressure


"&t%'s%st&'!"'%!'&&The air bag modules are located
both in the center of the steering
wheel and in the front passenger's
panel above the glove box. When the
SRSCM detects a sufficiently severe
impact to the front of the vehicle, it
will automatically deploy the front air
bags. Upon deployment, tear seams mold
ed directly into the pad covers will
separate under pressure from the
expansion of the air bags. Further
opening of the covers then allows full
inflation of the air bags.
If any of the following conditions
occurs, this indicates a malfunc
tion of the SRS. We recommend
that the system be inspected by
an authorized HYUNDAI dealer.
•The light does not turn on briefly
when you turn the ignition ON.
•The light stays on after illuminat
ing for approximately 6 seconds.
•The light comes on while the
vehicle is in motion.
•The light blinks when the ignition
switch is in ON position.
WARNING
B240B01L

Driver’s front air bag (1)
B240B02L
Driver’s front air bag (2)

AAt least monthly:• Check the coolant level in theengine coolant reservoir.
• Check the operation of all exterior lights, including the stoplights, turn
signals and hazard warning flash-
ers.
• Check the inflation pressures of all tires including the spare for tires
that are worn, show uneven wear,
or are damaged.
• Check for loose wheel lug nuts.
At least twice a year (i.e., every Spring and Fall):• Check the radiator, heater and air
conditioning hoses for leaks or
damage.
• Check the windshield washer spray and wiper operation. Clean
wiper blades with clean cloth
dampened with washer fluid.
• Check the headlight alignment.
• Check the muffler, exhaust pipes, shields and clamps.
• Check the lap/shoulder belts for wear and function.
At least once a year:• Clean the body and door drainholes.
• Lubricate the door hinges and checks, and hood hinges.
• Lubricate the door and hood locks and latches.
• Lubricate the door rubber weather- strips.
• Check the air conditioning system.
• Inspect and lubricate Continuously Variable Transaxle linkage and
controls.
• Clean the battery and terminals.
• Check the brake/clutch fluid level.
1.1
,204/3424-3

1.)1
,204/3424-3
!$# "#$$#Tire care For proper maintenance, safety, and
maximum fuel economy, you must
always maintain recommended tire
inflation pressures and stay within
the load limits and weight distribution
recommended for your vehicle. Recommended cold tire inflation
pressures All tire pressures (including the
spare) should be checked when the
tires are cold. “Cold Tires” means the
vehicle has not been driven for at
least three hours or driven less than
1.6 km (one mile).
Recommended pressures must be
maintained for the best ride, top vehi-
cle handling, and minimum tire wear.
For recommended inflation pressure,
refer to “Tire and wheels” in chapter
8. All specifications (sizes and pres-
sures) can be found on a label
attached to the vehicle.
OIB074055
Tire underinflation
Severe underinflation (70 kPa (10
psi) or more) can lead to severe
heat build-up, ca using blowouts,
tread separation and other tire fail-
ures that can result in the loss of
vehicle contro l leading to severe
injury or death. This risk is much
higher on hot days and when driv-
ing for long pe riods at high
speeds.
WARNING

1.(,204/3424-3
•• Underinflation also results in
excessive wear, poor handling and
reduced fuel economy. Wheel
deformatio n also is possible. Keep
your tire pressures at the proper
levels. If a tire frequently needs
refilling, we recommend that the
system be checked by an author-
ized HYUNDAI dealer.
• Overinflation produces a harsh ride, excessive wear at the center
of the tire tread, and a greater pos-
sibility of damage from roa d haz-
ards. • Warm tires normally exceed rec-
ommended cold tire pressures by
28 to 41 kPa (4 to 6 psi). Do not
release air from warm tires to
adjust the pressure or the tires will
be underinflated.
• Be sure to reinstall the tire inflation
valve caps. Without the valve cap,
dirt or moisture could get into the
val ve core and cause air leakage.
If a valve cap is missing, install a
new one as soon as possible. - Tire
pressure
Always observe the following:
• Check tire pressure when the tires are cold. (After vehicle has been
parked for at least three hours or
hasn't been driven more than 1.6
km (one mile) since startup.)
• C heck the pressure of your spare
tire each time you check the pres-
sure of other tires.
• Never overload your vehicle. Be
careful not to overload a vehicle
luggage rack if your vehicle is
equipped with one.
• Worn, old tires can cause acci-
dents. If your tread is badly worn,
or if your tires have been dam-
aged , replace them.
NOTICE
NOTICE
NOTICE
Tire Inflation
Overinflation or underinflation can
reduce tire life, adversely affect
vehicle handling, and lead to sud-
den tire failure. This could result in
loss of vehicle control and poten-
tial injury.
WARNING

