2016 Hyundai Equus engine

7-66
Maintenance
OVI073109N/OVI073107N
Engine compartment main fuse panel Engine compartment sub fuse panel

7-67
Maintenance07
Engine compartment main fuse panel
Fuse Name Fuse ratingCircuit Protected
WIPER (B+) 30A Electronic Control Wiper Module FAM 2 (B+) 40A FAM
FAM 1 (B+) 40A FAM START 30A Start Relay
WASHER 15A Washer Relay
WIPER (IG2) 10A Electronic Control Wiper Module DEICER 15A Deicer Relay
CRUISE (B+) 10A H/Lamp Relay, Smart Cruise Control Module HORN 15A Horn Relay
EPB 2 15A Electric Parking Brake Module
EPB 1 15A Electric Parking Brake Module
A/CON 10A A/C Control Module
BLOWER 40A Blower Relay
PRESAFETY
SEAT BELT LH 40A Driver Pre-Safe Seat Belt
RR HTD 40A RR HTD Relay
PRESAFETY
SEAT BELT RH 40A Passenger Pre-Safe Seat Belt
ECU (IG1) 10A ECM, Alternator ESC 10AESC Module, E/R Fuse &
Relay Box (Multipurpose Check Connector)
EHPS 10A EHPS Module
AFLS 10A Head Lamp LH/RH
TCU 15A TCM, Transmission Range Switch
HTD MIRR 10A Driver/Passenger Power Outside Mirror F/PUMP 20A F/Pump Relay
ROOM LAMP 10A Room Lamp Relay ECU (B+) 15A ECM, TCM
B/UP LAMP 10A Steering Angle Sensor, B/UP LP RLY’S’
CRUISE (IG1) 10A Smart Cruise Control Module
INJECTOR (IG1) 10A Injector Drive Box H/LAMP LH 15A Head Lamp LH
H/LAMP RH 15A Head Lamp RH
3 SENSOR 10A ECM, F/Pump Relay, Camshaft Position Sensor
(BANK1/BANK2) (Intake/Exhaust)
2 SENSOR 10A Canister Close Valve, Oil Control Valve #1 ~ #4, E/R Fuse &
Relay Box (C/Fan Relay), Purge Control Solenoid Valve
1 SENSOR 10A ECM, Oxygen Sensor #1 ~ #4
INJECTOR (B+) 15A Injector Drive Box IGN COIL 20A Condenser #1/#2, Ignition Coil #1 ~ #8ECU 30A ECU Relay

7-68
Maintenance
Engine compartment sub fuse panel
Fuse Name Fuse ratingCircuit Protected
ALT 200AAlternator, E/R Fuse & Relay Box (Fuse - I/P POWER RH,
EHPS, C/FAN, PDM (ACC), ECS, TRUNK, AMP,
POWER OUTLET FRT)
I/P POWER LH 80A Smart Junction Box LH (Fuse - PDM (B+), HAZARD, EPB,
RF RECEIVER, SMART KEY, P/HANDLE, TPMS,
STOP LAMP, SHIFT LEVER (B+), P/SEAT PASS,
RH SAFETY POWER WINDOW, MULTI MEDIA, LH SAFETY
POWER WINDOW, 1 MODULE, F/LID, ECS, O/S HDL DRV,
S/HEATER RR, O/S HDL RR, DR LOCK DRV,
S/HEATER DRV, DR LOCK PASS, P/TRUNK,
Leak Current Autocut Device)
I/P POWER RH 60A I/P Junction Box RH (Fuse - USB CHARGE, P/SEAT RR,
SUNROOF, O/S HDL RR, LEG SUPPORT RR,
S/HEATER PASS, O/S HDL PASS, S/HEATER RR)
C/FAN 70A C/FAN Relay EHPS 80A EHPS Module
ESC 1 40A ESC Module, Multipurpose Check Connector
ESC 2 40A ESC Module, Multipurpose Check Connector
PDM (IG1) 40A PDM (IG1) Relay
PDM (IG2) 30A PDM (IG2) Relay
P/SEAT (DRV) 30A Driver IMS Control Module, Driver Lumbar Support Valve ECS 40A ECS Relay
AMP 30A AMP
PDM (ACC) 30A PDM (ACC) Relay
STOP LAMP 15A Stop Signal Electronic Module B/UP LAMP 10A B/UP LAMP Relay
POWER OUTLET FRT 25A POWER OUTLET FRT Relay
TRUNK 10A TRUNK Relay