1.(&
,204/3424-3
CChecking tire inflation pressureCheck your tires once a month or
more.
Also, check the tire pressure of the
spare tire.How to checkUse a good quality gage to check tire
pressure. You can not tell if your tires
are properly inflated simply by look-
ing at them. Radial tires may look
properly inflated even when they're
underinflated.
Check the tire's inflation pressure
when the tires are cold. - "Cold"
means your vehicle has been sitting
for at least three hours or driven no
more than 1.6 km (1 mile). Remove the valve cap from the tire
valve stem. Press the tire gage firm-
ly onto the valve to get a pressure
measurement. If the cold tire inflation
pressure matches the recommended
pressure on the tire and loading
information label, no further adjust-
ment is necessary. If the pressure is
low, add air until you reach the rec-
ommended amount.
If you overfill the tire, release air by
pushing on the metal stem in the
center of the tire valve. Recheck the
tire pressure with the tire gage. Be
sure to put the valve caps back on
the valve stems. They help prevent
leaks by keeping out dirt and mois-
ture.
•
Inspect your tires frequently for
proper inflation as well as wear
and damage. Always use a tire
pressur e gauge.
•
Tires with too much or too little
pressure wear unevenly causing
poor handling, loss of vehicle
control, and sudden tire failure
leading to accidents, injuries,
and even death. The recom-
mended cold tire pre ssure for
your vehicle can be found in this
manual and on the tire label
located on the driver's side ce n-
ter pillar.
•
Worn tires can cause accidents.
Replace tires that are worn,
show uneven wear, or are dam-
aged.
•
Remember to check the pres-
sure of your spare tire.
HYUNDAI recommends that you
check the spare every t ime you
check the pressure of the other
tires on your vehicle.
WARNING

1.($
,204/3424-3
33. Checking tire life (TIN : Tire
Identification Number) Any tires that are over 6 years old,
based on the manufacturing date,
(including the spare tire) should be
replaced by new ones. You can find
the manufacturing date on the tire
sidewall (possibly on the inside of the
wheel), displaying the DOT Code.
The DOT Code is a series of num-
bers on a tire consisting of numbers
and English letters. The manufactur-
ing date is designated by the last four
digits (characters) of the DOT code.DOT : XXXX XXXX OOOOThe front part of the DOT means a
plant code number, tire size and
tread pattern and the last four num-
bers indicate week and year manu-
factured.
For example:
DOT XXXX XXXX 1618 represents
that the tire was produced in the 16th
week of 2018.
4. Tire ply composition and materi- alThe number of layers or plies of rub-
ber-coated fabric in the tire. Tire
manufacturers also must indicate the
materials in the tire, which include
steel, nylon, polyester, and others.
The letter "R" means radial ply con-
struction; the letter "D" means diago-
nal or bias ply construction; and the
letter "B" means belted-bias ply con-
struction.5. Maximum permissible inflationpressureThis number is the greatest amount
of air pressure that should be put in
the tire. Do not exceed the maximum
permissible inflation pressure. Refer
to the Tire and Loading Information
label for recommended inflation
pressure.
Tire age
Tires degrade over time, even
when they are not being used.
Regardless of the remaining
tread, it is recommended that tires
generally be replaced after six (6)
years of normal service. Heat
caused by hot climates or frequent
high loading conditions can accel-
erate the aging process. Failure
to follow this warning could cause
sudden tire failure, which could lead to a loss of control and an
accident inv olving serious injury or
death.
WARNING

!

+'-"-'($-),%**),%#+&*-,")&#($-),
$(%)&'!))#
When replacing tires, use the same size originally supplied with the vehicle.
Using tires of a different size can damage the related parts or make it work irregularly.
CAUTION
*\f : Normal load : Up to 2 personsItem
Tire size Wheel size Inflation pressure (psi)
Wheel lug nut
torque
kgf•m (lbf•ft, N•m)
Normal load *
\fMaximum load
Front Rear Front Rear
Full size tire 5 Door
\f85/70R\f4 5.5J x \f4 230 (33) 2\f5(3\f) 230(33) 230(33)
\f\f~\f3
(79~94, \f07~\f27)
\f95/55R\f6 6.0J x \f6 230 (33) 2\f5(3\f) 230(33) 230(33)
Cross \f85/65R\f5 5.5J x \f5 230 (33) 2\f5(3\f) 230(33) 230(33)
\f95/55R\f6 6.0J x \f6 230 (33) 2\f5(3\f) 230(33) 230(33)
• Only steel wheel provided as a spare wheel with all variants of vehicle.
• Spare tire make can be from any tire manuafacturer i.e. Bridgestone/MRF/Apollo.
• It is permissible to add 20 kPa (3 psi) to the standard tire pressure specification if colder temperatures are expect\b
ed soon. Tires typically lose 7 kPa (\f psi) for every 7°C (\f2°F) temperature drop. If extreme temperature variations
are expected, rec
heck your tire pressure as necessary to keep them properly inflated.
• An air pressure generally decreases, as you drive up to a high\baltitude area above sea level. Thus, if you plan to drive a high\baltitude area, check the tire pressures in advance. If necessary, inflate them to a proper level (Air infla\b
tion per altitude: +\f0 kPa/\f km (+2.4 psi/\f mile).
NOTICE