7-84
Maintenance
Waxing
A good coat of wax bars contamina-
tion from the vehicle paint. Maintain a
good coat of wax on your vehicle to
protect it.
Wax the vehicle when the wax polish
vanishes.
Always wash and dry the vehicle
before waxing. Use a good quality
liquid or paste wax, and follow the
manufacturer’s instructions. Wax all
metal trim to protect it and to main-
tain its luster.A spot remover, which removes oil,
tar, and other similar materials, peels
off the wax coating from the finish.
Make sure to re-wax these areas,
even when the rest of the vehicle
does not need be waxed.
Finish damage repair
Deep scratches or stone chips on the
paint must be repaired in a prompt
manner. Any exposed metal area
quickly gets rusty, and repairing it
may cost a lot.
Information
When your vehicle requires any metal
repair or replacement after damage,
make sure the body shop applies anti-
corrosion materials to the parts to be
repaired or to be replaced.
i
Washing the engine compart-
ment with the water of high
pressure is not recommend-
ed. It may fail electrical cir-
cuits, engine and any other
related part, located in the
engine compartment.
Never allow water or other liq- uids to contact with electri-
cal/electronic components
and the air duct. These may
damage them.
CAUTION
Wiping dust or dirt off thebody with a dry cloth will
scratch the finish.
Do not use a steel- or wool- abrasive cleaner, or strong
detergents, which is high in
alkaline or caustic agents on
chrome-plated, or which
anodizes aluminum parts.
This may damage the protec-
tive coating and cause discol-
oration or paint deterioration.
CAUTION
OVI075189N

7-89
Maintenance07
The emission control system of your
vehicle is covered by a written limited
warranty. Please refer to the Owner’s
Handbook & Warranty Information
booklet for more warranty information.
Your vehicle is equipped with an
emission control system to meet all
applicable emission regulations.
Below are the three emission control
systems.
(1) Crankcase emission control sys-tem
(2) Evaporative emission control sys- tem
(3) Exhaust emission control system
In order to assure the proper opera-
tion of the emission control systems,
it is recommended that you have
your car inspected and maintained
by an authorized EQUUS dealer in
accordance with the maintenance
schedule in this manual.
Caution for the Inspection and
Maintenance Test (With Electronic
Stability Control (ESC) system)
To prevent a misfiring during a dynamometer test, press the
Electronic Stability Control (ESC)
system OFF.
After a dynamometer test, turn ON the ESC system back.1. Crankcase emission control system
The positive crankcase ventilation
system is to prevent the gas emis-
sion from the crankcase and to
reduce the air pollution. This system
supplies filtered-out, fresh air to the
crankcase through the air intake
hose. Inside the crankcase, the fil-
tered-out air mixes with gases, which
then pass through the PCV valve into
the induction system.
2. Evaporative emission control(including ORVR: Onboard
Refueling Vapor Recovery)
system
The Evaporative Emission Control
System is designed to prevent fuel
vapor emission into the atmosphere.
(The ORVR system is designed to
keep the fuel vapors in a canister
while being refueled at the gas sta-
tion, preventing the fuel vapor emis-
sion into the atmosphere.)
Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the
onboard canister. When the engine is
running, the fuel vapors are
absorbed in the canister, and are
drawn into the engine intake mani-
fold through the purge control sole-
noid valve.
E EM
M I
IS
S S
SI
IO
O N
N
C
C O
O N
NT
TR
R O
O L
L
S
S Y
Y S
ST
T E
EM
M

7-90
Maintenance
Purge Control Solenoid Valve(PCSV)
The purge control solenoid valve is
controlled by the Engine Control
Module (ECM). When the engine
coolant temperature is low during
idling, the PCSV closes to prevent
the evaporated fuel from getting into
the engine. After warming up the
engine in a normal driving condition,
the PCSV opens to introduce evapo-
rated fuel to the engine.
3. Exhaust emission control system
The Exhaust Emission Control
System is highly effective in control-
ling exhaust emissions, while main-
taining good vehicle performance.
Vehicle modifications
This vehicle should not be modi-
fied. Modification of your vehicle
may affect its driving performance,
safety or durability. This even may
violate safety and emissions regu-
lations of the government.
In addition, damage or perform-
ance problems, which is resulted in
due to any modification, may not
be covered by a warranty.
Use of unauthorized electric devices may cause abnormal vehi-
cle operation, wire damage, bat-
tery discharge and a fire.
Be careful not to damage your
vehicle by using an unauthorized
electric device.
Engine exhaust gas precautions (carbon monoxide)
Carbon monoxide is present in
exhaust fumes. Therefore, when
you smell exhaust fumes of any
kinds, inside your vehicle, immedi-
ately have it inspected and
repaired. When you suspect
exhaust fume emission into your
vehicle, drive the vehicle only when
all windows are fully opened.
Immediately have your vehicle
checked and repaired immediately.
- Exhaust
Engine exhaust gases contain
carbon monoxide (CO). Though
colorless and odorless, it is
dangerous and is lethal, if
inhaled. Follow the instructions
on this page to avoid CO poi-
soning.
WARNING
Engine exhaust and a wide vari-
ety of automobile components
and parts, including compo-
nents found in the interior fur-
nishings in a vehicle, contain or
emit chemicals known to the
State of California to cause can-
cer and birth defects and repro-
ductive harm. In addition, cer-
tain fluids contained in vehicles
and certain products of compo-
nent wear contain or emit chem-
icals known to the State of
California to cause cancer and
birth defects or other reproduc-
tive harm.
CALIFORNIA PROPOSI- TION 65 WARNING

7-91
Maintenance07
Do not operate the engine in con-fined or closed areas (such as
garages) any more than what is
necessary to move the vehicle in or
out of the area.
When the vehicle is stopped in an open area, with the engine running,
for more than a short period of time,
adjust the ventilation system (as
needed) to draw the outside air into
the vehicle.
Never sit inside a parked or stopped vehicle for any extended period of
time, while the engine is running.
When the engine stalls or fails to start, excessive attempts to restart
the engine may damage the emis-
sion control system.
Operating precautions for cat-alytic converters (if equipped)
Your vehicle is equipped with a cat-
alytic converter emission control
device.
Therefore, you must observe the fol-
lowing precautions:
Use only the UNLEADED FUEL for
gasoline engines.
Do not drive the vehicle when there are signs of engine malfunction,
such as misfiring or noticeable
under-performing.
Do not misuse or abuse the engine. Examples of the engine
misusage are coasting and
descending on a steep slope with
the ignition in the OFF position.
Do not idle the engine at a high speed for an extended period of
time (5 minutes or more).
Do not modify any part of the engine or the emission control sys-
tem. All inspections and adjust-
ments must be done by an author-
ized EQUUS dealer.
Avoid driving with a low level of fuels. When your vehicle runs out
of gasoline, it may misfire the
engine or result in excessive load-
ing of the catalytic converter.
Failure to observe these precautions
may damage the catalytic converter
as well as your vehicle. Additionally,
such actions may void your war-
ranties.
- Fire
A hot exhaust system can
ignite flammable items under
your vehicle. Do not park, idle,
or drive the vehicle over or
near flammable objects, such
as grass, vegetation, paper,
leaves, etc.
The exhaust system and cat- alytic system are very hot
while the engine is running or
immediately after the engine
is turned off. Keep away from
the exhaust system and cat-
alytic; you may get burned.
Also, do not remove the heat
sink around the exhaust sys-
tem, do not seal the bottom of
the vehicle or do not coat the
vehicle for corrosion control.
It may present a fire risk under
certain conditions.
WARNING

Specifications, Consumerinformation and
Reporting safety defects
Dimensions ..............................................................8-2
Bulb wattage ...........................................................8-2
Tires and wheels ....................................................8-3
Recommended lubricants and capacities ...........8-4
Recommended SAE viscosity number ..........................8-5
Vehicle identification number (VIN) ....................8-6
Vehicle certification label .....................................8-6
Tire specification and pressure label .................8-6
Engine number .......................................................8-7
Refrigerant label ....................................................8-7
Consumer information ...........................................8-8
Reporting safety defects ......................................8-9